参数资料
型号: LTC3615EUF#PBF
厂商: Linear Technology
文件页数: 14/32页
文件大小: 0K
描述: IC REG BUCK SYNC ADJ 3A DL 24QFN
标准包装: 91
类型: 降压(降压)
输出类型: 可调式
输出数: 2
输出电压: 0.6 V ~ 5.5 V
输入电压: 2.25 V ~ 5.5 V
PWM 型: 电流模式,混合
频率 - 开关: 400kHz ~ 4MHz
电流 - 输出: 3A
同步整流器:
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 24-WFQFN 裸露焊盘
包装: 管件
供应商设备封装: 24-QFN 裸露焊盘(4x4)
LTC3615/LTC3615-1
OPERATION
Low Supply Operation
The LTC3615 is designed to operate down to an input supply
voltage of 2.25V. An important consideration at low input
supply voltages is that the R DS(ON) of the P-channel and
N-channel power switches increases by 50% compared to
5V. The user should calculate the power dissipation when
the LTC3615 is used at 100% duty cycle with low input
voltages to ensure that thermal limits are not exceeded.
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in current mode
constant-frequency architectures by preventing subhar-
monic oscillations at duty cycles greater than 50%. The
LTC3615 implements slope compensation by adding a
compensation ramp to the inductor current signal.
Short-Circuit Protection
The peak inductor current at which the current comparator
shuts off the top power switch is controlled by the voltage
on the ITH pin.
If the output current increases, the error amplifier raises
the ITH pin voltage until the average inductor current
matches the new load current. In normal operation, the
LTC3615 clamps the maximum ITH pin voltage at ap-
proximately 1.05V which corresponds to about 5A peak
inductor current.
When the output is shorted to ground, the inductor current
decays very slowly during a single switching cycle. The
LTC3615 uses two techniques to prevent current runaway
from occurring:
1. If the output voltage drops below 50% of its nominal
value, the clamp voltage at pin ITH is lowered, causing
the maximum peak inductor current to lower gradu-
ally with the output voltage. When the output voltage
reaches 0V, the clamp voltage at the ITH pin drops to
40% of the clamp voltage during normal operation. The
short-circuit peak inductor current is determined by the
minimum on-time of the LTC3615, the input voltage
and the inductor value. This foldback behavior helps
in limiting the peak inductor current when the output
is shorted to ground. It is disabled during internal or
external soft-start and tracking up/down operation (see
the Applications Information section).
2. If the inductor current of the bottom MOSFET increases
beyond 6A typical, the top power MOSFET will be held
off and switching cycles will be skipped until the induc-
tor current reduces.
14
For more information www.linear.com/LTC3615
3615fb
相关PDF资料
PDF描述
RBC25DCAD CONN EDGECARD 50POS R/A .100 SLD
RBB05DHFR CONN EDGECARD 10POS .050 SMD
LTC3615EUF-1#PBF IC REG BUCK SYNC ADJ 3A DL 24QFN
MAX6423US24+T IC MPU/RESET CIRC 2.40V SOT143-4
LT1076CR#PBF IC REG MULTI CONFIG ADJ 2A D2PAK
相关代理商/技术参数
参数描述
LTC3615HFE#PBF 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP
LTC3615HFE#TRPBF 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP
LTC3615HFE-1#PBF 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP
LTC3615HFE-1#TRPBF 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP
LTC3615HUF#PBF 制造商:Linear Technology 功能描述:IC REG BUCK SYNC ADJ 3A 24TSSOP