- 您现在的位置：买卖IC网 > PDF目录22051 > PCA9685PW/Q900,118 (NXP Semiconductors)IC PWM CTLR LED DVR 28TSSOP PDF资料下载
参数资料
| 型号： | PCA9685PW/Q900,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 15/51页 |
| 文件大小： | 0K |
| 描述： | IC PWM CTLR LED DVR 28TSSOP |
| 产品培训模块： | I²C Bus Fundamentals |
| 标准包装： | 1 |
| 拓扑： | 开路漏极，PWM |
| 输出数： | 16 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光，LED 闪烁器 |
| 类型 - 次要： | RGBA |
| 频率： | 25MHz，50MHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 输出电压： | 5.5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 28-TSSOP |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 其它名称： | 568-5931-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页
NXP Semiconductors
PCA9685
16-channel, 12-bit PWM Fm+ I 2 C-bus LED controller
7.3.2 Mode register 2, MODE2
Table 5. MODE2 - Mode register 2 (address 01h) bit description
Legend: * default value.
Bit
7 to 5
4
Symbol
-
INVRT [1]
Access
read only
R/W
Value
000*
0*
Description
reserved
Output logic state not inverted. Value to use when external driver used.
Applicable when OE = 0.
1
Output logic state inverted. Value to use when no external driver used.
Applicable when OE = 0.
3
OCH
R/W
0*
Outputs change on STOP command [2] .
1
Outputs change on ACK [3] .
2
OUTDRV [1]
R/W
0
The 16 LEDn outputs are configured with an open-drain structure.
1*
The 16 LEDn outputs are configured with a totem pole structure.
1 to 0
OUTNE[1:0] [4]
R/W
00*
When OE = 1 (output drivers not enabled), LEDn = 0.
01
1X
When OE = 1 (output drivers not enabled):
LEDn = 1 when OUTDRV = 1
LEDn = high-impedance when OUTDRV = 0 (same as OUTNE[1:0] = 10)
When OE = 1 (output drivers not enabled), LEDn = high-impedance.
[1]
[2]
[3]
[4]
See Section 7.7 “ Using the PCA9685 with and without external drivers ” for more details. Normal LEDs can be driven directly in either
mode. Some newer LEDs include integrated Zener diodes to limit voltage transients, reduce EMI, protect the LEDs and these must be
driven only in the open-drain mode to prevent overheating the IC.
Change of the outputs at the STOP command allows synchronizing outputs of more than one PCA9685. Applicable to registers from
06h (LED0_ON_L) to 45h (LED15_OFF_H) only. 1 or more registers can be written, in any order, before STOP.
Update on ACK requires all 4 PWM channel registers to be loaded before outputs will change on the last ACK.
See Section 7.4 “ Active LOW output enable input ” for more details.
7.3.3 LED output and PWM control
The turn-on time of each LED driver output and the duty cycle of PWM can be controlled
independently using the LEDn_ON and LEDn_OFF registers.
There will be two 12-bit registers per LED output. These registers will be programmed by
the user. Both registers will hold a value from 0 to 4095. One 12-bit register will hold a
value for the ON time and the other 12-bit register will hold the value for the OFF time. The
ON and OFF times are compared with the value of a 12-bit counter that will be running
continuously from 0000h to 0FFFh (0 to 4095 decimal).
Update on ACK requires all 4 PWM channel registers to be loaded before outputs will
change on the last ACK.
The ON time, which is programmable, will be the time the LED output will be asserted and
the OFF time, which is also programmable, will be the time when the LED output will be
negated. In this way, the phase shift becomes completely programmable. The resolution
for the phase shift is 1 ? 4096 of the target frequency. Table 6 lists these registers.
The following two examples illustrate how to calculate values to be loaded into these
registers.
PCA9685
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 3 — 2 September 2010
? NXP B.V. 2010. All rights reserved.
15 of 51
相关PDF资料 |
PDF描述 |
|---|---|
| 1-747948-5 | CONN D-SUB PLUG 25P 26-30AWG AU |
| ADT6502SRJZP085RL7 | IC TEMP SENSOR MICROPWR SOT23-5 |
| MINT1400A4810L01 | MEDICAL INTERNAL PS 400W 48V |
| R05P212S/X2/P/R8 | CONV DC/DC 2W 05VIN 12VOUT |
| 787169-9 | CONN 100POS .05 AMPLMT RECP RTAG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9691BS/1 | 制造商:NXP Semiconductors 功能描述:IC ADC/DAC 8-BIT I2C 16-HVQFN 制造商:NXP Semiconductors 功能描述:IC, ADC/DAC, 8-BIT, I2C, 16-HVQFN |
| PCA9691BS/1,118 | 功能描述:I2C 接口集成电路 ADC/DAC 16-Pin HVQFN EP RoHS:否 制造商:NXP Semiconductors 电源电压-最大:5.5 V 电源电压-最小:2.3 V 最大工作频率:400 KHz 最大工作温度:+ 85 C 封装 / 箱体:TSSOP-16 |
| PCA9691BS/1118 | 制造商:NXP Semiconductors 功能描述:PCA9691BS/HVQFN16/REEL13//1 |
| PCA9691T/1，112 | 制造商:NXP Semiconductors 功能描述: |
| PCA9691T/1，118 | 制造商:NXP Semiconductors 功能描述: |
发布紧急采购，3分钟左右您将得到回复。