- 您现在的位置：买卖IC网 > Datasheet目录322 > DS28E04S-100+T (Maxim Integrated Products)IC EEPROM 4KBIT 16SOIC Datasheet资料下载
参数资料
| 型号： | DS28E04S-100+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 22/37页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 4KBIT 16SOIC |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 4K (256 x 16) |
| 接口： | 1 线 串行 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
DS28E04-100: 4096-Bit 1-Wire Addressable EEPROM with PIO
Figure 12. PIO Access Pulse Timing Diagram
MS 2 bits of inverted
Selection Mask
LS 2 bits of confir-
mation byte (AAh)
IO
V TH
PIO
t REH +x
POL=1
POL=0
t PULSE
RESET ACTIVITY LATCHES [C3h]
Each PIO channel includes an activity latch that is set whenever there is a state transition at a PIO pin of duration
greater than t PWMIN . This change can be caused by an external event/signal or by writing to the PIO or by
generating a pulse. Depending on the application there may be a need to reset the activity latch after having
captured and serviced an external event. Since there is only read access to the PIO Activity Latch State Register,
the DS28E04-100 supports a special command to reset these latches. After having received the command code,
the device resets all activity latches simultaneously. There are two ways for the master to verify the execution of
the Reset Activity Latches command. One way is to start reading from the 1-Wire line right after the command code
is transmitted. In this case, the master reads AAh bytes until it sends a 1-Wire reset. The other way is reading
register address 0222h.
1-Wire BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the DS28E04-
100 is a slave device. The bus master is typically a microcontroller. The discussion of this bus system is broken
down into three topics: hardware configuration, transaction sequence, and 1-Wire signaling (signal types and
timing). The 1-Wire protocol defines bus transactions in terms of the bus state during specific time slots, which are
initiated on the falling edge of sync pulses from the bus master.
HARDWARE CONFIGURATION
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to drive it at
the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open-drain or tri-state
outputs. The 1-Wire port of the DS28E04-100 is open drain with an internal circuit equivalent to that shown in
Figure 13.
A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The DS28E04-100 supports both a
standard and Overdrive communication speed of 15.4kbps (max) and 111kbps (max), respectively. Note that
legacy 1-Wire products support a standard communication speed of 16.3kbps and Overdrive of 142kbps. The
slightly reduced rates for the DS28E04-100 are a result of additional recovery times, which in turn were driven by a
1-Wire physical interface enhancement to improve noise immunity. The value of the pullup resistor primarily
depends on the network size and load conditions. The DS28E04-100 requires a pullup resistor of 2.2k ? (max) at
any speed.
The idle state for the 1-Wire bus is high. If, for any reason, a transaction needs to be suspended, the bus MUST be
left in the idle state if the transaction is to resume. If this does not occur and the bus is left low for more than 16μs
(Overdrive speed) or more than 120μs (standard speed), one or more devices on the bus can be reset.
22 of 37
相关PDF资料 |
PDF描述 |
|---|---|
| DS28EC20+T | IC EEPROM 20KBIT TO92-3 |
| DS301X | KWIK-CHG DESIGNATION STRIP SGL |
| DS3030W-100# | IC NVSRAM 256KBIT 100NS 256BGA |
| DS3045W-100# | IC NVSRAM 1MBIT 100NS 256BGA |
| DS3050W-100# | IC NVSRAM 4MBIT 100NS 256BGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS28E04S-224-BB+T | 制造商:Maxim Integrated Products 功能描述:- Tape and Reel |
| DS28E05P+ | 功能描述:电可擦除可编程只读存储器 1W 1KB FTP MEMORY TSOC RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| DS28E05P+T | 功能描述:电可擦除可编程只读存储器 1W 1KB FTP MEMORY TSOC RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| DS28E05R+T | 功能描述:电可擦除可编程只读存储器 1-Wire 112-BYTE 电可擦除可编程只读存储器 RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| DS28E10 | 制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:1-Wire SHA-1 Authenticator Irreversible Write Protection |
发布紧急采购，3分钟左右您将得到回复。