- 您现在的位置：买卖IC网 > PDF目录373745 > TSS463A-TERZ (Atmel Corp.) VAN Data Link Controller with Serial Interface PDF资料下载
参数资料
| 型号： | TSS463A-TERZ |
| 厂商： | Atmel Corp. |
| 英文描述： | VAN Data Link Controller with Serial Interface |
| 中文描述： | 凡数据与串行接口链路控制器 |
| 文件页数： | 39/60页 |
| 文件大小： | 816K |
| 代理商： | TSS463A-TERZ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页当前第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
39
TSS463-AA
4205B–AUTO–12/04
Identifier Tag and Command
Registers
The identifier tag and command registers are located at the base_address and
base_address + 1. It allows the user to specify the full 12-bit identifier field of the ISO
standard and the 4-bit command.
Read/Write registers.
ID_T [11:0]: Identifier Tag
Upon a reception hit (i.e, a good comparison between the identifier received and an
identifier specified, taking the comparison mask into account, as well as a status and
command indicating a message to be received), the identifier tag bits value will be
rewritten with the identifier bits actually received.
EXT, RAK, RNW and RTR
(See Section “Message Types”, page 45). No comparison will be done on the command
bits, except on EXT bit. The RAK, RNW and RTR bits will be written into the first byte of
the Message upon a reception hit.
The RNW and RTR bits, as well as the status bits in the length and status register, must
be in a valid position for reception or transmission. If not, the message corresponding to
this identifier is considered as inactive or invalid.
The way of knowing if an acknowledge sequence was requested or not is to check the
first byte of the Message.
Message Pointer Register
The message pointer register at address (base_address + 0x02) is 8 bits wide. It indi-
cates where in the Message DATA RAM area the message buffer is located.
Read/Write register.
DRAK: Disable RAK (Used in
‘Spy Mode’)
In reception: whatever is the RAK bit of the incoming valid frame, no ACK answer will be
set. If the message was successfully received, an IT is set (ROK or RNOK).
In transmission: no action.
One
: disable active, “spy mode”.
Zero
: disable inactive, normal operation.
M_P [6:0]: Message Pointer
Since the Message DATA RAM area base address is 0x80, the value in this register is
the offset from that address. If the message buffer length value is illegal (i.e. zero), this
register is redefined as being a link pointer, thus containing the channel number of the
channel that contains the actual message pointer, message length and received status.
However, the identifier, mask, error and transmitted status used will be that of the origi-
nally matched channel. In any case, if a link is intended, the three high bits of M_P [6:0]
should be set to 0.
7
6
5
4
3
2
1
0
ID_T 3
ID_T 2
ID_T 1
ID_T 0
EXT
RAK
RNW
RTR
base_address
+ 0x01
7
6
5
4
3
2
1
0
ID_T 11
ID_T 10
ID_T 9
ID_T 8
ID_T 7
ID_T 6
ID_T 5
ID_T 4
base_address
+ 0x00
7
6
5
4
3
2
1
0
DRAK
M_P 6
M_P 5
M_P 4
M_P 3
M_P 2
M_P 1
M_P 0
base_address
+ 0x02
相关PDF资料 |
PDF描述 |
|---|---|
| TSS463C | VAN Data Link Controller with Serial Interface |
| TSS4B02G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B03G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS4B01G | Single Phase 4.0 Amps. Glass Passivated Super Fast Bridge Rectifiers |
| TSS5G45S | TOSHIBA SOLID STATE AC RELAY |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TSS463B | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_03 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Serial VAN Data Link Controller |
| TSS463B_04 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface |
| TSS463B-TERA | 制造商:Temic 功能描述:LAN Node Controller, 16 Pin, SOP |
| TSS463B-TERA-9 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:VAN Data Link Controller with Serial Interface |
发布紧急采购，3分钟左右您将得到回复。