参数资料
型号: TPS65930BZCH
厂商: TEXAS INSTRUMENTS INC
元件分类: 消费家电
英文描述: SPECIALTY CONSUMER CIRCUIT, PBGA139
封装: 10 X 10 MM, 0.65 MM PITCH, GREEN, PLASTIC, NFBGA-139
文件页数: 87/115页
文件大小: 1232K
代理商: TPS65930BZCH
UART_TX
DM
DP
UART_RX
CK1
CK2
CK3
CK4
037-047
SWCS037G
– MAY 2008 – REVISED APRIL 2011
Table 7-4. USB-CEA Carkit UART Timings
Notation
Parameter
Min
Max
Unit
CK1
td(UART_TXH-DM)
Delay time, UART_TX rising edge to DM transition
4.0
11
ns
CK2
td(UART_TXL-DM)
Delay time, UART_TX falling edge to DM transition
4.0
11
ns
At 38.4 MHz
205
234
Delay time, DP rising edge to UART_RX
CK3
td(DPH-UART_RX)
ns
transition
At 19.2 MHz
310
364
At 38.4 MHz
205
234
Delay time, DP falling edge to UART_RX
CK4
td(DPL-UART_RX)
ns
transition
At 19.2 MHz
310
364
Figure 7-5 shows the USB-CEA carkit UART timings.
Figure 7-5. USB-CEA Carkit UART Timings
7.1.4
PHY Electrical Characteristics
The PHY is the physical signaling layer of the USB 2.0. It contains the drivers and receivers for physical
data and protocol signaling on the DP and DM lines.
The PHY interfaces with the USB controller through the UTMI.
The transmitters and receivers in the PHY are of two main classes:
FS and LS transceivers (legacy USB1.x transceivers)
HS transceivers
To bias the transistors and run the logic, the PHY also contains reference generation circuitry which
consists of:
A DPLL that does a frequency multiplication to achieve the 480-MHz low-jitter lock necessary for USB,
and the clock required for the switched capacitor resistance block
A switched capacitor resistance block that replicates an external resistor on chip
Built-in pullup and pulldown resistors are used as part of the protocol signaling.
The PHY also contains circuitry that protects it from an accidental 5-V short on the DP and DM lines and
from 8-kV IEC ESD strikes.
7.1.4.1
HS Differential Receiver
The HS receiver consists of the following blocks:
A differential input comparator to receive the serial data
A squelch detector to qualify the received data
An oversampler-based clock data recovery scheme followed by a nonreturn to zero inverted (NRZI)
decoder, bit unstuffing, and serial-to-parallel converter to generate the UTMI DATAOUT
Table 7-5 lists the characteristics of the HS differential receiver.
Copyright
2008–2011, Texas Instruments Incorporated
USB Transceiver
73
focus.ti.com: TPS65930/TPS65920
相关PDF资料
PDF描述
TPS65950ZXNR SPECIALTY CONSUMER CIRCUIT, PBGA209
TPS65950ZXNT SPECIALTY CONSUMER CIRCUIT, PBGA209
TPS6735Y 2 A SWITCHING REGULATOR, 160 kHz SWITCHING FREQ-MAX, UUC12
TPS6735IP 2 A SWITCHING REGULATOR, 160 kHz SWITCHING FREQ-MAX, PDIP8
TPS6755Y 2 A SWITCHING REGULATOR, 160 kHz SWITCHING FREQ-MAX, UUC8
相关代理商/技术参数
参数描述
TPS65930BZCH 制造商:Texas Instruments 功能描述:IC POWER MANAGEMENT ((NW))
TPS65930BZCHR 功能描述:开关变换器、稳压器与控制器 Int Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
TPS65950A2ZXN 功能描述:PMIC 解决方案 Integ Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
TPS65950A2ZXNR 功能描述:PMIC 解决方案 Integ Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel
TPS65950A3ZXN 功能描述:PMIC 解决方案 Integrated Pwr Mgmt IC RoHS:否 制造商:Texas Instruments 安装风格:SMD/SMT 封装 / 箱体:QFN-24 封装:Reel