- 您现在的位置：买卖IC网 > PDF目录9582 > SI5315B-C-GMR (Silicon Laboratories Inc)IC CLOCK MULT 8KHZ-125MHZ 36QFN PDF资料下载
参数资料
| 型号： | SI5315B-C-GMR |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 24/54页 |
| 文件大小： | 0K |
| 描述： | IC CLOCK MULT 8KHZ-125MHZ 36QFN |
| 应用说明： | SI5315/17 Crystal Selection AppNote |
| 标准包装： | 250 |
| 系列： | DSPLL® |
| 类型： | 时钟/频率倍增器，抖动衰减器，多路复用器 |
| PLL： | 无 |
| 主要目的： | 以太网，SONET/SDH/PDH，电信 |
| 输入： | CML，CMOS，LVDS，LVPECL |
| 输出： | CML，CMOS，LVDS，LVPECL |
| 电路数： | 1 |
| 比率 - 输入:输出： | 2:2 |
| 差分 - 输入:输出： | 是/是 |
| 频率 - 最大： | 125MHz |
| 电源电压： | 1.71 V ~ 3.63 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 36-VFQFN 裸露焊盘 |
| 供应商设备封装： | 36-QFN（6x6） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页当前第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页
Si5315
30
Rev. 1.0
5.2.5. Hitless Switching with Phase Build-Out
Silicon Laboratories switching technology performs "phase build-out" to minimize the propagation of phase
transients to the clock outputs during input clock switching. All switching between input clocks occurs within the
input multiplexor and phase detector circuitry. The phase detector circuitry continually monitors the phase
difference between each input clock and the DSPLL output clock, fOSC. The phase detector circuitry can lock to a
clock signal at a specified phase offset relative to fOSC so that the phase offset is maintained by the PLL circuitry.
At the time a clock switch occurs, the phase detector circuitry knows both the input-to-output phase relationship for
the original input clock and for the new input clock. The phase detector circuitry locks to the new input clock at the
new clock's phase offset so that the phase of the output clock is not disturbed. The phase difference between the
two input clocks is absorbed in the phase detector's offset value, rather than being propagated to the clock output.
The switching technology virtually eliminates the output clock phase transients traditionally associated with clock
rearrangement (input clock switching). The Maximum Time Interval Error (MTIE) and maximum slope for clock
output phase transients during clock switching are given in (Table 3, “AC Characteristics”). These values fall
significantly below the limits specified in the ITU-T G.8262, Telcordia GR-1244-CORE, and GR-253-CORE
requirements.
5.3. Input Clock Control
This section describes the clock selection capabilities (manual input selection, automatic input selection, hitless
switching, and revertive switching). When switching between two clocks, LOL may temporarily go high if the two
clocks differ in frequency by more than 100 ppm.
5.3.1. Manual Clock Selection
Manual control of input clock selection is chosen via the CS_CA pin according to Table 11 and Table 12.
5.3.2. Automatic Clock Selection
The AUTOSEL input pin sets the input clock selection mode as shown in Table 11. Automatic switching is either
revertive or non-revertive. Setting AUTOSEL to M or H, changes the CS_CA pin to an output pin that indicates the
state of the automatic clock selection.
Table 11. Automatic/Manual Clock Selection
AUTOSEL
Clock Selection Mode
L
Manual
M
Automatic non-revertive
H
Automatic revertive
Table 12. Manual Input Clock Selection, AUTOSEL = L
CS_CA
Si5315
AUTOSEL = L
0CKIN1
1CKIN2
Table 13. Clock Active Indicators, AUTOSEL = M or H
CS_CA
Active Clock
0CKIN1
1CKIN2
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B5N-IU | CONVERTER MOD DC/DC 18.5V 200W |
| VI-2NZ-MY-S | CONVERTER MOD DC/DC 2V 20W |
| VE-B5M-IU | CONVERTER MOD DC/DC 10V 200W |
| VI-2NZ-MX-S | CONVERTER MOD DC/DC 2V 30W |
| MC1489AMG | IC LINE RECEIVER QUAD 14-SOEIAJ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI5315-C | 制造商:AUK 制造商全称:AUK corp 功能描述:IRED |
| SI5315-C(B) | 制造商:AUK 制造商全称:AUK corp 功能描述:IRED |
| SI5315-C_1 | 制造商:AUK 制造商全称:AUK corp 功能描述:IRED |
| SI5315-CB | 制造商:AUK 制造商全称:AUK corp 功能描述:IRED |
| SI5315-DS | 制造商:AUK 制造商全称:AUK corp 功能描述:High Speed IRED |
发布紧急采购，3分钟左右您将得到回复。