- 您现在的位置：买卖IC网 > PDF目录370013 > PowerNP NPe405H (IBM Microeletronics) 32-Bit Embedded Processor(32位嵌入式处理器) PDF资料下载
参数资料
| 型号： | PowerNP NPe405H |
| 厂商： | IBM Microeletronics |
| 英文描述： | 32-Bit Embedded Processor(32位嵌入式处理器) |
| 中文描述： | 32位嵌入式处理器（32位嵌入式处理器） |
| 文件页数： | 41/64页 |
| 文件大小： | 1050K |
| 代理商： | POWERNP NPE405H |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页当前第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页
Advance Information
PowerNP
TM
NPe405H Embedded Processor Data Sheet
41
BA1:0
Bank Address supporting up to 4 internal banks
O
3.3V LVTTL
RAS
Row Address Strobe.
O
3.3V LVTTL
CAS
Column Address Strobe.
O
3.3V LVTTL
DQM0:3
DQM for byte lanes 0 (MemData0:7),
1 (MemData8:15),
2 (MemData16:23), and
3 (MemData24:31)
O
3.3V LVTTL
DQMCB
DQM for ECC check bits.
O
3.3V LVTTL
ECC0:7
ECC check bits 0:7.
I/O
3.3V LVTTL
4
BankSel0:3
Select up to four external SDRAM banks.
O
3.3V LVTTL
WE
Write Enable.
O
3.3V LVTTL
ClkEn0:1
SDRAM Clock Enable.
O
3.3V LVTTL
MemClkOut0:1
Two copies of an SDRAM clock allows, in some cases,
glueless SDRAM attachment without requiring this signal
to be repowered by a PLL or zero-delay buffer.
O
3.3V LVTTL
External Slave Peripheral Interface
PerData0:31
Peripheral data bus used by NPe405H when not in
external master mode, otherwise used by external master.
Note:
PerData00 is the most significant bit (msb) on this
bus.
I/O
5V tolerant
3.3V LVTTL
1
PerAddr4:31
Peripheral Address bus used by NPe405H when not in
external master mode, otherwise used by external master.
I/O
5V tolerant
3.3V LVTTL
1
PerPar0:3
Peripheral byte parity signals.
I/O
5V tolerant
3.3V LVTTL
1
PerWBE0:3
As outputs, these pins can act as byte-enables which are
valid for an entire cycle or as write-byte-enables which are
valid for each byte on each data transfer, allowing partial
word transactions. As outputs, pins are used by either
peripheral controller or DMA controller depending upon the
type of transfer involved. Used as inputs when external bus
master owns the external interface.
I/O
5V tolerant
3.3V LVTTL
1, 2
PerWE
Peripheral Write Enable. Low when any of the four
PerWBE signals are low.
I/O
5V tolerant
3.3V LVTTL
[PerCS0:7]
Peripheral Chip Selects
O
5V tolerant
3.3V LVTTL
2
PerOE
Used by either peripheral controller or DMA controller
depending upon the type of transfer involved. When the
NPe405H is the bus master, it enables the selected
SDRAMs to drive the bus.
O
5V tolerant
3.3V LVTTL
2
Signal Functional Description
(Part 5 of 9)
Notes:
1. Receiver input has hysteresis
2. Must pull up (recommended value is 3k
to 3.3V, 10k
to 5V
)
3. Must pull down (recommended value is 1k
)
4. If not used, must pull up (recommended value is 3k
to 3.3V)
5. If not used, must pull down (recommended value is 1k
)
Signal Name
Description
I/O
Type
Notes
相关PDF资料 |
PDF描述 |
|---|---|
| PowerNP NPe405L | 32-Bit Embedded Processor(32位嵌入式处理器) |
| PowerNP NPe405 | 32-Bit Embedded Processor(32位嵌入式处理器（应用于网络方面，提供高性价比）) |
| PowerPC 401GF | 32-bit RISC Embedded Controllers(32位RISC结构嵌入式控制器) |
| PowerPC 403GA | 32-bit RISC Embedded Controllers(32位RISC结构嵌入式控制器) |
| PowerPC 403GB | 32-bit RISC Embedded Controllers(32位RISC结构嵌入式控制器) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| POWERPAC-B | 制造商:IAR Systems 功能描述:PowerPac |
| POWERPAC-S | 制造商:IAR Systems 功能描述:PowerPac |
| POWERPAT PLUS | 制造商:Fluke Electronics 功能描述:SOFTWARE PAT |
| POWERPATPLUS | 制造商:Fluke Electronics 功能描述:Fluke Powerpat Plus |
| POWERPLUG15W | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:AC/DC POWER SUPPLY |
发布紧急采购，3分钟左右您将得到回复。