- 您现在的位置：买卖IC网 > Datasheet目录517 > SM1212E433 (Semtech)RF EVAL FOR SX1212 433MHZ ISM Datasheet资料下载
参数资料
| 型号： | SM1212E433 |
| 厂商： | Semtech |
| 文件页数： | 16/77页 |
| 文件大小： | 0K |
| 描述： | RF EVAL FOR SX1212 433MHZ ISM |
| 标准包装： | 1 |
| 类型： | 收发器，ISM |
| 频率： | 433MHz |
| 适用于相关产品： | SX1212E |
| 已供物品： | 模块，天线，电源，软件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
SX1212
ADVANCED COMMUNICATIONS & SENSING
Note for mass production: The VCO capacitance is piece to piece dependant. As such, the optimization proposed
above should be verified on several prototypes, to ensure that the population is centered on 150 mV.
3.2.6. PLL Loop Filter
To adequately reject spurious components arising from the comparison frequency Fcomp, an external 2 nd order
loop filter is employed.
RL1
LF_M
CL2
CL1
LF_P
Figure 7: Loop Filter
Following the recommendations made in section 3.2.4, the loop filter proposed in the reference design’s bill of
material on section 7.5.3 should be used. The loop filter settings are frequency band independent and are hence
relevant to all implementations of the SX1212.
3.2.7. PLL Lock Detection Indicator
The SX1212 also features a PLL lock detect indicator. This is useful for optimizing power consumption, by adjusting
the synthesizer wake up time (TS_FS), since the PLL startup time is lower than specified under nominal conditions.
The lock status can be read on bit IRQParam_PLL_lock, and must be cleared by writing a “1” to this same register.
In addition, the lock status can be reflected in pin 23 PLL_LOCK, by setting the bit IRQParam_Enable_lock_detect.
3.2.8. Frequency Calculation
As shown in Figure 5 the PLL structure comprises three different dividers, R, P and S, which set the output
frequency through the LO. A second set of dividers is also available to allow rapid switching between a pair of
frequencies: R1/P1/S1 and R2/P2/S2. These six dividers are programmed by six bytes of the register MCParam
from addresses 6 to 11.
3.2.8.1. FSK Mode
The following formula gives the relationship between the local oscillator, and R, P and S values, when using FSK
modulation.
Frf , fsk =
9
8
Flo
Frf , fsk =
9 Fxtal
8 R + 1
[ 75 ( P + 1 ) + S ) ]
3.2.8.2. OOK Mode
Due to the manner in which the baseband OOK symbols are generated, the signal is always offset by the FSK
frequency deviation (Fdev - as programmed in MCParam_Freq_dev). Hence, the center of the transmitted OOK
signal is:
Rev 2 – June 18th, 2009
Page 16 of 77
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SM1230E868 | BOARD EVAL XMITTER FOR SX1230 |
| SM16S-CM012-012 | SYNJET ZFLOW 50 PWM 12V |
| SM200P81 | RF MODULE 250/500MBPS 2.4GHZ SMA |
| SM2440G | LAMP T2 TELEPHONE SLIDE 24V .04A |
| SM3020G | LAMP T2 TELEPHONE SLIDE 30V .02A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SM-1220M | 制造商: 功能描述: 制造商:undefined 功能描述: |
| SM12-3/16-BLK-200FT | 制造商:SUMITOMO 功能描述:177-10101 SM12 3/16 BLK SPL |
| SM12-3/4-WHT-200FT | 制造商:SUMITOMO 功能描述:SM12-3/4-WHT-200FT 制造商:SUMITOMO 功能描述:177-10189 SM12 3/4 WHT SPL |
| SM12-3/8-BLK-200FT | 制造商:Sumitomo Wiring Systems LTD 功能描述:177-10107 SM12 3/8 BLK SPL |
| SM1230E868 | 功能描述:BOARD EVAL XMITTER FOR SX1230 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
发布紧急采购，3分钟左右您将得到回复。