参数资料
型号: LTC3859EUHF#PBF
厂商: Linear Technology
文件页数: 23/42页
文件大小: 0K
描述: IC REG CTRLR BST PWM CM 38-QFN
标准包装: 52
PWM 型: 电流模式,Burst Mode?
输出数: 3
频率 - 最大: 850kHz
占空比: 100%
电源电压: 4.5 V ~ 38 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 125°C
封装/外壳: 38-WFQFN 裸露焊盘
包装: 管件
LTC3859
( I OUT(MAX) )
( V OUT ? V IN ) V OUT
P MAIN _ BOOST =
?
V IN
( 1 + δ ) R DS(ON) + ?
? ? ?
? ?
? V IN ? ?
( R DR ) ( C MILLER ) ? ? V
+
? V THMIN
V THMIN ?
( )
V IN
I OUT(MAX) ( 1 + δ ) R DS(ON)
P SYNC _ BOOST =
Buck Main Switch Duty Cycle = OUT
V ? V OUT
V ? V IN
Boost Sync Switch Duty Cycle =
( ) ( 1 + δ ) R
V OUT
P MAIN _ BUCK =
DS(ON) +
(V IN ) 2 ?
? (R DR )(C MILLER ) ?
? ?
APPLICATIONS INFORMATION
The peak-to-peak drive levels are set by the INTV CC voltage.
This voltage is typically 5.4V during start-up (see EXTV CC
Pin Connection). Consequently, logic-level threshold
MOSFETs must be used in most applications. Pay close
attention to the BV DSS speci?cation for the MOSFETs as
well; many of the logic level MOSFETs are limited to 30V
or less.
Selection criteria for the power MOSFETs include the
on-resistance R DS(ON) , Miller capacitance C MILLER , input
voltage and maximum output current. Miller capacitance,
C MILLER , can be approximated from the gate charge curve
usually provided on the MOSFET manufacturers’ data
sheet. C MILLER is equal to the increase in gate charge
along the horizontal axis while the curve is approximately
?at divided by the speci?ed change in V DS . This result is
then multiplied by the ratio of the application applied V DS
to the gate charge curve speci?ed V DS . When the IC is
operating in continuous mode the duty cycles for the top
and bottom MOSFETs are given by:
V
V IN
Buck Sync Switch Duty Cycle = IN
V IN
Boost Main Switch Duty Cycle = OUT
V OUT
V IN
V OUT
The MOSFET power dissipations at maximum output
current are given by:
2
I OUT(MAX)
V IN
? I OUT(MAX) ?
2
2
2
? V 2 OUT ? ? I OUT(MAX) ?
2
? 1 1 ?
? (f)
? INTVCC
2
V OUT
where z is the temperature dependency of R DS(ON) and
RDR (approximately 2Ω) is the effective driver resistance
at the MOSFET’s Miller threshold voltage. V THMIN is the
typical MOSFET minimum threshold voltage.
Both MOSFETs have I 2 R losses while the main N-channel
equations for the buck and boost controllers include an
additional term for transition losses, which are highest at
high input voltages for the bucks and low input voltages for
the boost. For V IN < 20V (high V IN for the boost) the high
current ef?ciency generally improves with larger MOSFETs,
while for V IN > 20V (low V IN for the boost) the transition
losses rapidly increase to the point that the use of a higher
R DS(ON) device with lower C MILLER actually provides higher
ef?ciency. The synchronous MOSFET losses for the buck
controllers are greatest at high input voltage when the top
switch duty factor is low or during a short-circuit when the
synchronous switch is on close to 100% of the period. The
synchronous MOSFET losses for the boost controller are
greatest when the input voltage approaches the output volt-
age or during an overvoltage event when the synchronous
switch is on 100% of the period.
The term (1+ z ) is generally given for a MOSFET in the
form of a normalized R DS(ON) vs Temperature curve, but
z = 0.005/°C can be used as an approximation for low
voltage MOSFETs.
+
? V INTVCC ? V THMIN
V THMIN ?
(
P SYNC _ BUCK = IN
V ? V OUT
) ( ) δ R
1 +
? 1 1 ?
V IN
? ? (f)
I OUT(MAX)
2
DS(ON)
The optional Schottky diodes D4, D5, and D6 shown in
Figure 13 conduct during the dead-time between the
conduction of the two power MOSFETs. This prevents
the body diode of the synchronous MOSFET from turning
on, storing charge during the dead-time and requiring a
reverse recovery period that could cost as much as 3%
in ef?ciency at high V IN . A 1A to 3A Schottky is generally
3859fa
23
相关PDF资料
PDF描述
HMC26DRTH-S734 CONN EDGECARD 52POS DIP .100 SLD
4922-05L INDUCTOR 2.2UH POWER SMD
LTC3728EG#PBF IC REG CTRLR BUCK PWM CM 28-SSOP
HMC26DREN-S734 CONN EDGECARD 52POS .100 EYELET
ECA44DTMT CONN EDGECARD 88POS R/A .125 SLD
相关代理商/技术参数
参数描述
LTC3859IFE#PBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3859IFE#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38-TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3859IUHF#PBF 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,000 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:50% 电源电压:9 V ~ 10 V 降压:无 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 85°C 封装/外壳:8-TSSOP(0.173",4.40mm 宽) 包装:带卷 (TR)
LTC3859IUHF#TRPBF 功能描述:IC REG CTRLR BST PWM CM 38VQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX
LTC3860EUH#PBF 功能描述:IC REG CTRLR BUCK PWM VM 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR