- 您现在的位置：买卖IC网 > Datasheet目录517 > SM1212E433 (Semtech)RF EVAL FOR SX1212 433MHZ ISM Datasheet资料下载
参数资料
| 型号： | SM1212E433 |
| 厂商： | Semtech |
| 文件页数： | 56/77页 |
| 文件大小： | 0K |
| 描述： | RF EVAL FOR SX1212 433MHZ ISM |
| 标准包装： | 1 |
| 类型： | 收发器，ISM |
| 频率： | 433MHz |
| 适用于相关产品： | SX1212E |
| 已供物品： | 模块，天线，电源，软件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页当前第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页
SX1212
ADVANCED COMMUNICATIONS & SENSING
5.5.9. Packet Mode Example
Configure all data processing related registers listed below appropriately. In this example we assume CRC is
enabled with autoclear on.
Table 25: Relevant Configuration Registers in Packet Mode (data processing related only)
Tx
Rx
Description
Data_mode_x
X
X
Defines data operation mode ( Packet)
MCParam
IRQParam
RXParam
SYNCParam
PKTParam
Fifo_size
Fifo_thresh
Rx_stby_irq_0
Rx_stby_irq_1
Tx_irq_1
Tx_start_irq_0
Sync_size
Sync_tol
Sync_value
Manchester_on
Payload_length
Node_adrs
Pkt_format
Preamble_size
Whitening_on
CRC_on
Adrs_filt
CRC_autoclr
Fifo_stby_access
X
X
X
X
X
X
X
X (1)
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Defines FIFO size
Defines FIFO threshold
Defines IRQ_0 source in Rx & Stby modes
Defines IRQ_1 source in Rx & Stby modes
Defines IRQ_1 source in Tx mode
Defines Tx start condition and IRQ_0 source
Defines Sync word size
Defines the error tolerance on Sync word detection
Defines Sync word value
Enables Manchester encoding/decoding
Length in fixed format, max Rx length in variable format
Defines node address for Rx address filtering
Defines packet format (fixed or variable length)
Defines the size of preamble to be transmitted
Enables whitening/de-whitening process
Enables CRC calculation/check
Enables and defines address filtering
Enables FIFO autoclear if CRC failed
Defines FIFO access in Stby mode
fixed format only
(1)
Tx Mode :
Program Tx start condition and IRQs: Start Tx when FIFO not empty (Tx_start_irq_0=1) and IRQ_1 mapped to
Tx_done (Tx_irq_1=1)
Go to Stby mode
Write all payload bytes into FIFO (Fifo_stby_access=0, Stby interrupts can be used if needed)
Go to Tx mode. When Tx is ready (automatically handled) Tx starts (Tx_start_irq_0=1).
Wait for Tx_done interrupt (+1 bit period)
Go to Sleep mode
Rx Mode :
Program Rx/Stby interrupts: IRQ_0 mapped to /Fifoempty (Rx_stby_irq_0=10) and IRQ_1 mapped to CRC_OK
(Rx_stby_irq_1=00)
Go to Rx (note that Rx is not ready immediately, see section 7.3.1
Wait for CRC_OK interrupt
Go to Stby
Read payload bytes from FIFO until /Fifoempty goes low. (Fifo_stby_access =1)
Go to Sleep mode
5.5.10. Additional Information
If the number of bytes filled for transmission is greater than the actual length of the packet to be transmitted and
Tx_start_irq_0 = 1, then the FIFO is cleared after the packet has been transmitted. Thus the extra bytes in the
Rev 2 – June 18th, 2009
Page 56 of 77
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SM1230E868 | BOARD EVAL XMITTER FOR SX1230 |
| SM16S-CM012-012 | SYNJET ZFLOW 50 PWM 12V |
| SM200P81 | RF MODULE 250/500MBPS 2.4GHZ SMA |
| SM2440G | LAMP T2 TELEPHONE SLIDE 24V .04A |
| SM3020G | LAMP T2 TELEPHONE SLIDE 30V .02A |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SM-1220M | 制造商: 功能描述: 制造商:undefined 功能描述: |
| SM12-3/16-BLK-200FT | 制造商:SUMITOMO 功能描述:177-10101 SM12 3/16 BLK SPL |
| SM12-3/4-WHT-200FT | 制造商:SUMITOMO 功能描述:SM12-3/4-WHT-200FT 制造商:SUMITOMO 功能描述:177-10189 SM12 3/4 WHT SPL |
| SM12-3/8-BLK-200FT | 制造商:Sumitomo Wiring Systems LTD 功能描述:177-10107 SM12 3/8 BLK SPL |
| SM1230E868 | 功能描述:BOARD EVAL XMITTER FOR SX1230 RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
发布紧急采购，3分钟左右您将得到回复。