- 您现在的位置：买卖IC网 > PDF目录15160 > ISL6551ABZ-T (Intersil)IC REG CTRLR FLYBACK PWM 28-SOIC PDF资料下载
参数资料
| 型号： | ISL6551ABZ-T |
| 厂商： | Intersil |
| 文件页数： | 11/26页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBACK PWM 28-SOIC |
| 标准包装： | 1,000 |
| PWM 型： | 电流模式 |
| 输出数： | 6 |
| 频率 - 最大： | 1MHz |
| 占空比： | 50% |
| 电源电压： | 10.8 V ~ 13.2 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 105°C |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 包装： | 带卷 (TR) |
ISL6551
3,000
2
2,500
0 °C
60 °C
120 °C
1.6
1.2
2,000
0.8
1,500
0.4
1,000
0
0
20
40
60
80
100
120
140
160
500
0
RD (k ? )
FIGURE 3. RD vs DEAD TIME (VDD = 12V)
10
100
CT (pF)
1,000
10,000
RECOMMENDED RANGE
FIGURE 2. CT vs FREQUENCY
- Note that the capacitance of a scope probe (~12pF for
single ended) would induce a smaller frequency at the
CT pin. It can be easily seen at a higher frequency. An
accurate operating frequency can be measured at the
outputs of the bridge/synchronous drivers.
- The dead time is the delay to turn on the upper FET
(UPPER1/UPPER2) after its corresponding lower FET
(LOWER1/LOWER2) is turned off when the bridge is
operating at maximum duty cycle in normal conditions,
or is responding to load transients or input line dipping
conditions. This helps to prevent shoot through between
the upper FET and the lower FET that are located at the
same side of the bridge. The dead time can be
estimated using Equation 2:
? Error Amplifier (EAI, EANI, EAO)
- This amplifier compares the feedback signal received at
the EAI pin to a reference signal set at the EANI pin and
provides an error signal (EAO) to the PWM Logic. The
feedback loop compensation can be programmed via
these pins.
- Both EANI and EAO are clamped by the voltage
(Vclamp) set at the CSS pin, as shown in Figure 4. Note
that the diodes in the functional block diagram represent
the clamp function of the CSS in a simplified way.
? Soft-Start (CSS)
- The voltage on an external capacitor charged by an
internal current source I SS is fed into a control pin on
the error amplifier. This causes the Error Amplifier to: 1)
limit the EAO to the soft-start voltage level; and 2) over-
ride the reference signal at the EANI with the soft-start
voltage, when the EANI voltage is higher than the soft-
start voltage. Thus, both the output voltage and current
M × RD
k ?
DT = --------------------
(ns)
(EQ. 2)
of the power supply can be controlled by the soft-start.
- The clamping voltage determines the cycle-by-cycle
where M=11.4(VDD=12V), 11.1(VDD=14V), and
12(VDD=10V), and RD is in k ? . This relationship is
shown in Figure 3.
peak current limiting of the power supply. It should be
set above the EANI and EAO voltages and can be
programmed by an external resistor as shown in
Figure 4 using Equation 3.
Vclamp = Rcss ? Iss
(V)
(EQ. 3)
400mV
+
-
(See Fig. 9)
SSL
(TO
VDD
BLANKING
CIRCUIT)
EAI
(–)
CSS
Iss
EANI
(+)
R CSS
SHUTDOWN
11
ERROR AMP
FIGURE 4. SIMPLIFIED CLAMP/SOFT-START
EAO
FN9066.5
January 3, 2006
相关PDF资料 |
PDF描述 |
|---|---|
| ISL88001IE16Z-T7A | IC VOLT SUPERVISOR 1.58V SC70-3 |
| GEM12DTBD-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| GEM12DTAN-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| GEM12DTAD-S273 | CONN EDGECARD 24POS R/A .156 SLD |
| ISL6326CRZ | IC REG CTRLR BUCK PWM VM 40-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6551AR | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL6551AR-T | 制造商:Rochester Electronics LLC 功能描述: 制造商:Intersil Corporation 功能描述: |
| ISL6551ARZ | 功能描述:IC REG CTRLR FLYBACK PWM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6551ARZ-T | 功能描述:IC REG CTRLR FLYBACK PWM 28-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6551EVAL1 | 功能描述:EVALUATION BOARD ISL6551 RoHS:否 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:True Shutdown™ 主要目的:DC/DC，步升 输出及类型:1，非隔离 功率 - 输出:- 输出电压:- 电流 - 输出:1A 输入电压:2.5 V ~ 5.5 V 稳压器拓扑结构:升压 频率 - 开关:3MHz 板类型:完全填充 已供物品:板 已用 IC / 零件:MAX8969 |
发布紧急采购，3分钟左右您将得到回复。