- 您现在的位置：买卖IC网 > PDF目录1831 > LTC3703IGN#PBF (Linear Technology)IC REG CTRLR BST PWM VM 16-SSOP PDF资料下载
参数资料
| 型号： | LTC3703IGN#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 25/34页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM VM 16-SSOP |
| 标准包装： | 100 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 330kHz |
| 占空比： | 96% |
| 电源电压： | 9.3 V ~ 15 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 16-SSOP（0.154"，3.90mm 宽） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LTC3703
APPLICATIONS INFORMATION
t ON =
> t ON(MIN)
MODE/SYNCPin(ExternalSynchronization)
The internal LTC3703 oscillator can be synchronized to
an external oscillator by applying and clocking the MODE/
SYNC pin with a signal above 2V P-P . The internal oscillator
locks to the external clock after the second clock transition
is received. When external synchronization is detected,
LTC3703 will operate in forced continuous mode. If an
external clock transition is not detected for three suc-
cessive periods, the internal oscillator will revert to the
frequency programmed by the R SET resistor. The internal
oscillator can synchronize to frequencies between 100kHz
and 600kHz, independent of the frequency programmed by
the R SET resistor. However, it is recommended that an R SET
resistor be chosen such that the frequency programmed
by the R SET resistor is close to the expected frequency of
the external clock. In this way, the best converter operation
(ripple, component stress, etc) is achieved if the external
clock signal is lost.
Fault Conditions: Output Overvoltage Protection
(Crowbar)
The output overvoltage crowbar is designed to blow a
system fuse in the input lead when the output of the regula-
tor rises much higher than nominal levels. This condition
causes huge currents to flow, much greater than in normal
operation. This feature is designed to protect against a
shorted top MOSFET; it does not protect against a failure
of the controller itself.
The comparator (MAX in the Functional Diagram) detects
overvoltage faults greater than 5% above the nominal
output voltage. When this condition is sensed the top
MOSFET is turned off and the bottom MOSFET is forced
on. The bottom MOSFET remains on continuously for as
long as the 0V condition persists; if V OUT returns to a safe
level, normal operation automatically resumes.
Minimum On-Time Considerations (Buck Mode)
Minimum on-time t ON(MIN) is the smallest amount of time
that the LTC3703 is capable of turning the top MOSFET on
and off again. It is determined by internal timing delays
and the amount of gate charge required to turn on the
top MOSFET. Low duty cycle applications may approach
this minimum on-time limit and care should be taken to
ensure that:
V OUT
V IN ? f
where t ON(MIN) is typically 200ns.
If the duty cycle falls below what can be accommodated
by the minimum on-time, the LTC3703 will begin to skip
cycles. The output will be regulated, but the ripple current
and ripple voltage will increase. If lower frequency opera-
tion is acceptable, the on-time can be increased above
t ON(MIN) for the same step-down ratio.
Pin Clearance/Creepage Considerations
The LTC3703 is available in two packages (GN16 and G28)
both with identical functionality. The GN16 package gives
the smallest size solution, however the 0.013" (minimum)
space between pins may not provide sufficient PC board
trace clearance between high and low voltage pins in higher
voltage applications. Where clearance is an issue, the G28
package should be used. The G28 package has four un-
connected pins between the all adjacent high voltage and
low voltage pins, providing 5(0.0106") = 0.053" clearance
which will be sufficient for most applications up to 100V.
For more information, refer to the printed circuit board
design standards described in IPC-2221 (www.ipc.org).
Efficiency Considerations
The efficiency of a switching regulator is equal to the out-
put power divided by the input power (x100%). Percent
efficiency can be expressed as:
%Efficiency = 100% – (L1 + L2 + L3 + ...)
where L1, L2, etc. are the individual losses as a percentage
of input power. It is often useful to analyze the individual
losses to determine what is limiting the efficiency and
what change would produce the most improvement.
Although all dissipative elements in the circuit produce
losses, four main sources usually account for most of the
losses in LTC3703 circuits: 1) LTC3703 V CC current, 2)
MOSFET gate current, 3) I 2 R losses, 4) Topside MOSFET
transition losses.
3703fc
25
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3704EMS#PBF | IC REG CTRLR INV PWM CM 10-MSOP |
| LTC3705IGN#TRPBF | IC CTRLR OCP 16SSOP |
| LTC3707IGN#TRPBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| LTC3708EUH#PBF | IC REG CTRLR BUCK PWM CM 32-QFN |
| LTC3709EG#TRPBF | IC REG CTRLR BUCK PWM CM 36-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3704EMS | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3704EMS#PBF | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3704EMS#PBF | 制造商:Linear Technology 功能描述:IC, DC/DC CONTROLLER, 300kHz, MSOP-10 |
| LTC3704EMS#TR | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3704EMS#TRPBF | 功能描述:IC REG CTRLR INV PWM CM 10-MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。