- 您现在的位置：买卖IC网 > PDF目录373745 > TSS463A-TERZ (Atmel Corp.) VAN Data Link Controller with Serial Interface PDF资料下载
参数资料
| 型号： | TSS463A-TERZ |
| 厂商： | Atmel Corp. |
| 英文描述： | VAN Data Link Controller with Serial Interface |
| 中文描述： | 凡数据与串行接口链路控制器 |
| 文件页数： | 11/60页 |
| 文件大小： | 816K |
| 代理商： | TSS463A-TERZ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
11
TSS463-AA
4205B–AUTO–12/04
Figure 8.
SCI Speed Considerations
Interrupts
If an event occurs in the TSS463AA that needs the attention of the processor, this will
be signalled on the active low, open-drain interrupt request pin. The event that creates
this request is controlled by the internal registers.
Every time the microprocessor accesses any of the interrupt registers (addresses 0x08
to 0x0B), the INT pin will be released momentarily. This enables the TSS463AA to work
with processors that have either edge or level sensitive interrupt inputs.
Reset
The reset is applied asynchronously or synchronously to the XTAL clock.
Asynchronous Reset
It can be done either by the RESET pin (hardware asynchronous reset) or by software
(software asynchronous reset).
The RESET pin is a CMOS trigger input with a pull-up resistor (~ 70 k
). An external
1
μ
F capacitor to GND provides to RESET pin an efficient behavior.
The asynchronous software reset is made by the "Initialization Sequence" described in
“Motorola SPI Mode” on page 5.
Two "0x00" bytes provide an asynchronous software reset and configure the TSS463AA
in the Motorola SPI mode while two "0xFF" bytes provide a reset and configure the com-
ponent in the Intel SPI mode and "0x00 followed by 0xFF " provide a reset and configure
the component in the SCI mode. The SS pin must be asserted as shown on Figure 9.
The SPI/SCI logic will monitor these two bytes and provide an internal reset pulse
asserting the TSS463AA in the right mode.
Synchronous Reset
A synchronous reset (regarding XTAL clock) is available on the TSS463AA during cur-
rent operation. It is made through the GRES command bit of the Command Register
(address 0x03).
The two kinds of reset are ordered and filtered. Then the internal reset, always asserted
asynchronously, enables the internal oscillator. Then it waits for 12 clock periods and
the oscillator stability.
The different blocks of the TSS463AA need to be turned on synchronously. The release
of the internal reset is synchronous and a loose of clock can let the TSS463AA in per-
manent reset after applying Reset.
It is important to note that even after a reset on the RESET pin, the user should wait for
12 clock periods before sending the "Initialization Sequence" in order to select the SPI
or SCI mode (because the default mode after a hardware reset is the Motorola SPI
mode).
Data
Control
Address
12 Xtal Min
(12s at 1 MHz)
(8 s at 1 MHz)
(4 s at 1 MHz)
15 Xtal Min
(15 s at 1 MHz)
SS
SCLK
MOSI
Start Bit
Stop Bit
125 Kbits/s Max for SCLK
8 Xtal Min
4 Xtal Min
相关PDF资料 |
PDF描述 |
|---|---|
| TSS463C | VAN Data Link Controller with Serial Interface |
| TSS4B02G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B03G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B01G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS5G45S | TOSHIBA SOLID STATE AC RELAY |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSS463B | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_03 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_04 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface |
| TSS463B-TERA | 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP |
| TSS463B-TERA-9 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface |
发布紧急采购，3分钟左右您将得到回复。