- 您现在的位置：买卖IC网 > PDF目录15160 > ISL6551ABZ-T (Intersil)IC REG CTRLR FLYBACK PWM 28-SOIC PDF资料下载
参数资料
| 型号： | ISL6551ABZ-T |
| 厂商： | Intersil |
| 文件页数： | 10/26页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBACK PWM 28-SOIC |
| 标准包装： | 1,000 |
| PWM 型： | 电流模式 |
| 输出数： | 6 |
| 频率 - 最大： | 1MHz |
| 占空比： | 50% |
| 电源电压： | 10.8 V ~ 13.2 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 105°C |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 包装： | 带卷 (TR) |
ISL6551
Block/Pin Functional Descriptions
Detailed descriptions of each individual block in the functional
block diagram on page 3 are included in this section.
Application information and design considerations for each pin
and/or each block are also included.
? IC Bias Power (VDD, VDDP1, VDDP2)
- The IC is powered from a 12V ± 10% supply.
- VDD supplies power to both the digital and analog circuits
and should be bypassed directly to the VSS pin with an
0.1 μ F low ESR ceramic capacitor.
- VDDP1 and VDDP2 are the bias supplies for the upper
drivers and the lower drivers, respectively. They should be
decoupled with ceramic capacitors to the PGND pin.
- Heavy copper should be attached to these pins for a better
heat spreading.
? IC GNDs (VSS, PGND)
- VSS is the reference ground, the return of VDD, of all
control circuits and must be kept away from nodes with
switching noises. It should be connected to the PGND in
only one location as close to the IC as practical. For a
secondary side control system, it should be connected to
the net after the output capacitors, i.e., the output return
pinout(s). For a primary side control system, it should be
connected to the net before the input capacitors, i.e., the
input return pinout(s).
- PGND is the power return, the high-current return path of
both VDDP1 and VDDP2. It should be connected to the
SOURCE pins of two lower power switches or the
? Undervoltage Lockout (UVLO)
- UVLO establishes an orderly start-up and verifies that VDD
is above the turn-on threshold voltage (VDD ON ). All the
drivers are held low during the lockout. UVLO incorporates
hysteresis VDD HYS to prevent multiple startup/shutdowns
while powering up.
- UVLO limits are not applicable to VDDP1 and VDDP2.
? Bandgap Reference (BGREF)
- The reference voltage VREF is generated by a precision
bandgap circuit.
- This pin must be pulled up to VDD with a resistance of
approximately 399k ? for proper operation. For additional
reference loads (no more than 1mA), this pull-up resistor
should be scaled accordingly.
- This pin must also be decoupled with an 0.1 μ F low ESR
ceramic capacitor.
? Clock Generator (CT, RD)
- This free-running oscillator is set by two external
components as shown in Figure 1. A capacitor at CT is
charged and discharged with two equal constant current
sources and fed into a window comparator to set the clock
frequency. A resistor at RD sets the clock dead time. RD
and CT should be tied to the VSS pin on their other ends
as close as possible. The corresponding CT for a particular
frequency can be selected from Figure 2.
- The switching frequency (Fsw) of the power train is half of
the clock frequency (Fclock), as shown in Equation 1.
Fsw = -------------------
RETURNs of external drivers as close as possible with
heavy copper traces.
- Copper planes should be attached to both pins.
RD
SET CLOCK
DEAD TIME (DT)
RD
VDD-
Fclock
2
(EQ. 1)
I_CT
VMAX
-
OUT
CLK
+
CT
CT
VMIN
- OUT
+
S
R
Q
Q
Q
Q
I_CT
10
CLK
FIGURE 1. SIMPLIFIED CLOCK GENERATOR CIRCUIT
DT
DT
FN9066.5
January 3, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| ISL88001IE16Z-T7A | IC VOLT SUPERVISOR 1.58V SC70-3 |
| GEM12DTBD-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| GEM12DTAN-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| GEM12DTAD-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| ISL6326CRZ | IC REG CTRLR BUCK PWM VM 40-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6551AR | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL6551AR-T | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL6551ARZ | 功能描述:IC REG CTRLR FLYBACK PWM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6551ARZ-T | 功能描述:IC REG CTRLR FLYBACK PWM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6551EVAL1 | 功能描述:EVALUATION BOARD ISL6551 RoHS:否 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:True Shutdown™ 主要目的:DC/DC，步升 输出及类型:1，非隔离 功率 - 输出:- 输出电压:- 电流 - 输出:1A 输入电压:2.5 V ~ 5.5 V 稳压器拓扑结构:升压 频率 - 开关:3MHz 板类型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
发布紧急采购，3分钟左右您将得到回复。