参数资料
型号: ISL8120EVAL3Z
厂商: Intersil
文件页数: 1/35页
文件大小: 0K
描述: EVALUATION BOARD FOR ISL8120
标准包装: 1
主要目的: DC/DC,步降
输出及类型: 2,非隔离
输出电压: 1.2V,1.2V
电流 - 输出: 2 x 25A 或 1 x 50A
输入电压: 3 ~ 22 V
稳压器拓扑结构: 降压
频率 - 开关: 150kHz ~ 1.5MHz
板类型: 完全填充
已供物品:
已用 IC / 零件: ISL8120
?
ISL8120
Data Sheet
April 7, 2009
FN6641.1
Dual/n-Phase Buck PWM Controller with
Integrated Drivers
The ISL8120 integrates two voltage-mode synchronous
buck PWM controllers to control a dual independent voltage
regulator or a 2-phase single output regulator. It has PLL
circuits and can output a phase-shift-programmable clock
signal for the system to be expanded to 3-, 4-, 6-, 12- phases
with desired interleaving phase shift. It also integrates
current sharing control for the power module to operate in
parallel, which offers high system flexibility.
It has voltage feed forward compensation to maintain a
constant loop gain for optimal transient response, especially
for applications with a wide input voltage range. Its
integrated high speed MOSFET drivers and multi-feature
functions provide complete control and protection for a
2/n-phase synchronous buck converter, dual independent
regulators, or DDR tracking applications (VDDQ and VTT
outputs).
The output voltage of a ISL8120-based converter can be
precisely regulated to as low as the internal reference
voltage 0.6V, with a system accuracy of ±0.6% over
commercial temperature and line load variations. Channel 2
can track an external ramp signal for DDR/tracking
applications.
The ISL8120 integrates an internal linear regulator, which
generates VCC from input rail for applications with only one
single supply rail. The internal oscillator is adjustable from
150kHz to 1.5MHz, and is able to track an external clock
signal for frequency synchronization and phase paralleling
applications. The integrated Pre-Biased Digital Soft-Start,
Differential Remote Sensing Amplifier, and Programmable
Input Voltage POR features enhance the value of ISL8120.
The ISL8120 protects against overcurrent conditions by
inhibiting the PWM operation while monitoring the current
with r DS(ON) of the lower MOSFET, DCR of the output
inductor, or a precision resistor. It also has a PRE-POR
Overvoltage Protection option, which provides some
protection to the load device if the upper MOSFET(s) is
OVP) on page 25 for details.
The ISL8120’s Fault Hand Shake feature protects any
channel from overloading/stressing due to system faults or
phase failure. The undervoltage fault protection features are
also designed to prevent a negative transient on the output
voltage during falling down. This eliminates the Schottky
diode that is used in some systems for protecting the load
device from reversed output voltage damage.
Features
? Wide VIN Range Operation: 3V to 22V
- VCC Operation from 3V to 5.60V
? Fast Transient Response
- 80MHz Bandwidth Error Amplifier
- Voltage-Mode PWM Leading-edge Modulation Control
- Voltage Feed-forward
? Dual Channel 5V High Speed 4A MOSFET Gate Drivers
- Internal Bootstrap Diodes
? Internal Linear Regulator Provides a 5.4V Bias from VIN
? External Soft-Start Ramp Reference Input for
DDR/Tracking Applications
? Excellent Output Voltage Regulation
- 0.6V ±0.6%/±0.9% Internal Reference Over
Commercial/Industrial Temperature
- True Differential Remote Voltage Sensing
? Oscillator Programmable from 150kHz to 1.5MHz
? Frequency Synchronization
? Scale for 1-, 2-, 3-, 4-, 6-, up to 12- Phase with Single
Output
- Excellent Phase Current Balancing
- Programmable Phase Shift Between the 2 Phases
Controlled by the ISL8120 and Programmable Phase
Shift for Clockout Signal
- Interleaving Operation Results in Minimum Input RMS
Current and Minimum Output Ripple Current
? Fault Hand Shake Capability for High System Reliability
? Overcurrent Protection
- DCR, r DS(ON) , or Precision Resistor Current Sensing
- Independent and Average Phase Current OCP
? Output Overvoltage and Undervoltage Protections
? Programmable Phase Shift in Dual Mode Operation
? Digital Soft-Start with Pre-Charged Output Start-up
Capability
? Power-Good Indication
? Dual Independent Channel Enable Inputs with Precision
Voltage Monitor and Voltage Feed-forward Capability
- Programmable Input Voltage POR and its Hysteresis
with a Resistor Divider at EN Input
? Over-Temperature Protection
? Pre-Power-On-Reset Overvoltage Protection Option
? 32 Ld 5x5 QFN Package - Near Chip-Scale Footprint
- Enhanced Thermal Performance for MHz Applications
? Pb-free (RoHS compliant)
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2008, 2009. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
相关PDF资料
PDF描述
ISL6455AEVAL1Z EVALUATION BOARD FOR ISL6455A
ISL6455EVAL1Z EVALUATION BOARD FOR ISL6455
GBC13DCAH CONN EDGECARD 26POS R/A .100 SLD
GBC13DCAD CONN EDGECARD 26POS R/A .100 SLD
EEC20DRYS CONN EDGECARD 40POS DIP .100 SLD
相关代理商/技术参数
参数描述
ISL8120EVAL4Z 功能描述:BOARD EVALUATION FOR ISL8120 RoHS:是 类别:编程器,开发系统 >> 评估板 - DC/DC 与 AC/DC(离线)SMPS 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:True Shutdown™ 主要目的:DC/DC,步升 输出及类型:1,非隔离 功率 - 输出:- 输出电压:- 电流 - 输出:1A 输入电压:2.5 V ~ 5.5 V 稳压器拓扑结构:升压 频率 - 开关:3MHz 板类型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
ISL8120IRZ 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL8120IRZEC 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL8120IRZ-T 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)
ISL8120IRZ-TEC 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC(0.154",3.90mm 宽) 包装:带卷 (TR)