参数资料
型号: MB9AF311MPMC
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 40 MHz, RISC MICROCONTROLLER, PQFP80
封装: 0.50 MM PITCH, PLASTIC, LQFP-80
文件页数: 7/114页
文件大小: 1357K
代理商: MB9AF311MPMC
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
104
16.6
Input Capture Unit
The Timer/Counter incorporates an input capture unit that can capture external events and give them a time-stamp
indicating time of occurrence. The external signal indicating an event, or multiple events, can be applied via the ICP1 pin or
alternatively, via the analog-comparator unit. The time-stamps can then be used to calculate frequency, duty-cycle, and
other features of the signal applied. Alternatively the time-stamps can be used for creating a log of the events.
The input capture unit is illustrated by the block diagram shown in Figure 16-3. The elements of the block diagram that are
not directly a part of the input capture unit are gray shaded. The small “n” in register and bit names indicates the
Timer/Counter number.
Figure 16-3. Input Capture Unit Block Diagram
When a change of the logic level (an event) occurs on the input capture pin (ICP1), alternatively on the analog comparator
output (ACO), and this change confirms to the setting of the edge detector, a capture will be triggered. When a capture is
triggered, the 16-bit value of the counter (TCNT1) is written to the input capture register (ICR1). The input capture flag (ICF1)
is set at the same system clock as the TCNT1 value is copied into ICR1 register. If enabled (ICIE1 = 1), the input capture flag
generates an input capture interrupt. The ICF1 flag is automatically cleared when the interrupt is executed. Alternatively the
ICF1 flag can be cleared by software by writing a logical one to its I/O bit location.
Reading the 16-bit value in the input capture register (ICR1) is done by first reading the low byte (ICR1L) and then the high
byte (ICR1H). When the low byte is read the high byte is copied into the high byte temporary register (TEMP). When the
CPU reads the ICR1H I/O location it will access the TEMP register.
The ICR1 register can only be written when using a waveform generation mode that utilizes the ICR1 register for defining the
counter’s TOP value. In these cases the waveform generation mode (WGM13:0) bits must be set before the TOP value can
be written to the ICR1 register. When writing the ICR1 register the high byte must be written to the ICR1H I/O location before
the low byte is written to ICR1L.
For more information on how to access the 16-bit registers refer to Section 16.3 “Accessing 16-bit Registers” on page 100.
ICFn (Int. Req.)
ICRnL (8-bit)
ICRnH (8-bit)
ICRn (16-bit Register)
TEMP (8-bit)
TCNTnL (8-bit)
TCNTnH (8-bit)
TCNTn (16-bit Counter)
DATA BUS (8-bit)
Noise
Canceler
Analog
Comparator
Edge
Detector
ICNC
ACIC*
ACO*
WRITE
+
-
ICES
ICPn
相关PDF资料
PDF描述
MSP430G2152IRSA16 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16
M37704E2EFP 16-BIT, OTPROM, 16 MHz, MICROCONTROLLER, PQFP80
MSM65544-JS 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PQCC68
MSM65516SS 8-BIT, MROM, 10 MHz, MICROCONTROLLER, PDIP64
MSM65P512JS 8-BIT, OTPROM, 10 MHz, MICROCONTROLLER, PQCC44
相关代理商/技术参数
参数描述
MB9AF312KPMC1-G-JNE2 功能描述:ARM? Cortex?-M3 FM3 MB9A310K Microcontroller IC 32-Bit 40MHz 160KB (160K x 8) FLASH 52-LQFP (10x10) 制造商:cypress semiconductor corp 系列:FM3 MB9A310K 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 连接性:CSIO,I2C,LIN,UART/USART,USB 外设:DMA,LVD,POR,PWM,WDT I/O 数:36 程序存储容量:160KB(160K x 8) 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:16K x 8 电压 - 电源(Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:A/D 8x12b 振荡器类型:内部 工作温度:-40°C ~ 105°C(TA) 封装/外壳:52-LQFP 供应商器件封装:52-LQFP(10x10) 标准包装:160
MB9AF312KPMC-ES-E1 制造商:FUJITSU 功能描述:
MB9AF312KPMC-G-JNE1 制造商:FUJITSU 功能描述:
MB9AF312KPMC-G-JNE2 功能描述:ARM? Cortex?-M3 FM3 MB9A310K Microcontroller IC 32-Bit 40MHz 160KB (160K x 8) FLASH 48-LQFP (7x7) 制造商:cypress semiconductor corp 系列:FM3 MB9A310K 包装:托盘 零件状态:有效 核心处理器:ARM? Cortex?-M3 核心尺寸:32-位 速度:40MHz 连接性:CSIO,I2C,LIN,UART/USART,USB 外设:DMA,LVD,POR,PWM,WDT I/O 数:36 程序存储容量:160KB(160K x 8) 程序存储器类型:闪存 EEPROM 容量:- RAM 容量:16K x 8 电压 - 电源(Vcc/Vdd):2.7 V ~ 5.5 V 数据转换器:A/D 8x12b 振荡器类型:内部 工作温度:-40°C ~ 105°C(TA) 封装/外壳:48-LQFP 供应商器件封装:48-LQFP(7x7) 标准包装:250
MB9AF312KQN-ES-AWE2 制造商:FUJITSU 功能描述: