参数资料
型号: 71M6521BE-IGT/F
厂商: Maxim Integrated
文件页数: 81/97页
文件大小: 0K
描述: IC ENERGY METER 8K FLASH 64-LQFP
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 160
系列: Single Converter Technology®
测量误差: 0.4%
电源电压: 3 V ~ 3.6 V
测量仪表类型: 单相,双相
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 64-LQFP
供应商设备封装: 64-LQFP(10x10)
包装: 托盘
71M6521BE
Energy Meter IC
DATA SHEET
JANUARY 2008
Pulse Generation
CE
Address
0x1044
Name
WRATE
Default
389
Description
Kh = VMAX * IMAX *47.1132 / ( In_8 * WRATE *N ACC *X) Wh/pulse. The default
value results in a Kh of 1.0Wh/pulse when 2520 samples are taken in each
accumulation interval (and VMAX =600, IMAX = 208, In_8 = 1, X = 6).
The maximum value for WRATE is 2 15 – 1.
WRATE controls the number of pulses that are generated per measured Wh quantities. The lower WRATE is the slower the
pulse rate for measured energy quantity. The metering constant Kh is derived from WRATE as the amount of energy measured
for each pulse. That is, if Kh = 1Wh/pulse, a power applied to the meter of 120V and 30A results in one pulse per second. If
the load is 240V at 150A, ten pulses per second will be generated. X is controlled by the PULSE_FAST and PULSE_SLOW bits
in the CECONFIG register.
The maximum pulse rate is 7.5kHz. The maximum time jitter is 67μs and is independent of the number of pulses measured.
Thus, if the pulse generator is monitored for 1 second, the peak jitter is 67ppm. After 10 seconds, the peak jitter is 6.7ppm.
The average jitter is always zero. If it is attempted to drive either pulse generator faster than its maximum rate, it will simply
output at its maximum rate without exhibiting any rollover characteristics. The actual pulse rate, using WSUM as an example,
is:
RATE =
WRATE ? WSUM ? F S ? X
2 46
Hz ,
where F S = sampling frequency (2520.6Hz), X = Pulse speed factor
CE Calibration Parameters
The table below lists the parameters that are typically entered to effect calibration of meter accuracy.
CE
Address
0x1020
0x1024
0x1028
0x102C
Name
CAL_IA
CAL_VA
CAL_IB
CAL_VB
Default
16384
16384
16384
16384
Description
These constants control the gain of their respective channels. The nominal
value for each parameter is 2 14 = 16384. The gain of each channel is directly
proportional to its CAL parameter. Thus, if the gain of a channel is 1% slow,
CAL should be scaled by 1/(1 – 0.01).
These two constants control the CT phase compensation. No compensation
(lag) is introduced. Range: ± 2
– 1. If it is desired to delay the current by the
0x1030
PHADJ_A
0
occurs when PHADJ_X = 0. As PHADJ_X is increased, more compensation
15
angle Φ :
0x1034
PHADJ_B
0
PHADJ _ X = 2 20
PHADJ _ X = 2 20
0 . 02229 ? TAN Φ
0 . 1487 ? 0 . 0131 ? TAN Φ
0 . 0155 ? TAN Φ
0 . 1241 ? 0 . 009695 ? TAN Φ
at 60Hz
at 50Hz
V1.0
? 2005-2008 TERIDIAN Semiconductor Corporation
Page: 81 of 97
相关PDF资料
PDF描述
ABC44DRES CONN EDGECARD 88POS .100 EYELET
RS3-4809SZ CONV DC/DC 3W 20-60VIN 09VOUT
VI-BNK-EU-F1 CONVERTER MOD DC/DC 40V 200W
78M6610+PSU/B00 IC ENERGY MEASURMENT 1PH 24TQFN
ACB65DHLT CONN EDGECARD 130PS .050 DIP SLD
相关代理商/技术参数
参数描述
71M6521BE-IGTR/F 功能描述:计量片上系统 - SoC Residential Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6521BE-IGTR/F1 功能描述:计量片上系统 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6521DE 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Energy Meter IC
71M6521DE-DB 制造商:Maxim Integrated Products 功能描述:Development Boards & Kits - 8051 71M6521DE Demo Brd
71M6521DE-IGT/F 功能描述:计量片上系统 - SoC Residential Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel