- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3388IMSE-3#TRPBF (Linear Technology)IC REG BUCK SYNC 50MA 10MSOP PDF资料下载
参数资料
| 型号： | LTC3388IMSE-3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 11/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 50MA 10MSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 2.8V，3V，3.3V，5V |
| 输入电压： | 2.7 V ~ 20 V |
| 电流 - 输出： | 50mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
LTC3388-1/LTC3388-3
OPERATION
The LTC3388-1/LTC3388-3 is an ultralow quiescent
current power supply designed to maintain a regulated
output voltage by means of a nanopower high efficiency
synchronous buck regulator.
Undervoltage Lockout (UVLO)
When the voltage on V IN rises above the UVLO rising
threshold the buck converter is enabled and charge is
transferred from the input capacitor to the output capacitor.
If V IN falls below the UVLO falling threshold the part will
re-enter UVLO. In UVLO the quiescent current is approxi-
mately 400nA and the buck converter is disabled.
Internal Rail Generation
Two internal rails, CAP and V IN2 , are generated from V IN and
are used to drive the high side PMOS and low side NMOS
of the buck converter, respectively. Additionally the V IN2
rail serves as logic high for EN, STBY, and output voltage
select bits D0 and D1. The V IN2 rail is regulated at 4.6V
above GND while the CAP rail is regulated at 4.8V below
V IN . The V IN2 and CAP rails are not intended to be used
as external rails. Bypass capacitors are connected to the
CAP and V IN2 pins to serve as energy reservoirs for driving
the buck switches. When V IN is below 4.6V, V IN2 is equal
to V IN . CAP is at GND until V IN rises above 4.8V. Figure 1
shows the ideal V IN , V IN2 and CAP relationship.
18
16
Buck Operation
The buck regulator uses a hysteretic voltage algorithm
to control the output through internal feedback from the
V OUT sense pin. The buck converter charges an output
capacitor through an inductor to a value slightly higher than
the regulation point. It does this by ramping the inductor
current up to 150mA through an internal PMOS switch
and then ramping it down to 0mA through an internal
NMOS switch. This efficiently delivers energy to the output
capacitor. The ramp rate is determined by V IN , V OUT , and
the inductor value. When the buck brings the output volt-
age into regulation the converter enters a low quiescent
current sleep state that monitors the output voltage with
a sleep comparator. During this operating mode load cur-
rent is provided by the buck output capacitor. When the
output voltage falls below the regulation point the buck
regulator wakes up and the cycle repeats. This hysteretic
method of providing a regulated output reduces losses
associated with FET switching and maintains an output
at light loads. The buck delivers a minimum of 50mA of
average load current when it is switching.
When the sleep comparator signals that the output has
reached the sleep threshold the buck converter may be
in the middle of a cycle with current still flowing through
the inductor. Normally both synchronous switches would
turn off and the current in the inductor would freewheel
to zero through the NMOS body diode. The LTC3388-1/
LTC3388-3 keeps the NMOS switch on during this time to
prevent the conduction loss that would occur in the diode
14
12
10
8
6
4
2
CAP
V IN
V IN2
if the NMOS were off. If the PMOS is on when the sleep
comparator trips, the NMOS will turn on immediately in
order to ramp down the current. If the NMOS is on it will
be kept on until the current reaches zero.
Though the quiescent current when the buck is switching
is much greater than the sleep quiescent current, it is still
a small percentage of the average inductor current which
0
0
5
10
15
results in high efficiency over most load conditions. The
V IN (V)
338813 F01
Figure 1. Ideal V IN , V IN2 and CAP Relationship
buck operates only when the output voltage discharges
to the sleep falling threshold. Thus, the buck operating
quiescent current is averaged with the low sleep quiescent
current. This allows the converter to remain very efficient
at loads as low as 10μA.
338813f
11
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3400ES6-1#TRPBF | IC REG BST SYNC ADJ .85A SOT23-6 |
| LTC3401EMS#TR | IC REG BOOST SYNC ADJ 1A 10MSOP |
| LTC3402EMS#TR | IC REG BOOST SYNC ADJ 2A 10MSOP |
| LTC3403EDD#TRPBF | IC REG BUCK SYNC ADJ 0.6A 8DFN |
| LTC3404MPMS8#PBF | IC REG BUCK SYNC ADJ 0.6A 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3400 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3400/LTC3400B | 制造商:LINER 制造商全称:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN |
| LTC3400-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT |
| LTC3400B | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3400BES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 0.5V to 6V 6-Pin TSOT-23 |
发布紧急采购，3分钟左右您将得到回复。