- 您现在的位置：买卖IC网 > PDF目录297500 > TLV320AIC22PTR (Texas Instruments, Inc.) DUAL VOIP CODEC PDF资料下载
参数资料
| 型号： | TLV320AIC22PTR |
| 厂商： | Texas Instruments, Inc. |
| 元件分类： | Codec |
| 英文描述： | DUAL VOIP CODEC |
| 中文描述： | 双VoIP编解码器 |
| 文件页数： | 11/55页 |
| 文件大小： | 763K |
| 代理商： | TLV320AIC22PTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页
TLV320AIC22
DUAL VOIP CODEC
SLAS281B – JULY 2000 – REVISED JUNE 2002
19
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
power down and reset (continued)
There are two ways to reset the TLV320AIC22:
D By pulling the RESET pin low, or
D By writing to the software reset bits in control registers 2 and/or 7 to reset either codec
Asserting the RESET pin low puts the device into a default state with default register settings. After deasserting
the RESET pin, the user should wait a minimum of 10
s before sending control or conversion data to the device.
The default register settings are described in the sections titled suggested configuration sequence and register
map. After a software reset has been removed, control and conversion data can be sent in the next frame.
Asserting a software reset by programming register 2 puts register 1, 2, 3, 4, 5, and 15 in their default settings
and resets codec 1.
Asserting a software reset by programming register 7 puts register 6–14, 16, and 17 in their default settings and
resets codec 2.
microphone bias
To operate Electret microphones properly, a bias voltage and current are provided. Typically, the current drawn
by the microphone is on the order of 100
A to 800 A and the bias voltage is specified across the microphone
at 2.5 V. The bias has good power-supply noise rejection in the audio band, can source 4-mA max current, and
can be shared between all the microphones.
microphone amplifiers
There are three microphone preamplifiers, one each for the handset, headset, and speakerphone microphones.
The input signals for the handset and headset amps typically are less than 20 mVrms, 100 mV max. The input
signals for the speakerphone amp typically are less than 2 mVrms, 20 mV max. The amplifiers have a differential
input to minimize noise and EMC immunity problems. Three values for the gain for the handset and headset
microphones and four values for the gain for the speakerphone microphone are selectable via the I2C or serial
interface to cater to the requirements in Europe and North America. The frequency response is flat, up to 8 kHz.
Table 3. Gain Settings
INPUT
GAIN SETTINGS
Handset microphone preamp (HSINP,M)
0 dB, 14 dB, 23 dB, or mute
Headset microphone preamp (HDINP,M)
0 dB, 14 dB, 23 dB, or mute
Speakerphone microphone preamp (MCINP,M)
0 dB, 20 dB, 32 dB, 42 dB, or mute
By default, the echo gain for the handset and headset are 14 dB. Therefore, a connection exists between the
handset and headset inputs (microphones) and their respective outputs (speakers) in order to implement
sidetone.
driver amplifiers
There are two driver amplifiers that are meant to drive a 150-
handset or headset speakers, differentially. The
drive amplifier is differential, to minimize noise and EMC immunity problems. The frequency response is flat,
up to 8 kHz.
speakerphone amplifiers
The speakerphone speaker impedance is 8
. The drivers are capable of providing a 5-V peak-to-peak
differential signal, which means that the peak power is about 390 mW. The differential drive amplifier achieves
this and minimizes noise and EMC immunity problems. The frequency response is flat, up to 8 kHz.
相关PDF资料 |
PDF描述 |
|---|---|
| TLV320AIC26IRHBG4 | LOW POWER STEREO AUDIO CODEC WITH HEADPHONE/SPEAKER AMPLIFIER AND 12-BIT BATTERY / TEMPERATURE / AUXILIARY ADC |
| TLV320AIC26IRHBR | LOW POWER STEREO AUDIO CODEC WITH HEADPHONE/SPEAKER AMPLIFIER AND 12-BIT BATTERY / TEMPERATURE / AUXILIARY ADC |
| TLV320AIC26IRHB | LOW POWER STEREO AUDIO CODEC WITH HEADPHONE/SPEAKER AMPLIFIER AND 12-BIT BATTERY / TEMPERATURE / AUXILIARY ADC |
| TLV320AIC29_07 | STWREO AUDIO CODEC WITH INTERGRATED HEADPHONE AND SPEAKER AMPLIFIERS |
| TLW-102-06-G-D-01 | 4 CONTACT(S), MALE, STRAIGHT TWO PART BOARD CONNECTOR, SOLDER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| TLV320AIC23 | 制造商:TI 制造商全称:Texas Instruments 功能描述:STereo Audio CODEC, 8- to 96kHz, With Integrated Headphone Amplifier |
| TLV320AIC23_06 | 制造商:TI 制造商全称:Texas Instruments 功能描述:Stereo Audio CODEC, 8-to 96-kHz, With Integrated Headphone Amplifier |
| TLV320AIC23B | 制造商:TI 制造商全称:Texas Instruments 功能描述:Stereo Audio CODEC, 8-to 96-kHz, With Integrated Headphone Amplifier |
| TLV320AIC23B_06 | 制造商:TI 制造商全称:Texas Instruments 功能描述:Stereo Audio CODEC, 8-to 96-kHz, With Integrated Headphone Amplifier |
| TLV320AIC23BGQE | 功能描述:接口—CODEC Lo-Pwr Highly Integrated Codec RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。