- 您现在的位置：买卖IC网 > PDF目录369994 > PF48F4400P0VBQ0 (INTEL CORP) Intel StrataFlash Embedded Memory PDF资料下载
参数资料
| 型号： | PF48F4400P0VBQ0 |
| 厂商： | INTEL CORP |
| 元件分类： | PROM |
| 英文描述： | Intel StrataFlash Embedded Memory |
| 中文描述： | 32M X 16 FLASH 1.8V PROM, 88 ns, PBGA88 |
| 封装： | 8 X 11 MM, 1.20 MM HEIGHT, LEAD FREE, SCSP-88 |
| 文件页数： | 53/102页 |
| 文件大小： | 1609K |
| 代理商： | PF48F4400P0VBQ0 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页当前第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页
1-Gbit P30 Family
Datasheet
Intel StrataFlash
Embedded Memory (P30)
Order Number: 306666, Revision: 001
April 2005
53
10.0
Read Operations
The device supports two read modes: asynchronous page mode and synchronous burst mode.
Asynchronous page mode is the default read mode after device power-up or a reset. The Read
Configuration Register must be configured to enable synchronous burst reads of the flash memory
array (see
Section 10.3, “Read Configuration Register” on page 54
).
The device can be in any of four read states: Read Array, Read Identifier, Read Status or Read
Query. Upon power-up, or after a reset, the device defaults to Read Array. To change the read state,
the appropriate read command must be written to the device (see
Section 9.2, “Device Commands”
on page 50
). See
Section 14.0, “Special Read States” on page 75
for details regarding Read Status,
Read ID, and CFI Query modes.
The following sections describe read-mode operations in detail.
10.1
Asynchronous Page-Mode Read
Following a device power-up or reset, asynchronous page mode is the default read mode and the
device is set to Read Array. However, to perform array reads after any other device operation (e.g.
write operation), the Read Array command must be issued in order to read from the flash memory
array.
Note:
Asynchronous page-mode reads can only be performed when Read Configuration Register bit
RCR[15] is set (see
Section 10.3, “Read Configuration Register” on page 54
).
To perform an asynchronous page-mode read, an address is driven onto the Address bus, and CE#
and ADV# are asserted. WE# and RST# must already have been deasserted. WAIT is deasserted
during asynchronous page mode. ADV# can be driven high to latch the address, or it must be held
low throughout the read cycle. CLK is not used for asynchronous page-mode reads, and is ignored.
If only asynchronous reads are to be performed, CLK should be tied to a valid V
IH
level, WAIT
signal can be floated and ADV# must be tied to ground. Array data is driven onto DQ[15:0] after
an initial access time t
AVQV
delay. (see
Section 7.0, “AC Characteristics” on page 33
).
In asynchronous page mode, four data words are “sensed” simultaneously from the flash memory
array and loaded into an internal page buffer. The buffer word corresponding to the initial address
on the Address bus is driven onto DQ[15:0] after the initial access delay. The lowest two address
bits determine which word of the 4-word page is output from the data buffer at any given time.
10.2
Synchronous Burst-Mode Read
To perform a synchronous burst- read, an initial address is driven onto the Address bus, and CE#
and ADV# are asserted. WE# and RST# must already have been deasserted. ADV# is asserted, and
then deasserted to latch the address. Alternately, ADV# can remain asserted throughout the burst
access, in which case the address is latched on the next valid CLK edge while ADV# is asserted.
During synchronous array and non-array read modes, the first word is output from the data buffer
on the next valid CLK edge after the initial access latency delay (see
Section 10.3.2, “Latency
Count” on page 55
). Subsequent data is output on valid CLK edges following a minimum delay.
相关PDF资料 |
PDF描述 |
|---|---|
| PF48F2000P0ZTQ0 | Intel StrataFlash Embedded Memory |
| PF48F3000P0ZTQ0 | Circular Connector; Body Material:Aluminum; Series:PT00; No. of Contacts:6; Connector Shell Size:10; Connecting Termination:Solder; Circular Shell Style:Wall Mount Receptacle; Circular Contact Gender:Pin; Insert Arrangement:10-6 |
| PF48F4000P0ZTQ0 | Circular Connector; MIL SPEC:MIL-C-26482, Series I, Solder; Body Material:Aluminum; Series:PT00; Number of Contacts:6; Connector Shell Size:10; Connecting Termination:Solder; Circular Shell Style:Wall Mount Receptacle |
| PF48F0P0ZTQ0 | Circular Connector; Body Material:Aluminum; Series:PT00; No. of Contacts:6; Connector Shell Size:10; Connecting Termination:Solder; Circular Shell Style:Wall Mount Receptacle; Circular Contact Gender:Socket; Insert Arrangement:10-98 |
| PF48F2P0ZTQ0 | Circular Connector; MIL SPEC:MIL-C-26482, Series I, Solder; Body Material:Aluminum; Series:PT00; No. of Contacts:10; Connector Shell Size:12; Connecting Termination:Solder; Circular Shell Style:Wall Mount Receptacle |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PF48F4400P0VBQ0A | 功能描述:IC FLASH 512MBIT 85NS 88TPBGA RoHS:是 类别:集成电路 (IC) >> 存储器 系列:StrataFlash™ 产品变化通告:Product Discontinuation 26/Apr/2010 标准包装:136 系列:- 格式 - 存储器:RAM 存储器类型:SRAM - 同步，DDR II 存储容量:18M（1M x 18） 速度:200MHz 接口:并联 电源电压:1.7 V ~ 1.9 V 工作温度:0°C ~ 70°C 封装/外壳:165-TBGA 供应商设备封装:165-CABGA（13x15） 包装:托盘 其它名称:71P71804S200BQ |
| PF48F4400P0VBQ2E | 制造商:Micron Technology Inc 功能描述:32MX16 NOR FLASH PLASTIC PBF TFBGA 1.8V - Trays 制造商:Micron Technology Inc 功能描述:IC FLASH 512MBIT 85NS TFBGA |
| PF48F4400P0VBQ2F | 制造商:Micron Technology Inc 功能描述:32MX16 NOR FLASH PLASTIC PBF TFBGA 1.8V - Tape and Reel |
| PF48F4400P0VBQE0 | 功能描述:IC FLASH 512MBIT 100NS 88SCSP RoHS:是 类别:集成电路 (IC) >> 存储器 系列:Axcell™ 标准包装:576 系列:- 格式 - 存储器:闪存 存储器类型:闪存 - NAND 存储容量:512M（64M x 8） 速度:- 接口:并联 电源电压:2.7 V ~ 3.6 V 工作温度:-40°C ~ 85°C 封装/外壳:48-TFSOP（0.724"，18.40mm 宽） 供应商设备封装:48-TSOP 包装:托盘 其它名称:497-5040 |
| PF48F4400P0VBQE3 | 功能描述:IC FLASH 512MBIT 100NS 88SCSP RoHS:是 类别:集成电路 (IC) >> 存储器 系列:Axcell™ 标准包装:576 系列:- 格式 - 存储器:闪存 存储器类型:闪存 - NAND 存储容量:512M（64M x 8） 速度:- 接口:并联 电源电压:2.7 V ~ 3.6 V 工作温度:-40°C ~ 85°C 封装/外壳:48-TFSOP（0.724"，18.40mm 宽） 供应商设备封装:48-TSOP 包装:托盘 其它名称:497-5040 |
发布紧急采购，3分钟左右您将得到回复。