参数资料
型号: L6919ETR
厂商: STMICROELECTRONICS
元件分类: 稳压器
英文描述: SWITCHING CONTROLLER, PDSO28
封装: SO-28
文件页数: 4/33页
文件大小: 644K
代理商: L6919ETR
Obsolete
Product(s)
- Obsolete
Product(s)
L6919E
12/33
1. TON Limited Output Voltage.
This happens when the maximum ON time is reached before the current in each phase reaches IOCPx (IINFOx
< 35
A).
Figure 5a shows the maximum output voltage that the device is able to regulate considering the TON limitation
imposed by the previous relationship. If the desired output characteristic crosses the TON limited maximum output
voltage, the output resulting voltage will start to drop after crossing. In this case, the device doesn't perform con-
stant current limitation but only limits the maximum ON time following the previous relationship. The output volt-
age follows the resulting characteristic (dotted in Figure 5b) until UVP is detected or anyway until IFB = 70A.
Figure 5. TON Limited Operation
2. Constant Current Operation
This happens when ON time limitation is reached after the current in each phase reaches IOCPx (IINFOx>35A).
The device enters in Quasi-Constant-Current operation: the low-side mosfets stays ON until the current read
becomes lower than IOCPx (IINFOx < 35A) skipping clock cycles. The high side mosfets can be turned ON with
a TON imposed by the control loop at the next available clock cycle and the device works in the usual way until
another OCP event is detected.
This means that the average current delivered can slightly increase also in Over Current condition since the cur-
rent ripple increases. In fact, the ON time increases due to the OFF time rise because of the current has to reach
the IOCPx bottom. The worst-case condition is when the ON time reaches its maximum value.
When this happens, the device works in Constant Current and the output voltage decrease as the load increase.
Crossing the UVP threshold causes the device to latch (FAULT pin is driven high).
Figure 6 shows this working condition
It can be observed that the peak current (Ipeak) is greater than the IOCPx but it can be determined as follow:
Where VoutMIN is the minimum output voltage (VID-30% as follow).
The device works in Constant-Current, and the output voltage decreases as the load increase, until the output
voltage reaches the Under-Voltage threshold (VoutMIN). When this threshold is crossed, all mosfets are turned
off, the FAULT pin is driven high and the device stops working. Cycle the power supply to restart operation. The
maximum average current during the Constant-Current behavior results:
a) Maximum output Voltage
b) TON Limited Output Voltage
0.80VIN
0.40VIN
VOUT
I
OUT
IOCP=2IOCPx
(I
FB=70A)
TON Limited Output
characteristic
0.80VIN
0.40VIN
VOUT
IOUT
IOCP=2IOCPx
(IFB=70A)
Desired Output
characteristic and
UVP threshold
Resulting Output
characteristic
Ipea k
I
OCPx
V
IN
Vo ut
MIN
L
--------------------------------------- Ton
MAX
+
I
OCPx
V
IN
Vo ut
MIN
L
--------------------------------------- 0.40 T
+
==
I
M AX,TOT
2I
MA X
2I
OCPx
Ipe ak
I
OC P x
2
--------------------------------------
+
+
=
相关PDF资料
PDF描述
LUW025F8 1-OUTPUT 16.5 W DC-DC REG PWR SUPPLY MODULE
L5973ADTR 2.3 A SWITCHING REGULATOR, PDSO8
LSN-1.8/10-D12BH DC-DC REG PWR SUPPLY MODULE
LM2575-33IN 4 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PDIP16
LM2575IKTT 4 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PSSO5
相关代理商/技术参数
参数描述
L-692 制造商:RHOMBUS-IND 制造商全称:Rhombus Industries Inc. 功能描述:Common Mode Inductor
L6920 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:1V HIGH EFFICIENCY SYNCRONOUS STEP UP CONVERTER
L6920D 功能描述:直流/直流开关转换器 0.6 to 5.5V Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
L6920DB 功能描述:直流/直流开关转换器 Synchronous Rectifer Step Up Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
L6920DBTR 功能描述:直流/直流开关转换器 SYNCRONOUS RECT. STEP UP CONVERTER RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT