参数资料
型号: WJLXT907ALCA4
厂商: CORTINA SYSTEMS INC
元件分类: 网络接口
英文描述: DATACOM, ETHERNET TRANSCEIVER, PQFP64
封装: ROHS COMPLIANT, LQFP-64
文件页数: 2/48页
文件大小: 621K
代理商: WJLXT907ALCA4
Intel
LXT901A/907A Universal 3.3 V Ethernet Transceiver
10
Datasheet
Document Number: 249098
Revision Number: 003
Revision Date: 27-Nov-2005
21
37
LEDC/
FDE
OD
Collision LED (LEDC)/Full-Duplex Enable (FDE). Open drain driver for the
collision indicator pulls Low during collision.
LED “On” (i.e., Low output) time is extended by approximately 100 ms.
If externally tied Low, enables full-duplex operation by disabling the internal TP
loopback and collision detection circuits in anticipation of external twisted-pair
loopback or full-duplex operation.
If this pin is not used, tie High or directly to Vcc.
22
38
LBK
I
Loopback. Enables internal loopback mode. Refer to Functional Description for
details.
23
33
39
55
GND1
GND2
Ground Returns 1 and 2. Grounds
40
GNDA
Analog Ground.
24
42
RBIAS
I
Bias Control. A 12.4 k
Ω 1% resistor to ground at this pin controls operating
circuit bias.
26
45
RXD
O
Receive Data. Output signal. Connect directly to the receive data input of the
controller.
27
46
CD
O
Carrier Detect. An output to notify the controller of activity on the network.
28
47
RCLK
O
Receive Clock. A recovered 10 MHz clock that is synchronous to the received
data. Connect to the controller receive clock input.
30
52
PLR
O
Polarity Reverse. Output goes High to indicate reversed polarity at the twisted-
pair input.
31
36
32
35
53
58
54
57
TPOPB
TPONB
TPOPA
TPONA
O
Twisted-Pair Transmit Pairs A & B. Two differential driver pair outputs (A and B)
to the twisted-pair cable. The outputs are pre-equalized.
Each pair must be shorted together and tied to the transformer through a
24.9
Ω 1% series resistor to match impedance of 100Ω.
Refer to Figure 16 on page 28 in the Applications Section for information on 150
Ω
configurations.
37
59
STP
I
STP Select (LXT901A Transceiver only).
When STP is Low, 150
Ω termination for shielded twisted-pair is selected.
When STP is High, 100
Ω termination for unshielded twisted-pair is selected.
LXT907A Transceiver is designed for 100
Ω unshielded twisted-pair termination
(not selectable).
DSQE
I
Disable SQE (LXT907A Transceiver only).
When DSQE is High, the SQE function is disabled.
When DSQE is Low, the SQE function is enabled.
SQE must be disabled for normal operation in Hub/Switch applications.
The LXT901A Transceiver operates with SQE enabled (not selectable).
38
39
61
62
TPIP
TPIN
I
Twisted-Pair Receive Pair. A differential input pair from the twisted-pair cable.
Receive filter is integrated on-chip. No external filters are required.
40
3
PAUI
I
Port/AUI Select. In Manual Port Select mode (AUTOSEL Low), PAUI selects the
active port.
When PAUI is High, the AUI port is selected.
When PAUI is Low, the TP port is selected.
In Auto Port Select mode, PAUI must be tied to ground.
Table 1.
Signal Descriptions (Continued)
Pin #
Symbol
I/O1
Description
PLCC
LQFP
1. I/O Column Coding: I = Input, O = Output, OD = Open Drain
相关PDF资料
PDF描述
WJLXT905LC.C2 DATACOM, ETHERNET TRANSCEIVER, PQFP32
WJLXT905LE.C2 DATACOM, ETHERNET TRANSCEIVER, PQFP32
WJLXT905LC.C2 DATACOM, ETHERNET TRANSCEIVER, PQFP32
WJLXT905LE.C2 DATACOM, ETHERNET TRANSCEIVER, PQFP32
WJLXT908LE.A4 DATACOM, ETHERNET TRANSCEIVER, PQFP64
相关代理商/技术参数
参数描述
WJLXT908LC.A4 功能描述:IC 3V 10BASE-T/AUI TXCVR 64LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
WJLXT908LC.A4-865813 制造商:Cortina Systems Inc 功能描述:PHY 1-CH 10Mbps 64-Pin LQFP
WJLXT908LC.A4-866864 制造商:Cortina Systems Inc 功能描述:UNIVERSAL 10BASE-T TRANSCEIVER WITH 3.3 V SUPPORT
WJLXT908LE.A4 功能描述:IC 3V 10BASE-T/AUI TXCVR 64-LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器,接收器,收发器 系列:- 标准包装:1,000 系列:- 类型:收发器 驱动器/接收器数:2/2 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SOIC(0.295",7.50mm 宽) 供应商设备封装:16-SOIC 包装:带卷 (TR)
WJLXT908LE.A4-865811 制造商:Cortina Systems Inc 功能描述:Ethernet TXRX Single Chip 1-Port 3.3V 10Mbps 64-Pin LQFP