参数资料
型号: SAB-C515-LM
厂商: INFINEON TECHNOLOGIES AG
元件分类: 微控制器/微处理器
英文描述: 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80
封装: PLASTIC, MQFP-80
文件页数: 102/162页
文件大小: 771K
代理商: SAB-C515-LM
Semiconductor Group
6-1
On-Chip Peripheral Components
C515
6
On-Chip Peripheral Components
This chapter gives detailed information about all on-chip peripherals of the C515 except for the
integrated interrupt controller, which is described separately in chapter 7.
6.1
Parallel I/O
The C515 has six 8-bit I/O ports and one 8-bit input port for analog/digital input. Port 0 is an open-
drain bidirectional I/O port, while ports 1 to 5 are quasi-bidirectional I/O ports with internal pullup
resistors. That means, when configured as inputs, ports 1 to 5 will be pulled high and will source
current when externally pulled low. Port 0 will float when configured as input.
The output drivers of port 0 and 2 and the input buffers of port 0 are also used for accessing external
memory. In this application, port 0 outputs the low byte of the external memory address, time
multiplexed with the byte being written or read. Port 2 outputs the high byte of the external memory
address when the address is 16 bits wide. Otherwise, the port 2 pins continue emitting the P2 SFR
contents. In this function, port 0 is not an open-drain port, but uses a strong internal pullup FET .
6.1.1
Port Structures
The C515 generally allows digital I/O on 48 lines grouped into 6 bidirectional C501 compatible 8-bit
ports and one 8-bit analog/digital input port. Each port bit (except port 6) consists of a latch, an
output driver and an input buffer. Read and write accesses to the I/O ports P0 to P5 are performed
via their corresponding special function registers. Depending on the specific ports, multiple
functions are assigned to the port pins. These alternate functions of the port pins are listed in
table 6-1.
When port 6 is used as analog input, an analog channel is switched to the A/D converter through a
3-bit multiplexer, which is controlled by three bits in SFR ADCON (see chapter 6.4). Port 6 lines
may also be used as digital inputs. In this case they are addressed as an input port via SFR P6.
Since port 6 has no internal latch, the contents of SFR P6 only depends on the levels applied to the
input lines. It makes no sense to output a value to these input-only port by writing to the SFR P6.
This will have no effect.
相关PDF资料
PDF描述
SAB-C515C-LM 8-BIT, 10 MHz, MICROCONTROLLER, PQFP80
SAB-XC164CM-8F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
SAB-XC164CM-4F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
SAB-XC164CM-8F20F 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP64
SAB-XC164KM-4F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
SAB-C517A 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-bit CMOS MICROCONTROLLER
SAB-C517A-4R24M 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-4RM 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-L24M 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-LM 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller