参数资料
型号: LT3437EFE#PBF
厂商: Linear Technology
文件页数: 8/28页
文件大小: 0K
描述: IC REG BUCK ADJ 0.5A 16TSSOP
标准包装: 95
类型: 降压(降压)
输出类型: 可调式
输出数: 1
输出电压: 1.25 V ~ 54 V
输入电压: 3.3 V ~ 60 V
PWM 型: 电流模式,混合
频率 - 开关: 200kHz
电流 - 输出: 500mA
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 16-TSSOP(0.173",4.40mm)裸露焊盘
包装: 管件
供应商设备封装: 16-TSSOP-EP
LT3437
PI FU CTIO S
(DD/FE)
SW (Pin 1/Pin 2): The SW pin is the emitter of the on-chip
power NPN switch. This pin is driven up to the input pin
voltage during switch on time. Inductor current drives the
SW pin negative during switch off time. Negative voltage
is clamped with an external schottky catch diode to pre-
vent excessive negative voltages.
NC (Pins 1, 3, 5, 7, 13, 16)(FE Package ONLY):
No Connection. The NC pins are electrically isolated from
the LT3437. The NC pins may be connected to PCB traces
to aid PCB layout.
V IN (Pin 2/Pin 4): This is the collector of the on-chip power
NPN switch. V IN powers the internal control circuitry when
a voltage on the BIAS pin is not present. High di/dt edges
occur on this pin during switch turn on and off. Keep the
path short from the V IN pin through the input bypass
capacitor, through the catch diode back to SW. All trace
inductance on this path will create a voltage spike at switch
off, adding to the V CE voltage across the internal NPN.
BOOST (Pin 3/Pin 6): The BOOST pin is used to provide a
drive voltage, higher than the input voltage, to the internal
bipolar NPN power switch. Without this added voltage, the
typical switch voltage loss would be about 1.5V. The
additional BOOST voltage allows the switch to saturate
and its voltage loss approximates that of a 0.8 ? FET
structure.
GND (Pins 4, 11/Pins 8, 17): The GND pin connection
acts as the reference for the regulated output, so load
regulation will suffer if the “ground” end of the load is not
at the same voltage as the GND pin of the IC. This
condition will occur when load current or other currents
flow through metal paths between the GND pin and the
load ground. Keep the path between the GND pin and the
load ground short and use a ground plane when possible.
The GND pin also acts as a heat sink and should be
soldered (along with the exposed leadframe) to the cop-
per ground plane to reduce thermal resistance (see Appli-
cations Information).
C SS (Pin 5/Pin 9): A capacitor from the C SS pin to the
regulated output voltage determines the output voltage
ramp rate during start-up. When the current through the
C SS capacitor exceeds the C SS threshold (I CSS ), the volt-
age ramp of the output is limited. The C SS threshold is
proportional to the FB voltage (see Typical Performance
Characteristics) and is defeated for FB voltage greater than
0.9V (typical). See Soft-Start section in Applications Infor-
mation for details.
3437fc
8
相关PDF资料
PDF描述
RBC19DREN-S734 CONN EDGECARD 38POS .100 EYELET
ISC1812ER681J INDUCTOR WW 680UH 5% 1812
PM2120-221K INDUCTOR TOROID 220UH 10% SMD
ISC1812ER471J INDUCTOR WW 470UH 5% 1812
LTC1751EMS8#PBF IC REG SWITCHD CAP DBL ADJ 8MSOP
相关代理商/技术参数
参数描述
LT3437HFE 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage 500mA, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current
LT3437HFE#PBF 功能描述:IC REG BUCK ADJ 0.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2
LT3437HFE#TRPBF 功能描述:IC REG BUCK ADJ 0.5A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:2,500 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V,1.5V,1.8V,2.5V 输入电压:2.7 V ~ 20 V PWM 型:- 频率 - 开关:- 电流 - 输出:50mA 同步整流器:是 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:10-TFSOP,10-MSOP(0.118",3.00mm 宽)裸露焊盘 包装:带卷 (TR) 供应商设备封装:10-MSOP 裸露焊盘
LT3437IDD 制造商:Linear Technology 功能描述:SP-SWREG/Monolithic, 60V, 500mA, 200kHz Step-down Converter w/ BurstMode
LT3437IDD#PBF 功能描述:IC REG BUCK ADJ 0.5A 10DFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压(降压) 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON(1.45x1) 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2