- 您现在的位置：买卖IC网 > PDF目录15160 > ISL6327IRZ-T (Intersil)IC REG CTRLR BUCK PWM 48-QFN PDF资料下载
参数资料
| 型号： | ISL6327IRZ-T |
| 厂商： | Intersil |
| 文件页数： | 11/29页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 48-QFN |
| 标准包装： | 4,000 |
| PWM 型： | 控制器 |
| 输出数： | 6 |
| 频率 - 最大： | 1MHz |
| 占空比： | 25% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
ISL6327
RMS input capacitor current. The single-phase converter
must use an input capacitor bank with twice the RMS current
capacity as the equivalent three-phase converter.
Figures 19, 20 and 21 in the section titled “Input Capacitor
Selection” on page 27 can be used to determine the input
capacitor RMS current based on the load current, the duty
cycle, and the number of channels. They are provided as
aids in determining the optimal input capacitor solution.
Figure 22 shows the single phase input-capacitor RMS
current for comparison.
Connecting the PWM4 to VCC selects 3-phase operation
and the pulse times are spaced in 1/3 cycle increments.
Connecting the PWM3 to VCC selects 2-phase operation
and the pulse times are spaced in 1/2 cycle increments.
Switching Frequency
The switching frequency is determined by the selection of
the frequency-setting resistor, R T , which is connected from
FS pin to GND (see the figures labelled Typical Applications
on page 4 and page 5). Equation 3 is provided to assist in
selecting the correct resistor value.
R T = -------------------------- – 600
PWM Modulation Scheme
The ISL6327 adopts Intersil's proprietary Active Pulse
Positioning (APP) modulation scheme to improve the
2.5X10
f SW
10
(EQ. 3)
transient performance. APP control is a unique dual-edge
PWM modulation scheme with both PWM leading and
trailing edges being independently moved to provide the
best response to the transient loads. The PWM frequency,
however, is constant and set by the external resistor
between the FS pin and GND.
To further improve the transient response, the ISL6327 also
implements Intersil's proprietary Adaptive Phase Alignment
(APA) technique. APA, with sufficiently large load step
currents, can turn on all phases together.
With both APP and APA control, ISL6327 can achieve
excellent transient performance and reduce the demand on
the output capacitors.
Under the steady state conditions the operation of the
ISL6327 PWM modulator appears to be that of a
conventional trailing edge modulator. Conventional analysis
and design methods can therefore be used for steady state
and small signal operation.
PWM Operation
The timing of each converter is set by the number of active
channels. The default channel setting for the ISL6327 is six.
The switching cycle is defined as the time between PWM
pulse termination signals of each channel. The cycle time of
where f SW is the switching frequency of each phase.
Current Sensing
ISL6327 senses the current continuously for fast response.
ISL6327 supports inductor DCR sensing, or resistive
sensing techniques. The associated channel current sense
amplifier uses the ISEN inputs to reproduce a signal
proportional to the inductor current, I L . The sensed current,
I SEN , is used for the current balance, the load-line
regulation, and the overcurrent protection.
The internal circuitry, shown in Figures 3 and 4, represents
one channel of an N-channel converter. This circuitry is
repeated for each channel in the converter, but may not be
active depending on the status of the PWM3, PWM4,
PWM5, and PWM6 pins, as described in “PWM Operation”
INDUCTOR DCR SENSING
An inductor ’s winding is characteristic of a distributed
resistance as measured by the DCR (Direct Current
Resistance) parameter. Consider the inductor DCR as a
separate lumped quantity, as shown in Figure 3. The
channel current I L , flowing through the inductor, will also
pass through the DCR. Equation 4 shows the S-domain
(equivalent voltage across the inductor V L ).
the pulse termination signal is the inverse of the switching
frequency set by the resistor between the FS pin and
V L = I L ? ( s ? L + DCR )
(EQ. 4)
ground. The PWM signals command the MOSFET drivers to
turn on/off the channel MOSFETs.
In the default 6-phase operation, the PWM2 pulse happens
1/6 of a cycle after PWM1, the PWM3 pulse happens 1/6 of
a cycle after PWM2, the PWM4 pulse happens 1/6 of a cycle
A simple RC network across the inductor extracts the DCR
voltage, as shown in Figure 3.
The voltage on the capacitor V C , can be shown to be
proportional to the channel current I L , see Equation 5.
? s ? ------------- + 1 ? ? ( DCR ? I )
V C = ---------------------------------------------------------------------
after PWM3, the PWM5 pulse happens 1/6 of a cycle after
PWM4, and the PWM6 pulse happens 1/6 of a cycle after
PWM5.
The ISL6327 works in 2, 3, 4, 5, or 6 phase configuration.
Connecting the PWM6 to VCC selects 5-phase operation
and the pulse times are spaced in 1/5 cycle increments.
Connecting the PWM5 to VCC selects 4-phase operation
and the pulse times are spaced in 1/4 cycle increments.
11
L
? DCR ? L
( s ? RC + 1 )
(EQ. 5)
FN9276.4
May 5, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| CAT1025ZI-45-GT3 | IC SUPERVISOR CPU 2K EEPR 8MSOP |
| ASM11DRYN | CONN EDGECARD 22POS DIP .156 SLD |
| ECM36DCSH-S288 | CONN EDGECARD 72POS .156 EXTEND |
| SLPX392M063A4P3 | CAP ALUM 3900UF 63V 20% SNAP |
| ASM11DRYH | CONN EDGECARD 22POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6328ACRZ | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:* 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6328ACRZ-T | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:* 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6328AIRZ | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:* 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6328AIRZ-T | 功能描述:IC VOLTAGE REGULATOR RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:* 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6328CRZ | 功能描述:IC CTRLR PWM SYNC BUCK DL 48QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:2,000 系列:- 应用:控制器，DSP 输入电压:4.5 V ~ 25 V 输出数:2 输出电压:最低可调至 1.2V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:30-TFSOP（0.173"，4.40mm 宽） 供应商设备封装:30-TSSOP 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。