- 您现在的位置：买卖IC网 > Datasheet目录517 > SM1212E433 (Semtech)RF EVAL FOR SX1212 433MHZ ISM Datasheet资料下载
参数资料
| 型号： | SM1212E433 |
| 厂商： | Semtech |
| 文件页数： | 45/77页 |
| 文件大小： | 0K |
| 描述： | RF EVAL FOR SX1212 433MHZ ISM |
| 标准包装： | 1 |
| 类型： | 收发器，ISM |
| 频率： | 433MHz |
| 适用于相关产品： | SX1212E |
| 已供物品： | 模块，天线，电源，软件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页当前第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
SX1212
ADVANCED COMMUNICATIONS & SENSING
If the transmitter is switched off (for example due to entering another chip mode) during transmission it will stop
immediately, even if there is still unsent data.
Figure 39 illustrates Tx processing with a 16 byte FIFO depth and Tx_start_irq_0=0. Please note that in this
example the packet length is equal to FIFO size, but this does not need to be the case, the uC can use the FIFO
interrupts anytime during Tx to manage FIFO contents and write additional bytes.
Start condition
(Cf. Tx_start_irq_0)
Fifofull
/Fifoempty
Tx_done
from
SPI Data
15
FIFO
0
b15
b14
b13
b12
b11
b10
b9
b8
b7
b6
b5
b4
b3
b2
b1
b0
Data Tx
(from SR)
XXX
b0
b1
b2
b3
b4
b5
b6
b7
b8
b9
b10
b11 b12 b13 b14 b15
XXX
Figure 39: Tx processing in Buffered Mode (FIFO size = 16, Tx_start_irq_0=0)
5.4.3. Rx Processing
After entering Rx in Buffered mode, the chip requires the uC to retrieve the received data from the FIFO. The FIFO
will actually start being filled with received bytes either; when a Sync word has been detected (in this case only the
bytes following the Sync word are filled into the FIFO) or when the Fifo_fill bit is asserted by the user - depending
on the state of bit, IRQParam_Fifo_fill_method.
In Buffered mode, the packet length is not limited i.e. as long as Fifo_fill is set, the received bytes are shifted into
the FIFO.
The uC software must therefore manage the transfer of the FIFO contents by interrupt and ensure reception of the
correct number of bytes. (In this mode, even if the remote transmitter has stopped, the demodulator will output
random bits from noise)
When the FIFO is full, Fifofull IRQ source is asserted to alert the uC, that at that time, the FIFO can still be unfilled
without data loss. If the FIFO is not unfilled, once the SR is also full (i.e. 8 bits periods later) Fifo_overrun_clr is
asserted and SR’s content is lost.
Figure 40 illustrates an Rx processing with a 16 bytes FIFO size and Fifo_fill_method=0. Please note that in the
illustrative example of section 5.4.6, the uC does not retrieve any byte from the FIFO through SPI Data, causing
overrun.
Rev 2 – June 18th, 2009
Page 45 of 77
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SM1230E868 | BOARD EVAL XMITTER FOR SX1230 |
| SM16S-CM012-012 | SYNJET ZFLOW 50 PWM 12V |
| SM200P81 | RF MODULE 250/500MBPS 2.4GHZ SMA |
| SM2440G | LAMP T2 TELEPHONE SLIDE 24V .04A |
| SM3020G | LAMP T2 TELEPHONE SLIDE 30V .02A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SM-1220M | 制造商: 功能描述: 制造商:undefined 功能描述: |
| SM12-3/16-BLK-200FT | 制造商:SUMITOMO 功能描述:177-10101 SM12 3/16 BLK SPL |
| SM12-3/4-WHT-200FT | 制造商:SUMITOMO 功能描述:SM12-3/4-WHT-200FT 制造商:SUMITOMO 功能描述:177-10189 SM12 3/4 WHT SPL |
| SM12-3/8-BLK-200FT | 制造商:Sumitomo Wiring Systems LTD 功能描述:177-10107 SM12 3/8 BLK SPL |
| SM1230E868 | 功能描述:BOARD EVAL XMITTER FOR SX1230 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
发布紧急采购，3分钟左右您将得到回复。