参数资料
型号: SM320VC33HFGM150
厂商: TEXAS INSTRUMENTS INC
元件分类: 数字信号处理
英文描述: 32-BIT, 75 MHz, OTHER DSP, CQFP164
封装: NCTB, CERAMIC, MO-113AA, QFP-164
文件页数: 6/56页
文件大小: 669K
代理商: SM320VC33HFGM150
SM320VC33, SMJ320VC33
DIGITAL SIGNAL PROCESSOR
SGUS034E - FEBRUARY 2001 - REVISED OCTOBER 2002
14
POST OFFICE BOX 1443
HOUSTON, TEXAS 77251-1443
PLL isolation
The internal PLL supplies can be directly connected to CVDD and VSS (0 case) or fully isolated as shown in
Figure 6. The RC network prevents the PLL supplies from turning high frequency noise in the CVDD and VSS
supplies into jitter.
CVDD
0 -100
0.1
F
0.01
F
0 -100
VSS
PLLVDD
PLLVSS
Figure 6. PLL Isolation Circuit Diagram
clock and PLL considerations on initialization
On power up, the CPU clock divide mode can be in MAXSPEED, LOPOWER or IDLE2, or the PLL could be
in an undefined mode. RESET falling in the presence of a valid CPU clock is used to clear this state, after which
the device will synchronously terminate any external activity.
The 5x Fclkin PLL of the 320VC33 contains an 8-bit PLL-LOCK counter that will cause the PLL to output a
frequency of Fclkin/2 during the initial ramp. This counter, however, does not increment while RESET is low or
in the absence of an input clock. A minimum of 256 input clocks are required before the first falling edge of reset
for the PLL to output to clear this counter. The setup and behavior that is seen is as follows.
Power is applied to the DSP with RESET low and the input clock high or low. A clock is applied (RESET is still
low) and the PLL appears to lock on to the input clock, producing the expected x5 output frequency. RESET
is driven high and the PLL output immediately drops to Fclkin/2 for up to 256 input cycles or 128 of the Fclkin/2
output cycles. The PLL/CPU clock then switches to x5 mode.
The switch over is synchronous and does not create a clock glitch, so the only effect is that the CPU will run
slow for up to the first 128 cycles after reset goes high. Once the PLL has stabilized, the counter will remain
cleared and subsequent resets will not exhibit this condition.
power sequencing considerations
Though an internal ESD and CMOS latchup protection diode exists between CVDD and DVDD, it should not be
considered a current-carrying device on power up. An external Schottky diode should be used to prevent CVDD
from exceeding DVDD by more than 0.7 V. The effect of this diode during power up is that if CVDD is powered
up first, DVDD will follow by one diode drop even when the DVDD supply is not active.
Typical systems using LDOs of the same family type for both DVDD and CVDD will track each other during power
up. In most cases, this is acceptable; but if a high-impedance pin state is required on power up, the SHZ pin
can be used to asynchronously disable all outputs. RESET should not be used in this case since some signals
require an active clock for RESET to have an effect and the clock may not yet be active. The internal core logic
becomes functional at approximately 0.8 V while the external pin IO becomes active at about 1.5 V.
相关PDF资料
PDF描述
SM34020AHTM32 GRAPHICS PROCESSOR, CQFP132
SM563 4-BIT, MROM, MICROCONTROLLER, PQFP64
SM565 4-BIT, MROM, MICROCONTROLLER, PQFP100
SM5K7 4-BIT, MROM, MICROCONTROLLER
SM5L3 4-BIT, MROM, MICROCONTROLLER, PQFP80
相关代理商/技术参数
参数描述
SM320VC33PGEA120EP 功能描述:数字信号处理器和控制器 - DSP, DSC EP Dig Signal Proc RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT
SM320VC5409-EP 制造商:TI 制造商全称:Texas Instruments 功能描述:FIXED-POINT DIGITAL SIGNAL PROCESSOR
SM320VC5409GGU10EP 功能描述:数字信号处理器和控制器 - DSP, DSC Fxd-pt Dig Sig Proc Mil enhanced RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT
SM320VC5416-EP 制造商:TI 制造商全称:Texas Instruments 功能描述:SM320VC5416-EP Fixed-Point Digital Signal Processor
SM320VC5416GGU16EP 功能描述:数字信号处理器和控制器 - DSP, DSC Fxd-pt Dig Sig Proc Mil enhanced RoHS:否 制造商:Microchip Technology 核心:dsPIC 数据总线宽度:16 bit 程序存储器大小:16 KB 数据 RAM 大小:2 KB 最大时钟频率:40 MHz 可编程输入/输出端数量:35 定时器数量:3 设备每秒兆指令数:50 MIPs 工作电源电压:3.3 V 最大工作温度:+ 85 C 封装 / 箱体:TQFP-44 安装风格:SMD/SMT