- 您现在的位置：买卖IC网 > PDF目录297788 > W25Q16BVDAIP (WINBOND ELECTRONICS CORP) 2M X 8 SPI BUS SERIAL EEPROM, PDIP8 PDF资料下载
参数资料
| 型号： | W25Q16BVDAIP |
| 厂商： | WINBOND ELECTRONICS CORP |
| 元件分类： | PROM |
| 英文描述： | 2M X 8 SPI BUS SERIAL EEPROM, PDIP8 |
| 封装： | 0.300 INCH, GREEN, PLASTIC, DIP-8 |
| 文件页数： | 37/68页 |
| 文件大小： | 2055K |
| 代理商： | W25Q16BVDAIP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页当前第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页
W25Q16BV
- 42 -
11.2.23 Erase Suspend (75h)
The Erase Suspend instruction “75h”, allows the system to interrupt a Sector or Block Erase operation
and then read from or program data to, any other sectors or blocks. The Erase Suspend instruction
sequence is shown in figure 22.
The Write Status Register instruction (01h) and Erase instructions (20h, 52h, D8h, C7h, 60h) are not
allowed during Erase Suspend. Erase Suspend is valid only during the Sector or Block erase operation. If
written during the Chip Erase or Program operation, the Erase Suspend instruction is ignored.
The Erase Suspend instruction “75h” will be accepted by the device only if the SUS bit in the Status
Register equals to 0 and the BUSY bit equals to 1 while a Sector or Block Erase is on-going. If the SUS
bit equals to 1 or the BUSY bit equals to 0, the Suspend instruction will be ignored by the device. A
maximum of time of “tSUS” (See AC Characteristics) is required to suspend the erase operation. The
BUSY bit in the Status Register will be cleared from 1 to 0 within “tSUS” and the SUS bit in the Status
Register will be set from 0 to 1 immediately after Erase Suspend. For a previously resumed Erase
operation, it is also required that the Suspend instruction “75h” is not issued earlier than a minimum of
time of “tSUS” following the preceding Resume instruction “7Ah”.
Unexpected power off during the Erase suspend state will reset the device and release the suspend
state. SUS bit in the Status Register will also reset to 0. The data within the sector or block that was being
suspended may become corrupted. It is recommended for the user to implement system design
techniques against the accidental power interruption and preserve data integrity during erase suspend
state.
Figure 22. Erase Suspend Instruction Sequence Diagram
相关PDF资料 |
PDF描述 |
|---|---|
| W25Q16BVSNIP | 2M X 8 SPI BUS SERIAL EEPROM, PDSO8 |
| W25Q40BLSNIP | 4M X 1 SPI BUS SERIAL EEPROM, PDSO8 |
| W25Q80BVSFIG | 1M X 8 SPI BUS SERIAL EEPROM, PDSO16 |
| W25X32AVZPIG | 4M X 8 FLASH 2.7V PROM, PDSO8 |
| W25X32AVSFIG | 4M X 8 FLASH 2.7V PROM, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| W25Q16BVSFIG | 功能描述:IC SPI FLASH 16MBIT 16SOIC RoHS:是 类别:集成电路 (IC) >> 存储器 系列:SpiFlash® 标准包装:2,000 系列:- 格式 - 存储器:RAM 存储器类型:SRAM - 异步 存储容量:256K (32K x 8) 速度:15ns 接口:并联 电源电压:3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 封装/外壳:28-TSSOP（0.465"，11.8mm 宽） 供应商设备封装:28-TSOP 包装:带卷 (TR) 其它名称:71V256SA15PZGI8 |
| W25Q16BVSFIP | 制造商:WINBOND 制造商全称:Winbond 功能描述:16M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI |
| W25Q16BVSNIG | 制造商:Winbond Electronics Corp 功能描述:Flash Serial-SPI 3.3V 16Mbit 2M x 8bit 6ns 8-Pin SOIC |
| W25Q16BVSNIP | 制造商:WINBOND 制造商全称:Winbond 功能描述:16M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI |
| W25Q16BVSSIG | 功能描述:IC SPI FLASH 16MBIT 8SOIC RoHS:是 类别:集成电路 (IC) >> 存储器 系列:SpiFlash® 标准包装:1 系列:- 格式 - 存储器:闪存 存储器类型:闪存 - NAND 存储容量:4G（256M x 16） 速度:- 接口:并联 电源电压:2.7 V ~ 3.6 V 工作温度:0°C ~ 70°C 封装/外壳:48-TFSOP（0.724"，18.40mm 宽） 供应商设备封装:48-TSOP I 包装:Digi-Reel® 其它名称:557-1461-6 |
发布紧急采购，3分钟左右您将得到回复。