- 您现在的位置：买卖IC网 > PDF目录18758 > SI4421-A0-FT (Silicon Laboratories Inc)IC TXRX FSK 915MHZ 3.8V 16-TSSOP PDF资料下载
参数资料
| 型号： | SI4421-A0-FT |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 30/45页 |
| 文件大小： | 0K |
| 描述： | IC TXRX FSK 915MHZ 3.8V 16-TSSOP |
| 标准包装： | 96 |
| 频率： | 433MHz，868MHz，915MHz |
| 数据传输率 - 最大： | 256kbps |
| 调制或协议： | FSK |
| 应用： | ISM |
| 功率 - 输出： | 7dbm |
| 灵敏度： | -110dBm |
| 电源电压： | 2.2 V ~ 3.8 V |
| 电流 - 接收： | 15mA |
| 电流 - 传输： | 28mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 585 (CN2011-ZH PDF) |
| 其它名称： | 336-1737-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页当前第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页
Si4421
Typical TX register usage
Enabling the Transmitter preloads the TX
latch with 0xAAAA
Do not switch the et off here, because the
TX byte1 is not transmitted out
only stored into the internal register!
SPI commands
(nSEL, SCK, SDI)
Conf. Set.
el = 1
Power Man
et = 1
TX latch wr
TX byte1
TX latch wr
Dummy
TX byte
Power Man
et = 0
Conf. Set.
el = 0
et bit
(enable transmitter)
enable
Synthesizer / PA
Synt.
T tx_XTAL_ON *
PA
TX data
0xAA
0xAA
TX byte1
Fraction of the
Dummy byte
nIRQ
SDO**
Notes:
*T tx_XTAL_ON is the start-up time of the PLL + PA with running crystal oscillator
** SDO is tri-state if nSEL is logic high.
Note: The content of the data registers are initialized by clearing bit et .
A complete transmit sequence should be performed as follows:
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
Enable the TX register by setting the el bit to 1 ( Configuration Setting Command , page 15)
The TX register automatically filled out with 0xAAAA, which can be used to generate preamble.
Enable the transmitter by setting the et bit ( Power Management Command , page 15)
The synthesizer and the PLL turns on, calibrates itself then the power amplifier automatically enabled
The TX data transmission starts
When the transmission of the byte completed, the nIRQ pin goes high, the SDO pin goes low at the same time. The nIRQ
pulse shows that the first 8 bits (the first byte, by default 0xAA) has transmitted. There are still 8 bits in the transmit
register.
The microcontroller recognizes the interrupt and writes a data byte to the TX register
Repeat f. - g. until the last data byte reached
Using the same method, transmit a dummy byte. The value of this dummy byte can be anything.
The next high to low transition on the nIRQ line (or low to high on the SDO pin) shows that the transmission of the data
bytes ended. The dummy byte is still in the TX latch.
Turn off the transmitter by setting the et bit to 0. This event will probably happen while the dummy byte is being
transmitted. Since the dummy byte contains no useful information, this corruption will cause no problems.
Clearing the el bit clears the Register Underrun interrupt; the nIRQ pin goes high, the SDO low.
It is possible to perform this sequence without sending a dummy byte (step i.) but after loading the last data byte to the transmit
register the PA turn off should be delayed for at least 16 bits time. The clock source of the microcontroller (if the clock is not supplied
by the Si4421) should be stable enough over temperature and voltage to ensure this minimum delay under all operating
circumstances.
When the dummy byte is used, the whole process is driven by interrupts. Changing the TX data rate has no effect on the algorithm
and no accurate delay measurement is needed.
30
相关PDF资料 |
PDF描述 |
|---|---|
| 230-50-LPI | XFRMR 115/230V 50MA 12VA PCB |
| SI4421-A1-FT | IC TXRX FSK 915MHZ 3.8V 16-TSSOP |
| 30-400-LPI | XFRMR PWR 115/230V 30VCT 400MA |
| 56-200-LPI | XFRMR PWR 115/230V 56VCT 200MA |
| ASFL1-33.333MHZ-EC-T | OSCILLATOR 33.3330 MHZ 3.3V SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| Si4421-A0-FTR | 功能描述:射频收发器 Transceiver-EZRadio RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| Si4421-A1-FT | 功能描述:射频收发器 TRANSCEIVR EZRadio UNIVRSL ISM BAND FSK RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| SI4421-A1-FTR | 功能描述:射频收发器 Transceiver EZRadio RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray |
| SI4421DY | 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:P-Channel 20-V (D-S) MOSFET |
| SI4421DY-T1 | 功能描述:MOSFET 20V 14A 1.5W RoHS:否 制造商:STMicroelectronics 晶体管极性:N-Channel 汲极/源极击穿电压:650 V 闸/源击穿电压:25 V 漏极连续电流:130 A 电阻汲极/源极 RDS（导通）:0.014 Ohms 配置:Single 最大工作温度: 安装风格:Through Hole 封装 / 箱体:Max247 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。