参数资料
型号: SFCF2048H2BU2TO-I-MS-517-STD
厂商: Swissbit NA Inc
文件页数: 36/102页
文件大小: 0K
描述: FLASH SLC UDMA/MDMA/PIO 2GB
标准包装: 1
系列: C-440
存储容量: 2GB
存储器类型: CompactFlash?
其它名称: 1052-1094
e) The host shall negate – CS0, -CS1, A2, A1, and A0. The host shall keep – CS0, -CS1, A2, A1, and A0 negated
until after negating – DMACK at the end of the burst.
f)
Steps I, (d), and (e) shall have occurred at least t ACK before the host asserts – DMACK. The host shall keep –
DMACK asserted until the end of an Ultra DMA burst.
g) The device may negate – DDMARDY t ZIORDY after the host has asserted – DMACK. Once the device has negated
– DDMARDY, the device shall not release – DDMARDY until after the host has negated DMACK at the end of
an Ultra DMA burst.
h) The host shall negate STOP within t ENV after asserting – DMACK. The host shall not assert STOP until after the
first negation of HSTROBE.
i)
j)
The device shall assert – DDMARDY within t LI after the host has negated STOP. After asserting DMARQ and –
DDMARDY the device shall not negate either signal until after the first negation of HSTROBE by the host.
The host shall drive the first word of the data transfer onto D[15:0]. This step may occur any time during
Ultra DMA burst initiation.
k) To transfer the first word of data: the host shall negate HSTROBE no sooner than t UI after the device has
asserted – DDMARDY. The host shall negate HSTROBE no sooner than t DVS after the driving the first word of
data onto D[15:0].
Figure 15: Ultra DMA Data-Out Burst Initiation Timing
Note: The definitions for the STOP, DDMARDY, and HSTROBE signal lines are not in effect until DMARQ and DMACK
are asserted.
6.5.4.4.7 Sustaining an Ultra DMA Data-Out Burst
An Ultra DMA Data-Out burst is sustained by following the steps lettered below. The timing diagram is shown in
Figure 16: Sustained Ultra DMA Data-Out Burst Timing. The associated timing parameters are specified in Table 26:
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
a) The host shall drive a data word onto D[15:0].
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.00
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
C-440_data_sheet_CF-HxBU_Rev100.doc
Page 36 of 102
相关PDF资料
PDF描述
MLEAWT-A1-0000-0004E5 LED XLAMP NEUTRAL WHIT 4000K SMD
TSL13T IC SENSOR LIGHT-VOLT 4-SMD
TSL12S-LF IC SENSOR LIGHT-VOLT SIDELOOKER
TSL14S-LF IC SENSOR LIGHT-VOLT SIDELOOKER
MLEAWT-A1-0000-0004A2 LED XLAMP ML-E WHITE SMD
相关代理商/技术参数
参数描述
SFCF2048H2BU2TO-I-MS-527-STD 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H4BK1SA-C-QT-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH
SFCF2048H4BK1SA-I-QT-553-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?
SFCF2048H4BK2SA-C-DS-553-SMA 制造商:SWISSBIT NA INC 功能描述:FLASH SLC UDMA/MDMA/PIO 2G
SFCF2048H4BK2SA-I-DS-553-SMA 功能描述:FLASH SLC UDMA/MDMA/PIO 2G RoHS:是 类别:存储卡,模块 >> 存储器,PC 卡 系列:C-300 标准包装:30 系列:- 存储容量:8GB 存储器类型:存储卡 - Extreme III SD?