- 您现在的位置：买卖IC网 > PDF目录382625 > TMP86CH47SUG (Toshiba Corporation) Zener Diode; Application: General; Pd (mW): 500; Vz (V): 18.1 to 19.0; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 PDF资料下载
参数资料
| 型号： | TMP86CH47SUG |
| 厂商： | Toshiba Corporation |
| 英文描述： | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 18.1 to 19.0; Condition Iz at Vz (mA): 5; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| 中文描述： | 8位微控制器 |
| 文件页数： | 105/160页 |
| 文件大小： | 1627K |
| 代理商： | TMP86CH47SUG |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页当前第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页第142页第143页第144页第145页第146页第147页第148页第149页第150页第151页第152页第153页第154页第155页第156页第157页第158页第159页第160页
Page 97
TMP86CH47SUG
9.3.8
16-Bit Programmable Pulse Generate (PPG) Output Mode (TC3 and 4)
This mode is used to generate pulses with up to 16-bits of resolution. The timer counter 3 and 4 are cascad-
able to enter the 16-bit PPG mode.
The counter counts up using the internal clock or external clock. When a match between the up-counter and
the timer register (PWREG3, PWREG4) value is detected, the logic level output from the timer F/F4 is
switched to the opposite state. The counter continues counting. The logic level output from the timer F/F4 is
switched to the opposite state again when a match between the up-counter and the timer register (TTREG3,
TTREG4) value is detected, and the counter is cleared. The INTTC4 interrupt is generated at this time.
Since the initial value can be set to the timer F/F4 by TC4CR<TFF4>, positive and negative pulses can be
generated. Upon reset, the timer F/F4 is cleared to 0.
(The logic level output from the
PPG
4 pin is the opposite to the timer F/F4.)
Set the lower byte and upper byte in this order to program the timer register. (TTREG3
→
TTREG4,
PWREG3
→
PWREG4) (Programming only the upper or lower byte should not be attempted.)
For PPG output, set the output latch of the I/O port to 1.
Note 1: In the PPG mode, do not change the PWREGi and TTREGi settings while the timer is running. Since
PWREGi and TTREGi are not in the shift register configuration in the PPG mode, the new values pro-
grammed in PWREGi and TTREGi are in effect immediately after programming PWREGi and TTREGi.
Therefore, if PWREGi and TTREGi are changed while the timer is running, an expected operation may not
be obtained.
Note 2: When the timer is stopped during PPG output, the
PPG
4 pin holds the output status when the timer is
stopped. To change the output status, program TC4CR<TFF4> after the timer is stopped. Do not change
TC4CR<TFF4> upon stopping of the timer.
Example: Fixing the
PPG
4 pin to the high level when the TimerCounter is stopped
CLR (TC4CR).3: Stops the timer
CLR (TC4CR).7: Sets the
PPG
4 pin to the high level
Note 3: i = 3, 4
Two machine cycles are required for the high- or low-level pulse input to the TC3 pin. Therefore, a maxi-
mum frequency to be supplied is fc/2
4
Hz in the NORMAL1/2 or IDLE1/2 mode, and fs/2
4
to in the SLOW1/
2 or SLEEP1/2 mode.
Example :Generating a pulse with 1-ms high-level width and a period of 16.385 ms (fc = 16.0 MHz)
Setting ports
LDW
(PWREG3), 07D0H
: Sets the pulse width.
LDW
(TTREG3), 8002H
: Sets the cycle period.
LD
(TC3CR), 33H
: Sets the operating clock to fc/2
3
, and16-bit PPG mode
(lower byte).
LD
(TC4CR), 057H
: Sets TFF4 to the initial value 0, and 16-bit
PPG mode (upper byte).
LD
(TC4CR), 05FH
: Starts the timer.
相关PDF资料 |
PDF描述 |
|---|---|
| TMP86CH49FG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 18.8 to 19.7; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CH72FG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 19.5 to 20.4; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CK74AFG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 20.2 to 21.1; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CM23AUG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 20.9 to 21.9; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
| TMP86CM27FG | Zener Diode; Application: General; Pd (mW): 500; Vz (V): 21.6 to 22.6; Condition Iz at Vz (mA): 2; C (pF) max: -; Condition VR at C (V):   ESD (kV) min: -; Package: DO-35 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TMP86CH47U | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:CMOS 8 BIT MICROCONTROLLER |
| TMP86CH47UG | 制造商:Toshiba America Electronic Components 功能描述:MCU 8BIT TLCS-870 CISC 16KB ROM 5V 44PQFP - Rail/Tube |
| TMP86CH49FG | 制造商:TOSHIBA 制造商全称:Toshiba Semiconductor 功能描述:8 Bit Microcontroller |
| TMP86CH72FG | 制造商:Toshiba America Electronic Components 功能描述:TLCS870/C 16K ROM , VFT - Rail/Tube |
| TMP86CK74AF | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Microcontroller |
发布紧急采购，3分钟左右您将得到回复。