参数资料
型号: LTC3859EUHF#PBF
厂商: Linear Technology
文件页数: 29/42页
文件大小: 0K
描述: IC REG CTRLR BST PWM CM 38-QFN
标准包装: 52
PWM 型: 电流模式,Burst Mode?
输出数: 3
频率 - 最大: 850kHz
占空比: 100%
电源电压: 4.5 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 38-WFQFN 裸露焊盘
包装: 管件
LTC3859
APPLICATIONS INFORMATION
1000
900
800
700
600
500
400
300
200
100
at a frequency correspond to the frequency set by the
FREQ pin. Once prebiased, the PLL only needs to adjust
the frequency slightly to achieve phase-lock and synchro-
nization. Although it is not required that the free-running
frequency be near external clock frequency, doing so will
prevent the operating frequency from passing through a
large range of frequencies as the PLL locks.
Table 1 summarizes the different states in which the FREQ
pin can be used.
0
15 25 35 45 55 65 75 85 95 105 115 125
Table 1
FREQ PIN RESISTOR (kΩ)
3859 F10
FREQ PIN
PLLIN/MODE PIN
FREQUENCY
Figure 10. Relationship Between Oscillator
Frequency and Resistor Value at the FREQ Pin
PLLIN/MODE pin. The turn-on of controller 2’s top MOSFET
is thus 180 degrees out of phase with the external clock.
0V
INTV CC
Resistor to SGND
Any of the Above
DC Voltage
DC Voltage
DC Voltage
External Clock
350kHz
535kHz
50kHz to 900kHz
Phase-Locked to
External Clock
The phase detector is an edge sensitive digital type that
t ON(MIN)_ BUCK < OUT
t ON(MIN)_ BOOST < OUT
provides zero degrees phase shift between the external
and internal oscillators. This type of phase detector does
not exhibit false lock to harmonics of the external clock.
If the external clock frequency is greater than the internal
oscillator’s frequency, f OSC , then current is sourced continu-
ously from the phase detector output, pulling up the VCO
input. When the external clock frequency is less than f OSC ,
current is sunk continuously, pulling down the VCO input.
If the external and internal frequencies are the same but
exhibit a phase difference, the current sources turn on for
an amount of time corresponding to the phase difference.
The voltage at the VCO input is adjusted until the phase
and frequency of the internal and external oscillators are
identical. At the stable operating point, the phase detector
output is high impedance and the internal ?lter capacitor,
CLP, holds the voltage at the VCO input.
Note that the LTC3859 can only be synchronized to an
external clock whose frequency is within range of the
LTC3859’s internal VCO, which is nominally 55kHz to 1MHz.
This is guaranteed to be between 75kHz and 850kHz.
Typically, the external clock (on PLLIN/MODE pin) input high
threshold is 1.6V, while the input low threshold is 1.2V.
Rapid phase-locking can be achieved by using the FREQ pin
to set a free-running frequency near the desired synchro-
nization frequency. The VCO’s input voltage is prebiased
Minimum On-Time Considerations
Minimum on-time t ON(MIN) is the smallest time duration
that the LTC3859 is capable of turning on the top MOSFET
(bottom MOSFET for the boost controller). It is determined
by internal timing delays and the gate charge required to
turn on the top MOSFET. Low duty cycle applications may
approach this minimum on-time limit and care should be
taken to ensure that
V
V IN (f)
V ? V IN
V OUT (f)
If the duty cycle falls below what can be accommodated
by the minimum on-time, the controller will begin to skip
cycles. The output voltage will continue to be regulated,
but the ripple voltage and current will increase.
The minimum on-time for the LTC3859 is approximately
95ns for the bucks and 120ns for the boost. However, as
the peak sense voltage decreases the minimum on-time
gradually increases up to about 130ns. This is of particu-
lar concern in forced continuous applications with low
ripple current at light loads. If the duty cycle drops below
the minimum on-time limit in this situation, a signi?cant
amount of cycle skipping can occur with correspondingly
larger current and voltage ripple.
3859fa
29
相关PDF资料
PDF描述
HMC26DRTH-S734 CONN EDGECARD 52POS DIP .100 SLD
4922-05L INDUCTOR 2.2UH POWER SMD
LTC3728EG#PBF IC REG CTRLR BUCK PWM CM 28-SSOP
HMC26DREN-S734 CONN EDGECARD 52POS .100 EYELET
ECA44DTMT CONN EDGECARD 88POS R/A .125 SLD
相关代理商/技术参数
参数描述
LTC3859IFE#PBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3859IFE#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3859IUHF#PBF 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3859IUHF#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3860EUH#PBF 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR