- 您现在的位置：买卖IC网 > PDF目录79959 > L6919ETR (STMICROELECTRONICS) SWITCHING CONTROLLER, PDSO28 PDF资料下载
参数资料
| 型号： | L6919ETR |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING CONTROLLER, PDSO28 |
| 封装： | SO-28 |
| 文件页数： | 7/33页 |
| 文件大小： | 644K |
| 代理商： | L6919ETR |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页
Obsolete
Product(s)
- Obsolete
Product(s)
15/33
L6919E
Figure 9. - Remote Buffer Connections
OUTPUT VOLTAGE MONITOR AND PROTECTIONS
The device monitors through pin VSEN the regulated voltage in order to build the PGOOD signal and manage
the OVP / UVP conditions.
Power good output is forced low if the voltage sensed by VSEN is not within ±12% (Typ.) of the programmed
value. It is an open drain output and it is enabled only after the soft start is finished (2048 clock cycles after start-
up). During Soft-Start this pin is forced low.
Under voltage protection is provided. If the output voltage monitored by VSEN drops below the 60% of the ref-
erence voltage for more than one clock period, the device turns off all mosfets and the OSC/FAULT is driven
high (5V). The condition is latched, to recover it is required to cycle the power supply.
Over Voltage protection is also provided: when the voltage monitored by VSEN reaches the OVP threshold
VOVP the controller permanently switches on both the low-side mosfets and switches off both the high-side
mosfets in order to protect the load. The OSC/ FAULT pin is driven high (5V) and power supply (Vcc) turn off
and on is required to restart operations.
The over voltage percentage is then set by the ratio between the fixed OVP threshold VOVP and the reference
programmed by VID:
Both Over Voltage and Under Voltage are active also during soft start (Under Voltage after than the output volt-
age reaches 0.6V). The reference used in this case to determine the UV thresholds is the increasing voltage
driven by the 2048 soft start digital counter while the reference used for the OV threshold is the final reference
programmed by the VID pins.
SOFT START AND INHIBIT
At start-up a ramp is generated increasing the loop reference from 0V to the final value programmed by VID in
2048 clock periods as shown in figure 10.
Once the soft start begins, the reference is increased: upper and lower MOS begin to switch and the output volt-
age starts to increase with closed loop regulation. At the end of the digital soft start, the Power Good comparator
is enabled and the PGOOD signal is then driven high (See fig. 10). The Under Voltage comparator is enabled
when the reference voltage reaches 0.6V. The Soft-Start will not take place, if both VCC and VCCDR pins are
not above their own turn-on thresholds.
During normal operation, if any under-voltage is detected on one of the two supplies the device shuts down.
Forcing the OSC/INH pin to a voltage lower than 0.6V (Typ.) disables the device: all the power mosfets and
protections are turned off until the condition is removed.
Reference
IFB
REMOTE
BUFFER
ERROR
AMPLIFIER
FB
COMP
VSEN
FBG
FBR
Remote
Ground
Remote
VOUT
RF
CF
RFB
64k
Reference
IFB
REMOTE
BUFFER
ERROR
AMPLIFIER
FB
COMP
VSEN
FBG
FBR
RF
CF
RFB
64k
VOUT
RB used (±0.5% Accuracy)
RB Not Used
OVP %
[]
V
OVP
Re feren ceVo ltage VID
()
----------------------------------------------------------------------- 100
=
相关PDF资料 |
PDF描述 |
|---|---|
| LUW025F8 | 1-OUTPUT 16.5 W DC-DC REG PWR SUPPLY MODULE |
| L5973ADTR | 2.3 A SWITCHING REGULATOR, PDSO8 |
| LSN-1.8/10-D12BH | DC-DC REG PWR SUPPLY MODULE |
| LM2575-33IN | 4 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PDIP16 |
| LM2575IKTT | 4 A SWITCHING REGULATOR, 63 kHz SWITCHING FREQ-MAX, PSSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| L-692 | 制造商:RHOMBUS-IND 制造商全称:Rhombus Industries Inc. 功能描述:Common Mode Inductor |
| L6920 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:1V HIGH EFFICIENCY SYNCRONOUS STEP UP CONVERTER |
| L6920D | 功能描述:直流/直流开关转换器 0.6 to 5.5V Step-Up RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| L6920DB | 功能描述:直流/直流开关转换器 Synchronous Rectifer Step Up Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
| L6920DBTR | 功能描述:直流/直流开关转换器 SYNCRONOUS RECT. STEP UP CONVERTER RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。