- 您现在的位置：买卖IC网 > PDF目录14798 > LTC3615EUF#PBF (Linear Technology)IC REG BUCK SYNC ADJ 3A DL 24QFN PDF资料下载
参数资料
| 型号： | LTC3615EUF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/32页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A DL 24QFN |
| 标准包装： | 91 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5.5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 400kHz ~ 4MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 24-QFN 裸露焊盘（4x4） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
LTC3615/LTC3615-1
OPERATION
Burst Mode Operation—External Clamp
Connecting the MODE pin to a voltage in the range of 0.5V
to 0.8V enables Burst Mode operation with external clamp.
During this mode of operation, the minimum voltage on
the ITH pin is externally set by the voltage on the MODE
pin. It is recommended to use Burst Mode operation with
the internal clamp for ambient temperatures above 85°C.
Pulse-Skipping Mode Operation
Pulse-skipping mode is similar to Burst Mode operation,
but the LTC3615 does not disable power to the internal
circuitry during sleep mode. This improves output voltage
ripple but uses more quiescent current compromising
light load efficiency.
Connecting the MODE pin to SV IN enables pulse-skipping
mode. As the load current decreases, the peak inductor
current will be determined by the voltage on the ITH pin
until the ITH voltage drops below 450mV, corresponding
to 0A. At this point switching cycles will be skipped to
keep the output voltage in regulation.
LTC3615
Forced Continuous Mode Operation
In forced continuous mode the inductor current is con-
stantly cycled which creates a minimum output voltage
ripple at all output current levels.
Connecting the MODE pin, to a voltage in the range of
1.1V to SV IN ? 0.58 will select the forced continuous mode
operation.
The forced continuous mode must be used if the output
is required to sink current.
Dropout Operation
As the input supply voltage approaches the output voltage,
the duty cycle increases toward the maximum on-time.
Further reduction of the supply voltage forces the main
switch to remain on for more than one cycle, eventually
reaching 100% duty cycle. The output voltage will then be
determined by the input voltage minus the voltage drop
across the internal P-channel MOSFET and the inductor.
LTC3615
V IN
SV IN
V IN
SV IN
SW1
V OUT1
R M1
0V
MODE
SGND
0V
MODE
SGND
FB1
R M2
2a. Burst Mode Operation
Internally Controlled
LTC3615
2b. Burst Mode Operation
Externally Controlled
LTC3615
V IN
SV IN
V IN
SV IN
R M1
MODE
R M2
MODE
0V
SGND
0V
SGND
3615 F02
2c. Pulse-Skipping Mode
2d. Forced Continuous Mode
Figure 2. Modes of Operation
13
For more information www.linear.com/LTC3615
3615fb
相关PDF资料 |
PDF描述 |
|---|---|
| RBC25DCAD | CONN EDGECARD 50POS R/A .100 SLD |
| RBB05DHFR | CONN EDGECARD 10POS .050 SMD |
| LTC3615EUF-1#PBF | IC REG BUCK SYNC ADJ 3A DL 24QFN |
| MAX6423US24+T | IC MPU/RESET CIRC 2.40V SOT143-4 |
| LT1076CR#PBF | IC REG MULTI CONFIG ADJ 2A D2PAK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3615HFE#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE-1#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HFE-1#TRPBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
| LTC3615HUF#PBF | 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP |
发布紧急采购，3分钟左右您将得到回复。