参数资料
| 型号： | ADV7391BCPZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 66/108页 |
| 文件大小： | 0K |
| 描述： | IC ENCODER VIDEO W/DAC 32LFCSP |
| 产品变化通告： | ADV734x, ADV739x Feature Improvement |
| 标准包装： | 1 |
| 类型： | 视频编码器 |
| 应用： | 机顶盒，视频播放器，显示器 |
| 电压 - 电源，模拟： | 2.6 V ~ 3.46 V |
| 电压 - 电源，数字： | 1.71 V ~ 1.89 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 32-LFCSP-VQ（5x5） |
| 包装： | 托盘 |
| 配用： | EVAL-ADV7391EBZ-ND - BOARD EVAL FOR ADV7391 ENCODER |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页当前第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页
ADV7390/ADV7391/ADV7392/ADV7393
Data Sheet
Rev. G | Page 60 of 108
The gamma curves in Figure 71 and Figure 72 are examples only;
any user-defined curve in the range from 16 to 240 is acceptable.
Figure 71. Signal Input (Ramp) and Signal Output for Gamma 0.5
Figure 72. Signal Input (Ramp) and Selectable Output Curves
ED/HD SHARPNESS FILTER AND ADAPTIVE FILTER
CONTROLS
Subaddress 0x40; Subaddress 0x58 to Subaddress 0x5D
There are three filter modes available on the ADV739x:
sharpness filter mode and two adaptive filter modes.
ED/HD Sharpness Filter Mode
To enhance or attenuate the Y signal in the frequency ranges
shown in Figure 73, the ED/HD sharpness filter must be
enabled (Subaddress 0x31, Bit 7 = 1) and the ED/HD adaptive
filter must be disabled (Subaddress 0x35, Bit 7 = 0).
To select one of the 256 individual responses, the corresponding
gain values, ranging from 8 to +7 for each filter, must be
programmed into the ED/HD sharpness filter gain register at
Subaddress 0x40.
ED/HD Adaptive Filter Mode
In ED/HD adaptive filter mode, the following registers are used:
ED/HD Adaptive Filter Threshold A
ED/HD Adaptive Filter Threshold B
ED/HD Adaptive Filter Threshold C
ED/HD Adaptive Filter Gain 1
ED/HD Adaptive Filter Gain 2
ED/HD Adaptive Filter Gain 3
ED/HD sharpness filter gain
To activate the adaptive filter control, the ED/HD sharpness
filter and the ED/HD adaptive filter must be enabled
(Subaddress 0x31, Bit 7 = 1, and Subaddress 0x35, Bit 7 = 1,
respectively).
The derivative of the incoming signal is compared to the three
programmable threshold values: ED/HD adaptive filter
(Threshold A, Threshold B, and Threshold C ) registers
(Subaddress 0x5B, Subaddress 0x5C, and Subaddress 0x5D).
The recommended threshold range is 16 to 235, although any
value in the range of 0 to 255 can be used.
The edges can then be attenuated with the settings in the
ED/HD adaptive filter (Gain 1, Gain 2, and Gain 3) registers
(Subaddress 0x58, Subaddress 0x59 and Subaddress 0x5A), and
the ED/HD sharpness filter gain register (Subaddress 0x40).
There are two adaptive filter modes available. The mode is
selected using the ED/HD adaptive filter mode control
(Subaddress 0x35, Bit 6) as follows:
Mode A is used when the ED/HD adaptive filter mode
control is set to 0. In this case, Filter B (LPF) is used in the
adaptive filter block. In addition, only the programmed
values for Gain B in the ED/HD sharpness filter gain
register and ED/HD adaptive filter (Gain 1, Gain 2, and
Gain 3) registers are applied when needed. The Gain A
values are fixed and cannot be changed.
Mode B is used when ED/HD adaptive filter mode control is
set to 1. In this mode, a cascade of Filter A and Filter B is used.
Both settings for Gain A and Gain B in the ED/HD sharpness
filter gain register and ED/HD adaptive filter (Gain 1, Gain 2,
and Gain 3) registers become active when needed.
LOCATION
0
50
100
150
200
250
300
50
100
150
200
250
0.5
SIGNAL INPUT
G
AM
M
A
CO
RRE
CT
E
D
AM
P
L
IT
UDE
SIGNAL OUTPUT
GAMMA CORRECTION BLOCK OUTPUT TO A RAMP INPUT
06234-
072
LOCATION
0
50
100
150
200
250
300
50
100
150
200
250
G
AM
M
A
CO
RRE
CT
E
D
AM
P
L
IT
UDE
GAMMA CORRECTION BLOCK TO A RAMP INPUT FOR
VARIOUS GAMMA VALUES
0.3
0.5
1.5
1.8
SIGN
AL
INP
UT
06234-
073
相关PDF资料 |
PDF描述 |
|---|---|
| ADV7511KSTZ | IC XMITTER HDMI 12BIT 100LQFP |
| ADV7511WBSWZ | IC XMITTER HDMI AUTO 64LQFP |
| ADV7622BSTZ-RL | IC TXRX HDMI 4:1 144LQFP |
| ADV7623BSTZ | IC TXRX HDMI 4:1 144LQFP |
| ADW54010Z-0REEL | IC SWITCH DUAL SPDT 10MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADV7391BCPZ-REEL | 功能描述:IC VIDEO ENCODER SD/HD 32-LFCSP RoHS:是 类别:集成电路 (IC) >> 接口 - 编码器，解码器，转换器 系列:- 产品变化通告:Development Systems Discontinuation 26/Apr/2011 标准包装:1 系列:- 类型:编码器 应用:DVB-S.2 系统 电压 - 电源，模拟:- 电压 - 电源，数字:- 安装类型:- 封装/外壳:模块 供应商设备封装:模块 包装:散装 其它名称:Q4645799 |
| ADV7391EBZ | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Power, Chip Scale 10-Bit SD/HD Video Encoder |
| ADV7391WBCPZ | 制造商:Analog Devices 功能描述: |
| ADV7391WBCPZ-RL | 制造商:Analog Devices 功能描述: |
| ADV7392 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Power, Chip Scale 10-Bit SD/HD Video Encoder |
发布紧急采购，3分钟左右您将得到回复。