- 您现在的位置：买卖IC网 > PDF目录4954 > LTC3859EUHF#PBF (Linear Technology)IC REG CTRLR BST PWM CM 38-QFN PDF资料下载
参数资料
| 型号： | LTC3859EUHF#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/42页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BST PWM CM 38-QFN |
| 标准包装： | 52 |
| PWM 型： | 电流模式，Burst Mode? |
| 输出数： | 3 |
| 频率 - 最大： | 850kHz |
| 占空比： | 100% |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 是 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
LTC3859
APPLICATIONS INFORMATION
The Typical Application on the ?rst page is a basic LTC3859
application circuit. LTC3859 can be con?gured to use
either DCR (inductor resistance) sensing or low value
resistor sensing. The choice between the two current
sensing schemes is largely a design trade-off between
cost, power consumption, and accuracy. DCR sensing
is becoming popular because it saves expensive current
sensing resistors and is more power ef?cient, especially
in high current applications. However, current sensing
resistors provide the most accurate current limits for the
controller. Other external component selection is driven
by the load requirement, and begins with the selection of
R SENSE (if R SENSE is used) and inductor value. Next, the
power MOSFETs and Schottky diodes are selected. Finally,
input and output capacitors are selected.
SENSE + and SENSE – Pins
on the SENSE3 – pin allows the current comparator to be
used in inductor DCR sensing.
Filter components mutual to the sense lines should be
placed close to the LTC3859, and the sense lines should
run close together to a Kelvin connection underneath the
current sense element (shown in Figure 3). Sensing cur-
rent elsewhere can effectively add parasitic inductance
and capacitance to the current sense element, degrading
the information at the sense terminals and making the
programmed current limit unpredictable. If DCR sensing
is used (Figure 4b), sense resistor R1 should be placed
close to the switching node, to prevent noise from coupling
into sensitive small-signal nodes.
TO SENSE FILTER
NEXT TO THE CONTROLLER
The SENSE + and SENSE – pins are the inputs to the current
comparators.
3859 F03
CURRENT FLOW
R SENSE =
Δ I L
I MAX +
BuckControllers(SENSE1 + /SENSE1 – ,SENSE2 + /SENSE2 – ):
The common mode voltage range on these pins is 0V to
28V (absolute maximum), enabling the LTC3859 to regu-
late buck output voltages up to a nominal 24V (allowing
margin for tolerances and transients). The SENSE + pin
is high impedance over the full common mode range,
drawing at most ±1μA. This high impedance allows the
current comparators to be used in inductor DCR sensing.
The impedance of the SENSE – pin changes depending on
the common mode voltage. When SENSE – is less than
INTV CC –0.5V, a small current of less than 1μA ?ows out
of the pin. When SENSE – is above INTV CC +0.5V, a higher
current (≈700μA) ?ows into the pin. Between INTV CC –0.5V
and INTV CC +0.5V, the current transitions from the smaller
current to the higher current.
Boost Controller (SENSE3 + /SENSE3 – ): The common
mode input range for these pins is 2.5V to 38V, allowing
the boost converter to operate from inputs over this full
range. The SENSE3 + pin also provides power to the cur-
rent comparator and draws about 170μA during normal
operation (when not shut down or asleep in Burst Mode
operation). There is a small bias current of less than 1μA
that ?ows out of the SENSE3 – pin. This high impedance
INDUCTOR OR R SENSE
Figure 3. Sense Lines Placement with Inductor or Sense Resistor
Low Value Resistor Current Sensing
A typical sensing circuit using a discrete resistor is shown
in Figure 4a. R SENSE is chosen based on the required
output current.
The current comparators have a maximum threshold
V SENSE(MAX) of 50mV. The current comparator threshold
sets the peak of the inductor current, yielding a maximum
average output current, I MAX , equal to the peak value less
half the peak-to-peak ripple current, D I L . To calculate the
sense resistor value, use the equation:
V SENSE(MAX)
2
When using the buck controllers in very low dropout
conditions, the maximum output current level will be
reduced due to the internal compensation required to
meet stability criterion for buck regulators operating at
greater than 50% duty factor. A curve is provided in the
Typical Performance Characteristics section to estimate
this reduction in peak output current level depending upon
the operating duty factor.
3859fa
20
相关PDF资料 |
PDF描述 |
|---|---|
| HMC26DRTH-S734 | CONN EDGECARD 52POS DIP .100 SLD |
| 4922-05L | INDUCTOR 2.2UH POWER SMD |
| LTC3728EG#PBF | IC REG CTRLR BUCK PWM CM 28-SSOP |
| HMC26DREN-S734 | CONN EDGECARD 52POS .100 EYELET |
| ECA44DTMT | CONN EDGECARD 88POS R/A .125 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3859IFE#PBF | 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3859IFE#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3859IUHF#PBF | 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP（0.173"，4.40mm 宽） 包装:带卷 (TR) |
| LTC3859IUHF#TRPBF | 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3860EUH#PBF | 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。