参数资料
型号: TS-MAC-E2-U4
厂商: Lattice Semiconductor Corporation
文件页数: 18/66页
文件大小: 0K
描述: IP CORE ETH MAC TRI-SPEED EC/ECP
标准包装: 1
系列: *
其它名称: TSMACE2U4
Lattice Semiconductor
Table 2-1. TSMAC IP Core Input and Output Signals
Functional Description
Port Name
Type
Active State
Description
Receive Statistics Vector . This bus indicates the events encountered
during frame reception. This bus is qualified by the rx_stat_en signal.
The definition of each signal is explained in the Receive MAC section of
this user’s guide.
The corresponding bit locations of this bus are defined as follows:
rx_statvec[15:0] - Frame Byte Count
rx_statvec[16] - VLAN Tag Detected
rx_statvec[17] - Pause Frame
rx_statvec[18] - Control Frame
tx_statvec[19] - Unsupported Opcode
rx_stat_vector[31:0]
Output
N/A
rx_statvec[20] - Dribble Nibble
rx_statvec[21] - Broadcast Address
rx_statvec[22] - Multicast Address
rx_statvec[23] - Receive OK
rx_statvec[24] - Length Check Error
rx_statvec[25] - CRC Error
rx_statvec[26] - Packet Ignored
rx_statvec[27] - Carrier Event Previously Seen
rx_statvec[28] – Unused
rx_statvec[29] - IPG Violation
rx_statvec[30] - Short Frame
rx_statvec[31] - Long Frame
rx_stat_en
Output
High
Receive Statistics Vector Enable . When asserted, this signal indicates
that the contents of the rx_stat_vector bus is valid.
Ignore Next Packet . This signal is asserted by the host to prevent a
ignore_next_pkt
Input
High
Receive FIFO Full condition. The Receive MAC continues dropping
packets as long as this signal is asserted. This is an asynchronous sig-
nal.
rx_eof
Output
High
End Of Frame . Indicates all the data for the current packet has passed
on to the FIFO.
Receive Packet Error . When asserted, this signal indicates the packet
contains error(s). This signal is qualified with the rx_eof signal.
The rx_error signal will be asserted for any of the following three condi-
rx_error
Output
High
tions:
? The rxer signal on the GMII is asserted by the PHY during frame recep-
tion.
? There are Rx FCS errors on received frames.
? There is a length check error on the received frame.
Receive FIFO Error . This signal is asserted when the external Rx FIFO
is full (rx_fifo_full signal asserted) and the Rx FIFO is being written to by
the Rx MAC (rx_write is asserted). When this error signal is asserted the
rx_fifo_error
Output
High
rx_write signal will be de-asserted as long as the rx_fifo_error signal is
asserted. The rx_fifo_error signal will be de-asserted when the end of
packet (rx_eof) exits the receive FIFO (Note: for this errored condition
data will continue to be pulled out of the receive FIFO, even while the
rx_write signal has been de-asserted).
1. Classic TSMAC IP core option.
2. Gigabit MAC or SGMII Easy Connect MAC options.
IPUG51_03.0, December 2010
18
Tri-Speed Ethernet MAC User’s Guide
相关PDF资料
PDF描述
IMC1210ER6R8K INDUCTOR WW 6.8UH 10% 1210
IMC1210ER5R6K INDUCTOR WW 5.6UH 10% 1210
IMC1210ER4R7K INDUCTOR WW 4.7UH 10% 1210
IMC1210ER3R9K INDUCTOR WW 3.9UH 10% 1210
IMC1210ER3R3K INDUCTOR WW 3.3UH 10% 1210
相关代理商/技术参数
参数描述
TS-MAC-E2-UT4 功能描述:开发软件 ETHERNET MAC TRI-SPEED RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
TS-MAC-E3-U3 功能描述:开发软件 Tri-Speed ethernet MAC RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
TS-MAC-E3-U4 功能描述:开发软件 ETHERNET MAC TRI-SPEED RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
TS-MAC-E3-UT4 功能描述:开发软件 ETHERNET MAC TRI-SPEED RoHS:否 制造商:Atollic Inc. 产品:Compilers/Debuggers 用于:ARM7, ARM9, Cortex-A, Cortex-M, Cortex-R Processors
TSMACP2U2 功能描述:以太网模块 TriSpd Ethernet MAC RoHS:否 制造商:Lantronix 产品:Device Servers 数据速率:300 bps to 921.6 kbps, 10 Mbps, 100 Mbps 接口类型:Ethernet, Serial 工作电源电压:5 V to 15 V 工作电源电流:133 mA to 400 mA 最大工作温度:+ 70 C