参数资料
| 型号： | KSZ8842-16MBLI TR |
| 厂商： | Micrel Inc |
| 文件页数： | 47/141页 |
| 文件大小： | 0K |
| 描述： | IC ETHERNET SW 2PORT 100LFBGA |
| 标准包装： | 1,000 |
| 控制器类型： | 以太网开关控制器 |
| 接口： | PCI |
| 电源电压： | 3.1 V ~ 3.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 100-LBGA |
| 供应商设备封装： | 100-LFBGA |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页当前第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页第139页第140页第141页
Micrel, Inc.
KSZ8842-16/32 MQL/MVL/MVLI/MBL
October 2007
140
M9999-102207-1.9
MDI
Medium Dependent Interface
An Ethernet port connection that allows network hubs or switches to
connect to other hubs or switches without a null-modem, or crossover,
cable. MDI provides the standard interface to a particular media (copper
or fiber) and is therefore 'media dependent.'
MDI-X Medium Dependent Interface Crossover
An Ethernet port connection that allows networked end stations (i.e.,
PCs or workstations) to connect to each other using a null-modem, or
crossover, cable. For 10/100 full-duplex networks, an end point (such as
a computer) and a switch are wired so that each transmitter connects to
the far end receiver. When connecting two computers together, a cable
that crosses the TX and RX is required to do this. With auto MDI-X, the
PHY senses the correct TX and RX roles, eliminating any cable
confusion.
MIB
Management Information Base
The MIB comprises the management portion of network devices. This
can include things like monitoring traffic levels and faults (statistical),
and can also change operating parameters in network nodes (static
forwarding addresses).
MII
Media Independent Interface
The MII accesses PHY registers as defined in the IEEE 802.3
specification.
NIC
Network Interface Card
An expansion board inserted into a computer to allow it to be connected
to a network. Most NICs are designed for a particular type of network,
protocol, and media, although some can serve multiple networks.
NPVID Non Port VLAN ID
The Port VLAN ID value is used as a VLAN reference.
PLL
Phase-Locked Loop
An electronic circuit that controls an oscillator so that it maintains a
constant phase angle (i.e., lock) on the frequency of an input, or
reference, signal. A PLL ensures that a communication signal is locked
on a specific frequency and can also be used to generate, modulate,
and demodulate a signal and divide a frequency.
PME Power Management Event
An occurrence that affects the directing of power to different
components of a system.
QMU Queue Management Unit
Manages packet traffic between MAC/PHY interface and the system
host. The QMU has built-in packet memories for receive and transmit
functions called TXQ (Transmit Queue) and RXQ (Receive Queue).
SA
Source Address
The address from which information has been sent.
TDR
Time Domain Reflectometry
TDR is used to pinpoint flaws and problems in underground and aerial
wire, cabling, and fiber optics. They send a signal down the conductor
and measure the time it takes for the signal -- or part of the signal -- to
return.
UTP
Unshielded Twisted Pair
Commonly a cable containing 4 twisted pairs of wires. The wires are
twisted in such a manner as to cancel electrical interference generated
in each wire, therefore shielding is not required.
VLAN Virtual Local Area Network
A configuration of computers that acts as if all computers are connected
by the same physical network but which may be located virtually
anywhere.
相关PDF资料 |
PDF描述 |
|---|---|
| KSZ8842-32MVLI | IC SWITCH ETH 2P 32BIT 128LQFP |
| KSZ8842-PMBL AM TR | IC ETHERNET SW 2PORT 100LFBGA |
| KSZ8842-PMQLI | IC ETHERNET SW 2PORT PCI 128PQFP |
| KSZ8851-16MLLI TR | IC MAC CTLR 1PORT W/BUS 48LQFP |
| KSZ8851-16MLLJ | IC CTLR MAC 1PORT NON-PCI 48LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8842-16MQL | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8842-16MQL-EVAL | 功能描述:以太网开发工具 KSZ8842-16MQL Evaluation Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8842-16MVL | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8842-16MVL TR | 功能描述:以太网 IC 2-Port Ethernet Switch/Repeater + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8842-16MVL-EVAL | 功能描述:BOARD EVALUATION KSZ8842-16MVL RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- 主要目的:电源管理，电池充电器 嵌入式:否 已用 IC / 零件:MAX8903A 主要属性:1 芯锂离子电池 次要属性:状态 LED 已供物品:板 |
发布紧急采购，3分钟左右您将得到回复。