参数资料
型号: TPS51727RHARG4
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: DUAL SWITCHING CONTROLLER, 500 kHz SWITCHING FREQ-MAX, PQCC40
封装: 6 X 6 MM, GREEN, PLASTIC, QFN-40
文件页数: 29/42页
文件大小: 0K
代理商: TPS51727RHARG4
Power Chain Symmetry
Place Analog Components as Close to the Device as Possible
Grounding Recommendations
Decoupling Recommendations
Conductor Widths
www.ti.com ..................................................................................................................................................... SLUS806B – APRIL 2008 – REVISED JANUARY 2009
The TPS51727 does not require special care in the layout of the power chain components, because independent
isolated current feedback is provided. Make every effort to lay out the phases in a symmetrical manner. The
current feedback from each phase must be free of noise and have the same effective current sense resistance.
Place components close to the device in the following order.
1. CS pin noise filtering components
2. DROOP pin compensation component
3. Decoupling capacitor
4. ISLEW resistor (RSLEW)
The TPS51727 has separate analog and power grounds, and a thermal pad. The normal procedure for
connecting these is:
1. Connect the thermal pad to PGND.
2. Tie the thermal pad to the system ground plane with at least 4 small vias or one large via.
3. GND can be connected to any quiet space. A quiet space is defined as a spot where no power supply
switching currents are likely to flow. This applies to all switching converters on the same board. Use a single
point connection to the point, and pour a GND island around the analog components.
4. Make sure the bottom MOSFET source connection and the decoupling capacitors have plenty of vias.
Decouple V5 to PGND with at least a 2.2-F ceramic capacitor. This fits best on the opposite side of the
device.
Use double vias to connect to the device.
Decouple V5FILT with 1-F to AGND with leads as short as possible.
Decouple VREF to AGND with 0.22-F, with short leads as short as possible.
Maximize the widths of power, ground and drive signal connections.
For conductors in the power path, be sure there is adequate trace width for the amount of current flowing
through the traces.
Make sure there are sufficient vias for connections between layers.
Use a minimum of 1 via per ampere of current
Copyright 2008–2009, Texas Instruments Incorporated
35
Product Folder Link(s): TPS51727
相关PDF资料
PDF描述
TPS54312QPWPRQ1 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20
TPS54316QPWPRQ1 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20
TPS54315QPWPRQ1 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20
TPS54313QPWPRQ1 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20
TPS54311QPWPRQ1 7.5 A SWITCHING REGULATOR, 762 kHz SWITCHING FREQ-MAX, PDSO20
相关代理商/技术参数
参数描述
TPS51727RHAT 功能描述:DC/DC 开关控制器 Dual-Ph Eco-Mode Stp Down Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TPS51727RHATG4 功能描述:DC/DC 开关控制器 2Ph Eco-Mode Step Down Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK
TPS51728RHAR 制造商:Texas Instruments 功能描述:DUAL PHASE MANAGEMENT IC FOR APPLICATION 制造商:Texas Instruments 功能描述:CONTROLLER-NON VMI
TPS5172RHAR 制造商:TI 制造商全称:Texas Instruments 功能描述:DUAL-PHASE, ECO-MODE⑩ STEP-DOWN POWER MANAGEMENT IC FOR 50-A+ APPLICATIONS
TPS5172RHAT 制造商:TI 制造商全称:Texas Instruments 功能描述:DUAL-PHASE, ECO-MODE⑩ STEP-DOWN POWER MANAGEMENT IC FOR 50-A+ APPLICATIONS