参数资料
| 型号： | MIC3001BML TR |
| 厂商： | Micrel Inc |
| 文件页数： | 25/76页 |
| 文件大小： | 0K |
| 描述： | IC FOM MANAGEMENT W/CALIBR 24MLF |
| 标准包装： | 1,000 |
| 类型： | 收发器 |
| 规程： | SDHj Sonet |
| 电源电压： | 3 V ~ 3.6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-VFQFN 裸露焊盘，24-MLF? |
| 供应商设备封装： | 24-MLF?（4x4） |
| 包装： | 带卷 (TR) |
| 其它名称： | MIC3001BMLTR MIC3001BMLTR-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页
Micrel, Inc.
MIC3001
August 2004
31
M9999-082404-A
hbwhelp@micrel.com or (408) 955-1690
Alarms and Warning Flags
There are twenty different conditions that will cause the
MIC3001 to set one of the bits in the WARNx or ALARMx
registers. These conditions are listed in Table 19. The
less critical of these events generate warning flags by
setting a bit in WARN0 or WARN1. The more critical
events cause bits to be set in ALARM0 or ALARM1.
An event occurs when any alarm or warning condition
becomes true. Each event causes its corresponding
status bit in ALARM0, ALARM1, WARN0, or WARN1 to
be set. This action cannot be masked by the host. The
status bit will remain set until the host reads that particular
status register, a power on-off cycle occurs, or the host
toggles TXDISABLE.
If TXDISABLE is asserted at any time during normal
operation, A/D conversions continue. The A/D results for
all parameters will continue to be reported. All events will
be reported in the normal way. If they have not already
been individually cleared by read operations, when
TXDISABLE is de-asserted, all status registers will be
cleared.
Control and Status I/O
The logic for the transceiver control and status I/O is shown
schematically in Figure 14. Note that the internal drivers on
RXLOS, RATE_SELECT, and TXFAULT are all open-drain.
These signals may be driven either by the internal logic or
external drivers connected to the corresponding MIC3001
pins. In any case, the signal level appearing at the pins of
the MIC3001 will be reported in the control register status
bits.
Note
that
the
control
bits
for
TX_DISABLE
and
RATE_SELECT and the status bits for TXFAULT and
RXLOS do not meet the timing requirements specified in the
SFP MSA or the GBIC Specification, revision 5.5 (SFF-
8053) for the hardware signals. The speed of the serial
interface limits the rate at which these functions can be
manipulated and/or reported. The response time for the
control
and
status
bits
is
given
in
the
“Electrical
Characteristics” section.
Event
Condition
MIC3001 Response
Temperature high alarm
TEMP > TMAX
Set ALARM0[7]
Temperature low alarm
TEMP < TMIN
Set ALARM0[6]
Voltage high alarm
VIN > VMAX
Set ALARM0[5]
Voltage low alarm
VIN < VMIN
Set ALARM0[4]
TX bias high alarm
IBIAS > IBMAX
Set ALARM0[3]
TX bias low alarm
IBIAS < IBMIN
Set ALARM0[2]
TX power high alarm
TXOP > TXMAX
Set ALARM0[1]
TX power low alarm
TXOP < TXMIN
Set ALARM0[0]
RX power high alarm
RXOP > RXMAX
Set ALARM1[7]
RX power low alarm
RXOP < RXMIN
Set ALARM1[6]
Temperature high warning
TEMP > THIGH
Set WARN0[7]
Temperature low warning
TEMP < TLOW
Set WARN0[6]
Voltage high warning
VIN > VHIGH
Set WARN0[5]
Voltage low warning
VIN < VLOW
Set WARN0[4]
TX bias high warning
IBIAS > IBHIGH
Set WARN0[3]
TX bias low warning
IBIAS < IBLOW
Set WARN0[2]
TX power high warning
TXOP > TXHIGH
Set WARN0[1]
TX power low warning
TXOP < TXLOW
Set WARN0[0]
RX power high warning
RXOP > RXHIGH
Set WARN1[7]
RX power low warning
RXOP < RXLOW
Set WARN1[6]
Temperature high alarm
TEMP > TMAX
Set ALARM0[7]
Table 19. MIC3001 Events
相关PDF资料 |
PDF描述 |
|---|---|
| MIC74BQS TR | IC I/O EXPANDER I2C 8B 16QSOP |
| MICRF302YML TR | IC ENCODER PAR QWIKRADIO 10-MLF |
| MK10DN512ZVLL10 | IC ARM CORTEX MCU 512KB 100LQFP |
| MK10DX128VFM5 | IC ARM CORTEX MCU 128KB 32QFN |
| MK20DN512ZVLL10 | IC ARM CORTEX MCU 512KB 100LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MIC3001GML | 功能描述:网络控制器与处理器 IC F/O Transceiver Mgt. IC with Internal Calibration RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MIC3001GML TR | 功能描述:网络控制器与处理器 IC F/O Transceiver Mgt. IC with Internal Calibration RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| MIC3001GMLTR | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:FOM Management IC with Internal Calibration |
| MIC3002 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:FOM Management IC with Internal Calibr ation |
| MIC3002_10 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:FOM Management IC with Internal Calibration |
发布紧急采购，3分钟左右您将得到回复。