- 您现在的位置：买卖IC网 > PDF目录140377 > W3H128M72E-667SBM (MICROSEMI CORP-PMG MICROELECTRONICS) 128M X 72 DDR DRAM, 1.25 ns, PBGA208 PDF资料下载
参数资料
| 型号： | W3H128M72E-667SBM |
| 厂商： | MICROSEMI CORP-PMG MICROELECTRONICS |
| 元件分类： | DRAM |
| 英文描述： | 128M X 72 DDR DRAM, 1.25 ns, PBGA208 |
| 封装： | 16 X 22 MM, 1 MM PITCH, PLASTIC, BGA-208 |
| 文件页数： | 7/32页 |
| 文件大小： | 988K |
| 代理商： | W3H128M72E-667SBM |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
W3H128M72E-XSBX
15
White Electronic Designs Corporation (602) 437-1520 www.whiteedc.com
White Electronic Designs
September 2009
Rev. 6
White Electronic Designs Corp. reserves the right to change products or specications without notice.
EXTENDED MODE REGISTER 2
The extended mode register 2 (EMR2) controls functions
beyond those controlled by the mode register. Currently
all bits in EMR2 are reserved, as shown in Figure 8. The
EMR2 is programmed via the LM command and will
retain the stored information until it is programmed again
or the device loses power. Reprogramming the EMR will
not alter the contents of the memory array, provided it is
performed correctly.
Bit E7 (A7) must be programmed as"1" to provide a faster
refresh rate on devices if the TCASE exceeds 85°C
EMR2 must be loaded when all banks are idle and no
bursts are in progress, and the controller must wait the
specied time tMRD before initiating any subsequent
operation. Violating either of these requirements could
result in unspecied operation.
EXTENDED MODE REGISTER 3
The extended mode register 3 (EMR3) controls functions
beyond those controlled by the mode register. Currently,
all bits in EMR3 are reserved, as shown in Figure 9.
The EMR3 is programmed via the LM command and will
retain the stored information until it is programmed again
or the device loses power. Reprogramming the EMR will
not alter the contents of the memory array, provided it is
performed correctly.
EMR3 must be loaded when all banks are idle and no
bursts are in progress, and the controller must wait the
specified time tMRD before initiating any subsequent
operation. Violating either of these requirements could
result in unspecied operation.
COMMAND TRUTH TABLES
The following tables provide a quick reference of DDR2
SDRAM available commands, including CKE power-down
modes, and bank-to-bank commands.
FIGURE 9 – EXTENDED MODE REGISTER 3 (EMR3) DEFINITION
0
1
0
1
Mode Register Definition
M16
M17
0
0
1
M15
0
0
Mode register (MR)
Extended mode register (EMR)
Extended mode register (EMR2)
Extended mode register (EMR3)
DLL
Posted CAS#
out
A9
A7 A6 A5 A4 A3
A8
A2
A1 A0
Extended Mode
Register (Ex)
Address Bus
97
6
5
4
3
82
1
0
A10
A12
A11
BA0
BA1
10
11
12
13
0
14
15
OCD Program
A13
A14
ODS
RTT
DQS#
RDQS
EMR3
RTT
BA2
16
17
Note: 1. E14 (A14)-E0 (A0) are reserved for future use and must be programmed to
"0." A14 is not used in this device.
相关PDF资料 |
PDF描述 |
|---|---|
| WF128K32N-150HC5A | 512K X 8 FLASH 5V PROM MODULE, 150 ns, CPGA66 |
| WS128K32NV-25H1M | 128K X 32 MULTI DEVICE SRAM MODULE, 25 ns, CPGA66 |
| WE128K32-200G4Q | 128K X 32 EEPROM 5V MODULE, 200 ns, CQMA68 |
| WE128K32-250G4M | 128K X 32 EEPROM 5V MODULE, 250 ns, CQMA68 |
| WF512K32F-70H1C5 | 512K X 32 FLASH 5V PROM MODULE, 70 ns, CPGA66 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| W3H13C1048AT | 制造商:AVX 制造商全称:AVX Corporation 功能描述:High Current Feedthry Capacitors |
| W3H13C1048AT1A | 功能描述:馈通电容器 25volt 0.1uF X7R RoHS:否 制造商:Tusonix 电容:8200 pF 容差:- 20 %, + 80 % 电压额定值: 工作温度范围: 温度系数: 封装 / 箱体: |
| W3H13C1048AT1F | 功能描述:馈通电容器 25volt 0.1uF X7R RoHS:否 制造商:Tusonix 电容:8200 pF 容差:- 20 %, + 80 % 电压额定值: 工作温度范围: 温度系数: 封装 / 箱体: |
| W3H15C1038AT | 制造商:AVX 制造商全称:AVX Corporation 功能描述:High Current Feedthry Capacitors |
| W3H15C1038AT1A | 功能描述:馈通电容器 50volt .01uF X7R RoHS:否 制造商:Tusonix 电容:8200 pF 容差:- 20 %, + 80 % 电压额定值: 工作温度范围: 温度系数: 封装 / 箱体: |
发布紧急采购，3分钟左右您将得到回复。