- 您现在的位置：买卖IC网 > Datasheet目录306 > A3944KLPTR-T (Allegro Microsystems Inc)IC PREDRIVER MOSFET 6CH TSSOP Datasheet资料下载
参数资料
| 型号： | A3944KLPTR-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 9/31页 |
| 文件大小： | 0K |
| 描述： | IC PREDRIVER MOSFET 6CH TSSOP |
| 标准包装： | 8,000 |
| 配置： | 低端 |
| 输入类型： | 并行/串行 |
| 延迟时间： | 200ns |
| 电流 - 峰： | 50mA |
| 配置数： | 6 |
| 输出数： | 6 |
| 电源电压： | 6 V ~ 40 V |
| 工作温度： | -40°C ~ 150°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.173"，4.40mm 宽）裸露焊盘 |
| 供应商设备封装： | 28-TSSOP 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
A3944
Automotive, Low Side FET Pre-Driver
Functional Description
The A3944 provides a programmable interface between an ECU
and 6 low-side MOSFET switches in automotive applications.
Each channel provides all the features necessary to drive and
monitor the external FET and load.
The gate of the external FET is driven by a 50 Ω (typ) push-pull
driver capable of sourcing and sinking at least 40 mA under all
conditions. This is sufficient to allow most typically used FETs to
be switched with a PWM input at up to 10 kHz. The state of each
channel is determined by a combination of parallel and serial
inputs.
When the FET is active its drain is monitored for a short to
battery. When the FET is inactive, internal current sources are
activated and the drain voltage is monitored to check for shorts to
ground or open loads.
The serial, SPI compatible interface provides access to control
and configuration registers. Each channel has a dedicated fault
configuration register that allows independent fault thresholds,
fault timing, and fault configuration for each channel.
The output state of each channel is determined by the logic con-
trol input for the channel and a dedicated bit in the single output
control register. Channels can therefore be controlled by parallel
input, by serial input, or by a combination of the two. All chan-
nels can be switched at the same time with a single serial write.
A single fault mask register can be used to ignore the fault detect
output for any channel combination.
The serial interface also provides read back of the fault status for
each channel.
Digital inputs and outputs are compatible with 3.3 V and 5 V
supplies.
Terminal Functions
VDD: Positive supply for digital input, output, and logic.
VBB: Positive supply for voltage regulator. Can be connected to
battery voltage through reverse polarity protection.
VREG: Regulated voltage for analog and reference functions.
VDR: Positive supply for gate drive outputs.
GND: Ground return. Connect to common return point for all
external MOSFET source connections.
RESETN: Active low digital input. When held low for longer
than the minimum reset pulse width: forces outputs low, resets
the configuration, sets the LR bit, and resets all other channel
faults.
SI: Active high digital input with pull-down resistor. Data on SI is
clocked into the serial register on the rising edge of SCK.
SO: Push-pull digital output. Data from the fault register is output
on SO, changing on the falling edge of SCK.
SCK: Digital clock input with pull-down resistor. See SI and SO
for action.
CSN: Active low digital input with pull-up resistor. When CSN
is low SO becomes active and data is accepted on SI. Data is
latched in the serial register when CSN goes high. When CSN is
high SO is high impedance and SI and SCK are ignored.
INx: Active high digital inputs with pull-down resistors. When
INx is high GATx is allowed to go high, depending the contents
of the serial control register and any active faults. When INx is
low GATx is held off.
GATx: Gate drive outputs. Drive between GND and VDR. Con-
nected through a resistor or directly to the gate of the external
MOSFETs.
DRNx: Analog, high-voltage inputs. Drain monitor connection
used to determine the status of the drive to the load.
Gate Drive Channels
Each gate drive channel has independent control logic, gate drive
output, fault detection circuitry, fault threshold generators, fault
timers, and fault configuration register. The fault configuration
register and reference generation provides two short to ground
thresholds and eight short to battery thresholds, plus four turn-on
blank times and four turn-off blank times independently select-
able per channel.
The gate drive channel block diagram (figure 1) shows the func-
tional circuit for one gate drive channel, which is duplicated in
each gate drive channel. A retry timer, common to all channels,
allows automatic retry for short to battery faults.
Control and Enable
A gate drive output, GATx, is turned-on when: RESETN is high,
no short to battery fault is present, and either the direct digital
input, INx, or the relevant bit in the serial control register, Gx, is
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
9
相关PDF资料 |
PDF描述 |
|---|---|
| A3985SLDTR-T | IC MOSFET DRVR PROG DUAL 38TSSOP |
| A4933KJPTR-T | IC PREDRIVER MOSFET 3PH 48LQFP |
| A4935KJPTR-T | IC MOSFET DVR AUTO 3PH 48-LQFP |
| A4940KLPTR-T | IC MOSF DVR FULL BRIDGE 24TSSOP |
| A6210GEUTR-T | IC LED DRIVER HIGH BRIGHT 16-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A3946 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:Half-Bridge Power MOSFET Controller |
| A3946GLPTR-T | 制造商:Allegro MicroSystems LLC 功能描述: |
| A3946KLB | 功能描述:IC CTRLR MOSFET 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器，驱动器 系列:- 标准包装:1 系列:- 应用:直流电机驱动器，步进电机驱动器 评估套件:- 输出数:1 或 2 电流 - 输出:750mA 电压 - 负载:10 V ~ 40 V 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-BFSOP（0.295"，7.50mm 宽） 供应商设备封装:24-SOP 包装:Digi-Reel® 其它名称:MTS62C19A-HS105DKR |
| A3946KLB-T | 功能描述:IC MOSFET CONTROLLER 16-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器，驱动器 系列:- 标准包装:1 系列:- 应用:直流电机驱动器，步进电机驱动器 评估套件:- 输出数:1 或 2 电流 - 输出:750mA 电压 - 负载:10 V ~ 40 V 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-BFSOP（0.295"，7.50mm 宽） 供应商设备封装:24-SOP 包装:Digi-Reel® 其它名称:MTS62C19A-HS105DKR |
| A3946KLBTR | 功能描述:IC CTRLR MOSFET 16-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 电机和风扇控制器，驱动器 系列:- 标准包装:1 系列:- 应用:直流电机驱动器，步进电机驱动器 评估套件:- 输出数:1 或 2 电流 - 输出:750mA 电压 - 负载:10 V ~ 40 V 电源电压:4.5 V ~ 5.5 V 工作温度:-20°C ~ 70°C 安装类型:表面贴装 封装/外壳:24-BFSOP（0.295"，7.50mm 宽） 供应商设备封装:24-SOP 包装:Digi-Reel® 其它名称:MTS62C19A-HS105DKR |
发布紧急采购，3分钟左右您将得到回复。