- 您现在的位置：买卖IC网 > PDF目录8855 > MCP4726A1T-E/MAY (Microchip Technology)IC DAC 12BIT NV EEP I2C 6DFN PDF资料下载
参数资料
| 型号： | MCP4726A1T-E/MAY |
| 厂商： | Microchip Technology |
| 文件页数： | 29/86页 |
| 文件大小： | 0K |
| 描述： | IC DAC 12BIT NV EEP I2C 6DFN |
| 标准包装： | 3,000 |
| 设置时间： | 6µs |
| 位数： | 12 |
| 数据接口： | EEPROM，I²C，串行 |
| 转换器数目： | 1 |
| 电压电源： | 单电源 |
| 功率耗散（最大）： | 1.10W |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 6-VDFN 裸露焊盘 |
| 供应商设备封装： | 6-DFN（2x2） |
| 包装： | 带卷 (TR) |
| 输出数目和类型： | 1 电压，单极 |
| 采样率（每秒）： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页当前第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页
2011-2012 Microchip Technology Inc.
DS22272C-page 35
MCP4706/4716/4726
4.0
GENERAL DESCRIPTION
The MCP4706, MCP4716, and MCP4726 devices are
single channel voltage output 8-bit, 10-bit, and 12-bit
DAC devices with nonvolatile memory (EEPROM) and
an I2C serial interface. This family will be referred to as
MCP47X6.
The devices use a resistor ladder architecture. The
resistor ladder DAC is driven from a software
selectable voltage reference source. The source can
be either the device’s internal VDD or the external VREF
pin voltage.
The DAC output is buffered with a low power and
precision output amplifier (op amp). This output
amplifier provides a rail-to-rail output with low offset
voltage and low noise. The gain of the output buffer is
software configurable.
This device also has user programmable nonvolatile
memory (EEPROM), which allows the user to save the
desired POR/BOR value of the DAC register and
device Configuration bits.
The devices use a two-wire I2C serial communication
interface and operate with a single supply voltage from
2.7V to 5.5V.
4.1
Power-On Reset/Brown-Out Reset
(POR/BOR)
The internal Power-on Reset (POR)/Brown-out Reset
(BOR) circuit monitors the power supply voltage (VDD)
during operation. This circuit ensures correct device
start-up at system power-up and power-down events.
VRAM is the RAM retention voltage and is always lower
than the POR trip point voltage.
POR occurs as the voltage is rising (typically from 0V),
while BOR occurs as the voltage is falling (typically
from VDD(MIN) or higher).
When the rising VDD voltage crosses the VPOR trip
point, the following occurs:
Nonvolatile DAC register value latched into
volatile DAC register
Nonvolatile Configuration bit values latched into
volatile Configuration bits
POR Status bit is set (“1”)
The Reset delay timer starts; when timer times
out (tPORD), the I
2C interface is operational.
The analog output (VOUT) state will be determined by
the state of the volatile Configuration bits and the DAC
register. This is called a POR Reset (event).
When the falling VDD voltage crosses the VPOR trip
point, the following occurs:
Device is forced into a power-down state
(PD1:PD0 = 11). Analog circuitry is turned off.
Volatile DAC register is forced to 000h
Volatile Configuration bits VREF1, VREF0 and G
are forced to ‘0’
Figure 4-1 illustrates the conditions for power-up and
power-down events under typical conditions.
FIGURE 4-1:
Power-on Reset Operation.
VPOR
TPORD
VDD(MIN)
Normal Operation
BOR Reset,
volatile DAC Register = 000h
volatile VREF1:VREF0 = 00
Device in
Below
VRAM
Device in
POR state
unknown
state
minimum
operating
voltage
Device in
unknown
state
Device
in power
down
state
(60 s max.)
volatile G = 0
volatile PD1:PD0 = 11
VBOR
Volatile memory
retains data value
Volatile memory
becomes corrupted
POR starts Reset Delay Timer.
When timer times out, I2C interface
can operate (if VDD >= VDD(MIN))
EEPROM data latched into volatile
Configuration bits and DAC register.
POR Status bit is set (“1”)
POR Reset forced active
相关PDF资料 |
PDF描述 |
|---|---|
| M83723/84G2219N | CONN RCPT 19POS JAM NUT W/SCKT |
| V28B36M150B3 | CONVERTER MOD DC/DC 36V 150W |
| ICS570BI | IC MULTIPLIER/ZDB 8-SOIC |
| MCP4726A1T-E/CH | IC DAC 12BIT NV EEP I2C SOT-23-6 |
| MS3454L22-21S | CONN RCPT 3POS JAM NUT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MCP4726A2T-E/CH | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A2T-E/MAY | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A3T-E/CH | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4726A3T-E/MAY | 功能描述:数模转换器- DAC Sngl 12B NV DAC w/Ex Vref & I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| MCP4728A0-E/UN | 功能描述:数模转换器- DAC Quad, 12-bit NV DAC with I2C interface RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。