参数资料
型号: SAB-C515-LM
厂商: INFINEON TECHNOLOGIES AG
元件分类: 微控制器/微处理器
英文描述: 8-BIT, 16 MHz, MICROCONTROLLER, PQFP80
封装: PLASTIC, MQFP-80
文件页数: 116/162页
文件大小: 771K
代理商: SAB-C515-LM
Semiconductor Group
6-14
On-Chip Peripheral Components
C515
6.2
Timers/Counters
The C515 contains three general purpose 16-bit timers/counters, timer 0, 1, and 2, which are useful
in many applications for timing and counting.
In "timer" function, the timer register is incremented every machine cycle. Thus one can think of it
as counting machine cycles. Since a machine cycle consists of 12 oscillator periods, the counter
rate is 1/12 of the oscillator frequency.
In "counter" function, the register is incremented in response to a 1-to-0 transition (falling edge) at
its corresponding external input pin, T0 or T1 (alternate functions of P3.4 and P3.5, resp.). In this
function the external input is sampled during S5P2 of every machine cycle. When the samples show
a high in one cycle and a low in the next cycle, the count is incremented. The new count value
appears in the register during S3P1 of the cycle following the one in which the transition was
detected. Since it takes two machine cycles (24 oscillator periods) to recognize a 1-to-0 transition,
the maximum count rate is 1/24 of the oscillator frequency. There are no restrictions on the duty
cycle of the external input signal, but to ensure that a given level is sampled at least once before it
changes, it must be held for at least one full machine cycle.
6.2.1
Timer/Counter 0 and 1
Timer / counter 0 and 1 of the C515 are fully compatible with timer / counter 0 and 1 of the C501
and can be used in the same four operating modes:
Mode 0: 8-bit timer/counter with a divide-by-32 prescaler
Mode 1: 16-bit timer/counter
Mode 2: 8-bit timer/counter with 8-bit auto-reload
Mode 3: Timer/counter 0 is configured as one 8-bit timer/counter and one 8-bit timer; Timer/
counter 1 in this mode holds its count. The effect is the same as setting TR1 = 0.
External inputs INT0 and INT1 can be programmed to function as a gate for timer/counters 0 and 1
to facilitate pulse width measurements.
Each timer consists of two 8-bit registers (TH0 and TL0 for timer/counter 0, TH1 and TL1 for timer/
counter 1) which may be combined to one timer configuration depending on the mode that is
established. The functions of the timers are controlled by two special function registers TCON and
TMOD.
In the following descriptions the symbols TH0 and TL0 are used to specify the high-byte and the
low-byte of timer 0 (TH1 and TL1 for timer 1, respectively). The operating modes are described and
shown for timer 0. If not explicity noted, this applies also to timer 1.
相关PDF资料
PDF描述
SAB-C515C-LM 8-BIT, 10 MHz, MICROCONTROLLER, PQFP80
SAB-XC164CM-8F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
SAB-XC164CM-4F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
SAB-XC164CM-8F20F 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP64
SAB-XC164KM-4F40F 16-BIT, FLASH, 40 MHz, MICROCONTROLLER, PQFP64
相关代理商/技术参数
参数描述
SAB-C517A 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-bit CMOS MICROCONTROLLER
SAB-C517A-4R24M 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-4RM 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-L24M 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller
SAB-C517A-LM 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller