- 您现在的位置：买卖IC网 > PDF目录16270 > 73S1217F-EB-LITE (Maxim Integrated Products)BOARD EVAL 73S1217F CBL/DOC/CD PDF资料下载
参数资料
| 型号： | 73S1217F-EB-LITE |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 19/93页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL 73S1217F CBL/DOC/CD |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页
73S12xxF Software User Guide
UG_12xxF_016
26
Rev. 1.50
4.2.4
Real Time Clock API - Available with the 68-pin 73S12xxF
The 73S12xxF provides a 32-bit counter selectable in 0.5, 1 or 2 second increments to measure time. This time
mark can also be used to generate RTC interrupts at 0.5, 1, 2, 4, or 8-second intervals. A 24-bit trimming
function, along with a 24-bit accumulator, is provided to correct the clock drift induced by the quartz crystal.
The device also supports a watchdog capability. This feature will give the processor 0.5 seconds to
respond to an RTC interrupt. If the RTC interrupt is not serviced within 0.5 seconds, a full RESET to the
72S12xxF is performed. To use the watchdog timer function, the RTC interrupt must be enabled.
Consequently, the watchdog will always be enabled when the RTC interrupt is enabled. It is not possible
to turn off the watchdog while the RTC interrupt is enabled.
Care should be taken as it is possible for the device to be put into an infinite reset loop when an
RTC interrupt is not serviced on time (within 0.5 second). When this problem occurs,
reprogram the Flash with a known good application/program using the TFP.
The RTC block uses the 32768 Hz oscillator signal or divider logic (from the 12 MHz oscillator circuit) to
produce 0.5 second time marks. The 32768 Hz oscillator can be disabled (see the PowerOFF API), but
is intended to operate at all times in all power consumption modes. If a 32 kHz crystal is not provided,
this oscillator must be disabled and the RTC will operate from an internal 96 MHz clock divided by 2930.
In this case, the RTC trim value should be set as described in the following paragraph.
The 3-byte accumulator can hold 2
24 = 16,777,216, which yields a 0.0596 PPM resolution. Using the 12 MHz
oscillator gives 96 MHz/2930 which will generate 32,764 Hz. The core RTC uses a 32,768 Hz Oscillator crystal.
This yields a 106 PPM error. Therefore, the trim value = (106 PPM) / (.0596 PPM) ~= 1778 (0x06F2).
When the accumulator reaches overflow, it will advance the counter one additional count if the trim value
is positive, or prevent the counter from advancing one count if the trim value is negative.
The trim value can be set in the API_12.h file. RTClk_Init () must be called prior to using any of the RTC
APIs. Once the RTC is initialized, the 32 kHz OSC clock will always be running. To turn it off, use the
PowerOFF (DISABLE_RTC) API.
The Real Time Clock API is described in detail below and includes:
RTClk_Init () (page 26)
RTCClk_Control () (page 27)
RTClk_Write () (page 27)
RTCClk_GetTIME () (page 28)
RTCClk_SetTIME () (page 29)
RTClk_Init ()
Purpose
Initialize the Real Time Clock values by setting the accumulator to 0 and setting the
trim values as defined in api_12.h. The default base day is defined as 12:00:00,
01/01/2005 calculated using the Gregorian/Julian conversion defined in:
When this function is called, the RTC is stopped and restarted. The RTC counter,
trim and accumulator will be loaded at the next 32 kHz clock positive edge. The RTC
interrupt is NOT set here. Use RTClk_Control() to set the interrupt. The RTC
counter continues to count whether the RTC interrupt is enabled or not.
The Interrupt service routine for the RTC interrupt can be masked using the Set_Event (eRTC,
pRTCVector) API. If customization of the RTC ISR is desirable, call Set_Event after this API is
called. See Set_Event() for its usage description.
相关PDF资料 |
PDF描述 |
|---|---|
| UPT2D221MHD6 | CAP ALUM 220UF 200V 20% RADIAL |
| MAX5391NEVMINIQU+ | EVAL KIT MAX5391 |
| GSC08DRTN-S93 | CONN EDGECARD 16POS DIP .100 SLD |
| CM453232-R56KL | INDUCTOR 560NH 520MA SMD |
| REC15-1212D/H3 | CONV DC/DC 15W 12VIN +/-12VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 73S1217F-IMR/F | 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Bus-Powered 80515 System-on-Chip with USB, ISO 7816 / EMV, PINpad and More |
| 73S13B | 制造商:QUARTZCOM 制造商全称:QUARTZCOM the communications company 功能描述:-20 ~ +70 °C commercia l application -30 ~ +75 °C on request |
| 73S5040G01X0A | 制造商:NEX Computers 功能描述:INTEL 40GB SSD - Bulk |
| 73S8009C | 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Versatile Power Management and Smart Card Interface IC |
| 73S8009C-20IM/F | 功能描述:输入/输出控制器接口集成电路 Smart Card Interface IC RoHS:否 制造商:Silicon Labs 产品: 输入/输出端数量: 工作电源电压: 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:QFN-64 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。