参数资料
| 型号： | LT1977IFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 12/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 1.5A 16TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 54 V |
| 输入电压： | 3.3 V ~ 60 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 500kHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 16-TSSOP-EP |
LT1977
APPLICATIO S I FOR ATIO
triangular with a typical value of 200mA RMS . The formula
to calculate this is:
Output capacitor ripple current (RMS)
V OUT
10mV/DIV
100 μ F
75m ?
TANTALUM
= P-P
I RIPPLE ( RMS ) =
0. 29 ( V OUT )( V IN – V OUT )
( L )( f )( V IN )
I
12
V OUT
10mV/DIV
100 μ F
CERAMIC
CERAMIC CAPACITORS
V SW
Higher value, lower cost ceramic capacitors are now
becoming available. They are generally chosen for their
10V/DIV
V IN = 12V
V OUT = 3.3V
500ns/DIV
1977 F03
good high frequency operation, small size and very low
ESR (effective series resistance). Low ESR reduces output
ripple voltage but also removes a useful zero in the loop
frequency response, common to tantalum capacitors. To
compensate for this a resistor R C can be placed in series
with the V C compensation capacitor C C (Figure 10). Care
must be taken however since this resistor sets the high
frequency gain of the error amplifier including the gain at
I L = 1A
Figure 3. LT1977 Ripple Voltage Waveform
Peak-to-peak output ripple voltage is the sum of a triwave
created by peak-to-peak ripple current times ESR and a
square wave created by parasitic inductance (ESL) and
ripple current slew rate. Capacitive reactance is assumed
to be small compared to ESR or ESL.
the switching frequency. If the gain of the error amplifier
is high enough at the switching frequency output ripple
voltage (although smaller for a ceramic output capacitor)
V RIPPLE = ( I P-P )( ESR ) + ( ESL )
di
dt
( 3 . 3 )( 12 – 3 . 3 )
( 12 ) ( 15 e ? 6 )( 500 e 3 )
= = 0 . 8 e 6
V OUT ( V IN – V OUT )
( V IN )( )( ) f
may still affect the proper operation of the regulator. A
filter capacitor C F in parallel with the R C /C C network, along
with a small feedforward capacitor C FB , is suggested to
control possible ripple at the V C pin. The LT1977 can be
stabilized using a 100 μ F ceramic output capacitor and V C
component values of C C = 1500pF, R C = 10k, C F = 330pF
and C FB = 10pF.
OUTPUT RIPPLE VOLTAGE
Figure 3 shows a typical output ripple voltage waveform
for the LT1977. Ripple voltage is determined by the
impedance of the output capacitor and ripple current
through the inductor. Peak-to-peak ripple current through
the inductor into the output capacitor is:
I P-P =
L
For high frequency switchers the ripple current slew rate
is also relevant and can be calculated from:
Example: with V IN = 12V, V OUT = 3.3V, L = 15 μ H, ESR =
0.08 ? , ESL = 10nH:
I P-P = = 0 . 319 A
di 12
dt 15 e – 6
V RIPPLE = (0.319A)(0.08) + (10e – 9)(0.8e6)
= 0.026 + 0.008 = 34mV P-P
MAXIMUM OUTPUT LOAD CURRENT
Maximum load current for a buck converter is limited by
the maximum switch current rating (I PK ). The minimum
specified current rating for the LT1977 is 1.5A. Unlike
most current mode converters, the LT1977 maximum
switch current limit does not fall off at high duty cycles.
Most current mode converters suffer a drop off of peak
switch current for duty cycles above 50%. This is due to
= IN
di
dt
V
L
the effects of slope compensation required to prevent
subharmonic oscillations in current mode converters.
(For detailed analysis, see Application Note 19.)
1977fa
12
相关PDF资料 |
PDF描述 |
|---|---|
| LT3008EDC-1.2#TRMPBF | IC REG LDO 1.2V 20MA 6-DFN |
| LT3009ESC8-1.5#TRMPBF | IC REG LDO 1.5V 20MA SC70-8 |
| LT3010MPMS8E-5#TRPBF | IC REG LDO 5V 50MA 8-MSOP |
| LT3011HMSE#TRPBF | IC REG LDO ADJ 50MA 12-MSOP |
| LT3012HFE#TRPBF | IC REG LDO ADJ .2A 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT1990 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Precision, 100μA Gain Selectable Amplifier |
| LT1990ACS8 | 功能描述:IC AMP DIFF +/-250V MCRPWR 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:2pA 电压 - 输入偏移:1000µV 电流 - 电源:85µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):1.8 V ~ 6 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 产品目录页面:680 (CN2011-ZH PDF) 其它名称:MCP6L04T-E/SLCT |
| LT1990ACS8#PBF | 功能描述:IC AMP DIFF +/-250V MCRPWR 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 产品培训模块:Differential Circuit Design Techniques for Communication Applications 标准包装:1 系列:- 放大器类型:RF/IF 差分 电路数:1 输出类型:差分 转换速率:9800 V/µs 增益带宽积:- -3db带宽:2.9GHz 电流 - 输入偏压:3µA 电压 - 输入偏移:- 电流 - 电源:40mA 电流 - 输出 / 通道:- 电压 - 电源，单路/双路(±):3 V ~ 3.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-VQFN 裸露焊盘，CSP 供应商设备封装:16-LFCSP-VQ 包装:剪切带 (CT) 产品目录页面:551 (CN2011-ZH PDF) 其它名称:ADL5561ACPZ-R7CT |
| LT1990ACS8#TR | 功能描述:IC AMP DIFF +/-250V MCRPWR 8SOIC RoHS:否 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:2pA 电压 - 输入偏移:1000µV 电流 - 电源:85µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):1.8 V ~ 6 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 产品目录页面:680 (CN2011-ZH PDF) 其它名称:MCP6L04T-E/SLCT |
| LT1990ACS8#TRPBF | 功能描述:IC AMP DIFF +/-250V MCRPWR 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:1 系列:- 放大器类型:通用 电路数:4 输出类型:满摆幅 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:2pA 电压 - 输入偏移:1000µV 电流 - 电源:85µA 电流 - 输出 / 通道:20mA 电压 - 电源，单路/双路(±):1.8 V ~ 6 V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:14-SOIC（0.154"，3.90mm 宽） 供应商设备封装:14-SOICN 包装:剪切带 (CT) 产品目录页面:680 (CN2011-ZH PDF) 其它名称:MCP6L04T-E/SLCT |
发布紧急采购，3分钟左右您将得到回复。