MB90540G/545G Series
DS07-13703-7E
69
■ MAIN CHANGES IN THIS EDITION
The vertical lines marked in the left side of the page show the changes.
Page
Section
Change Results
5
■ PRODUCT LINEUP
Changed the name in peripheral resource.
16-bit I/O Timer
→ 16-bit Free-run Timer
14 to 16
■ I/O CIRCUIT TYPE
Changed the name of input typ.
Hysteresis
→ CMOS Hysteresis
HYS
→ CMOS Hysteresis
21
■ BLOCK DIAGRAM
Changed the arrow direction of SOT1 signal at UART1(SCI).
“
← →” (input/output) → “←” (output)
28
■ I/O MAP
Changed the text of “Note”.
35
■ INTERRUPT MAP
Changed the name of peripheral resource of the pin number:
#19.
I/O Timer
→ 16-bit Free-run Timer
39
■ ELECTRICAL CHARACTERISTICS
2. Recommended Conditions
Changed the remarks of “parameter: Power supply voltage”.
40
3. DC Characteristics
Changed the maximum value of symbol : VILM of parameter:
Input voltage.
VCC + 0.3
→ VSS + 0.3
Added the following remarks for parameter : Pull-down
resistance.
Except Flash device
42, 43
4. AC Characteristics
(1) Clock Timing
Added the value when using an external clock in Oscillation
frequency and Clock cycle time on (1) Clock Timing for
parameter.
44
Added the item of A/D converter operation range in figure of “
Guaranteed PLL operation range”
46
(3) Reset and Hardware Standby Input
Timing
Changed the following item.
(3) Reset and Hardware Standby Input Timing Remarks:
In sub-clock mode, sub-sleep mode, timer mode
2tCP
→ 2tLCP
48
(4) Power On Reset
Changed as follows;
Due to repetitive operation
→ Waiting time until power-on
57
5. A/D Converter
Changed the unit of Zero transition voltage and Full scale
transition voltage.
mV
→ V
66
■ ORDERING INFORMATION
Added the MB90F548GLPMC in Part Numbers.