- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3388IMSE-3#TRPBF (Linear Technology)IC REG BUCK SYNC 50MA 10MSOP PDF资料下载
参数资料
| 型号： | LTC3388IMSE-3#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/20页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 50MA 10MSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 2.8V，3V，3.3V，5V |
| 输入电压： | 2.7 V ~ 20 V |
| 电流 - 输出： | 50mA |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-TFSOP，10-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-MSOP 裸露焊盘 |
LTC3388-1/LTC3388-3
OPERATION
Enable and Standby Modes
Two logic pins, EN and STBY, determine the operating
mode of the LTC3388-1/LTC3388-3. When EN is high and
STBY is low the synchronous buck converter is enabled
and will regulate the output if the input voltage is above
the programmed output voltage and above the UVLO
threshold. If EN is low the buck converter circuitry is
powered down to save quiescent current. The internal rail
generation circuits are kept alive and the voltages at V IN2
and CAP are maintained. When low, EN also shuts down
the PGOOD circuitry and pulls the PGOOD pin low. If EN
is high and the input falls below the UVLO threshold, the
buck converter is shut down.
While enabled, the LTC3388-1/LTC3388-3 can be placed
in standby mode by bringing STBY high. In standby mode
the buck converter is disabled, eliminating the quiescent
current used to run the buck circuitry. The PGOOD and
sleep comparators are kept alive to maintain the state of
the PGOOD pin.
The sleep comparator has lower quiescent current than the
PGOOD comparator and when the LTC3388-1/LTC3388-3
is in sleep mode the PGOOD comparator is shut down and
PGOOD is held high. The same occurs in standby mode.
If the LTC3388-1/LTC3388-3 was in sleep before entering
standby it will stay in sleep in standby, saving the quiescent
current of the PGOOD comparator. If V OUT falls below the
sleep falling threshold the PGOOD comparator will be
enabled. If V OUT falls below the PGOOD falling threshold
the PGOOD pin will be pulled low.
If STBY is driven high with EN low it will be ignored and
the LTC3388-1/LTC3388-3 will remain shut down.
If EN and STBY are driven high but near V IH or low but near
V IL , additional quiescent current may appear on V IN . This
additional quiescent current is typically 40nA and depends
on V IN and temperature. Driving EN or STBY to 0V or V IN2
will prevent additional quiescent current on V IN .
Figure 4 shows V OUT during a transition into and out of
standby. While in standby, the buck is off and V OUT is
quiet.
V OUT
50mV/DIV
AC-COUPLED
STANDBY
5V/DIV
0V
V IN = 5.5V,
500μs/DIV
338813 F04
L = 22μH, C OUT = 100μF
STANDBY TRANSIENT
Figure 4. LTC3388-3 Standby Transient,
V OUT = 3.3V, I LOAD = 5mA
338813f
13
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3400ES6-1#TRPBF | IC REG BST SYNC ADJ .85A SOT23-6 |
| LTC3401EMS#TR | IC REG BOOST SYNC ADJ 1A 10MSOP |
| LTC3402EMS#TR | IC REG BOOST SYNC ADJ 2A 10MSOP |
| LTC3403EDD#TRPBF | IC REG BUCK SYNC ADJ 0.6A 8DFN |
| LTC3404MPMS8#PBF | IC REG BUCK SYNC ADJ 0.6A 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3400 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3400/LTC3400B | 制造商:LINER 制造商全称:Linear Technology 功能描述:4A, 2MHz Dual Phase Step-Up DC/DC Converter in 3mm 3mm DFN |
| LTC3400-1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:600mA, 1.2MHz Micropower Synchronous Boost Converter in ThinSOT |
| LTC3400B | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3400BES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 0.5V to 6V 6-Pin TSOT-23 |
发布紧急采购，3分钟左右您将得到回复。