- 您现在的位置：买卖IC网 > PDF目录180125 > M29F400FB55M3F2 256K X 16 FLASH 5V PROM, 55 ns, PDSO44 PDF资料下载
参数资料
| 型号： | M29F400FB55M3F2 |
| 元件分类： | PROM |
| 英文描述： | 256K X 16 FLASH 5V PROM, 55 ns, PDSO44 |
| 封装： | 0.500 INCH, ROHS COMPLIANT, PLASTIC, SOP-44 |
| 文件页数： | 54/65页 |
| 文件大小： | 1669K |
| 代理商： | M29F400FB55M3F2 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页当前第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页
Block protection
M29FxxxFT, M29FxxxFB
58/65
Appendix C
Block protection
Block protection can be used to prevent any operation from modifying the data stored in the
Flash memory. Each Block can be protected individually. Once protected, Program and
Erase operations on the block fail to change the data.
There are three techniques that can be used to control Block Protection, these are the
Programmer technique, the In-System technique and Temporary Unprotection. Temporary
Unprotection is controlled by the Reset/Block Temporary Unprotection pin, RP; this is
described in the Signal Descriptions section.
Unlike the Command Interface of the Program/Erase Controller, the techniques for
protecting and unprotecting blocks could change between different Flash memory suppliers.
9.1
Programmer Technique
The Programmer technique uses high (VID) voltage levels on some of the bus pins. These
cannot be achieved using a standard microprocessor bus, therefore the technique is
recommended only for use in Programming Equipment.
To protect a block follow the flowchart in Figure Figure 25., Programmer Equipment Block
Protect Flowchart. During the Block Protect algorithm, the A19-A12 Address Inputs indicate
the address of the block to be protected. The block will be correctly protected only if A19-
A12 remain valid and stable, and if Chip Enable is kept Low, VIL, all along the Protect and
Verify phases.
The Chip Unprotect algorithm is used to unprotect all the memory blocks at the same time.
This algorithm can only be used if all of the blocks are protected first. To unprotect the chip
follow Figure Figure 26., Programmer Equipment Chip Unprotect Flowchart. Table Table
, Programmer Technique Bus Operations, gives a summary of each operation.
The timing on these flowcharts is critical. Care should be taken to ensure that, where a
pause is specified, it is followed as closely as possible. Do not abort the procedure before
reaching the end. Chip Unprotect can take several seconds and a user message should be
provided to show that the operation is progressing.
9.2
In-System Technique
The In-System technique requires a high voltage level on the Reset/Blocks Temporary
Unprotect pin, RP. This can be achieved without violating the maximum ratings of the
components on the microprocessor bus, therefore this technique is suitable for use after the
Flash memory has been fitted to the system.
To protect a block follow the flowchart in Figure Figure 27., In-System Block Protect
Flowchart. To unprotect the whole chip it is necessary to protect all of the blocks first, then
all the blocks can be unprotected at the same time. To unprotect the chip follow Figure
, In-System Chip Unprotect Flowchart.
The timing on these flowcharts is critical. Care should be taken to ensure that, where a
pause is specified, it is followed as closely as possible. Do not allow the microprocessor to
service interrupts that will upset the timing and do not abort the procedure before reaching
the end. Chip Unprotect can take several seconds and a user message should be provided
to show that the operation is progressing.
相关PDF资料 |
PDF描述 |
|---|---|
| M29F400FB5AN6F2 | 256K X 16 FLASH 5V PROM, 55 ns, PDSO48 |
| M29W800B-120N5RTR | 1M X 8 FLASH 3V PROM, 120 ns, PDSO48 |
| M29W800T-150M6 | 1M X 8 FLASH 3V PROM, 150 ns, PDSO44 |
| M29W800FB9N3F | 512K X 16 FLASH 3V PROM, 90 ns, PDSO48 |
| M2CT-90A1-24ER | PUSHBUTTON SWITCH, DPST, MOMENTARY, PANEL MOUNT-THREADED |
相关代理商/技术参数 |
参数描述 |
|---|---|
| M29F400FB55M3F2 TR | 制造商:Micron Technology Inc 功能描述:IC FLASH 4MBIT 55NS 44SO |
| M29F400FB55M3T2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays |
| M29F400FB55N3E2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Trays 制造商:Micron Technology Inc 功能描述:IC FLASH 4MBIT 55NS 48TSOP |
| M29F400FB55N3F2 | 制造商:Micron Technology Inc 功能描述:AUTOMOTIVE 5V - Tape and Reel |
| M29F400FB55N3F2 TR | 制造商:Micron Technology Inc 功能描述:IC FLASH 4MBIT 55NS 48TSOP |
发布紧急采购，3分钟左右您将得到回复。