- 您现在的位置：买卖IC网 > Datasheet目录517 > SM1212E433 (Semtech)RF EVAL FOR SX1212 433MHZ ISM Datasheet资料下载
参数资料
| 型号： | SM1212E433 |
| 厂商： | Semtech |
| 文件页数： | 43/77页 |
| 文件大小： | 0K |
| 描述： | RF EVAL FOR SX1212 433MHZ ISM |
| 标准包装： | 1 |
| 类型： | 收发器，ISM |
| 频率： | 433MHz |
| 适用于相关产品： | SX1212E |
| 已供物品： | 模块，天线，电源，软件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页当前第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
SX1212
ADVANCED COMMUNICATIONS & SENSING
5.3.5. uC Connections
SX1212
DATA
IRQ_0
IRQ_1 (DCLK)
NSS_CONFIG
uC
SCK
MOSI
MISO
Figure 37: uC Connections in Continuous Mode
Note that some connections may not be needed depending on the application:
IRQ_0: if Sync and RSSI interrupts are not used. In this case, leave floating.
IRQ_1: if the chip is never used in Tx FSK mode (DCLK connection is not compulsory in Rx and Tx OOK
modes). In this case, leave floating.
MISO: if no read register access is needed. In this case, pull-up to VDD through a 100 k ? resistor.
In addition, NSS_DATA pin (unused in continuous mode) should be pulled-up to VDD through a 100 k ? resistor.
Please refer to Table 13 for SX1212’s pins configuration
5.3.6. Continuous Mode Example
Configure all data processing related registers listed below appropriately. In this example we assume that both
Bit synchronizer and Sync word recognition are on.
Table 19: Relevant Configuration Registers in Continuous Mode (data processing related only)
Tx
Rx
Description
MCParam
Data_mode_x
X
X
Defines data operation mode (
Continuous)
IRQParam
RXParam
SYNCParam
Rx_stby_irq_0
Sync_on
Sync_size
Sync_tol
Sync_value
X
X
X
X
X
Defines IRQ_0 source in Rx mode
Enables Sync word recognition
Defines Sync word size
Defines the error tolerance on Sync word recognition
Defines Sync word value
Tx Mode:
Go to Tx mode (and wait for Tx to be ready, see Figure 50)
Send all packet’s bits on DATA pin synchronously with DCLK signal provided on IRQ_1
Go to Sleep mode
Rx Mode:
Program Rx interrupts: IRQ_0 mapped to Sync (Rx_stby_irq_0=”00”) and IRQ_1 mapped to DCLK (Bit
synchronizer enabled)
Go to Rx mode (note that Rx is not ready immediately, see Figure 49)
Wait for Sync interrupt
Get all packet bits on DATA pin synchronously with DCLK signal provided on IRQ_1
Go to Sleep mode
Rev 2 – June 18th, 2009
Page 43 of 77
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SM1230E868 | BOARD EVAL XMITTER FOR SX1230 |
| SM16S-CM012-012 | SYNJET ZFLOW 50 PWM 12V |
| SM200P81 | RF MODULE 250/500MBPS 2.4GHZ SMA |
| SM2440G | LAMP T2 TELEPHONE SLIDE 24V .04A |
| SM3020G | LAMP T2 TELEPHONE SLIDE 30V .02A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SM-1220M | 制造商: 功能描述: 制造商:undefined 功能描述: |
| SM12-3/16-BLK-200FT | 制造商:SUMITOMO 功能描述:177-10101 SM12 3/16 BLK SPL |
| SM12-3/4-WHT-200FT | 制造商:SUMITOMO 功能描述:SM12-3/4-WHT-200FT 制造商:SUMITOMO 功能描述:177-10189 SM12 3/4 WHT SPL |
| SM12-3/8-BLK-200FT | 制造商:Sumitomo Wiring Systems LTD 功能描述:177-10107 SM12 3/8 BLK SPL |
| SM1230E868 | 功能描述:BOARD EVAL XMITTER FOR SX1230 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
发布紧急采购，3分钟左右您将得到回复。